0
Toyota Sequoia
The Sequoia is a full-size sport utility vehicle (SUV) manufactured by Toyota Motor Corporation from 2000 to the present. This model is sold exclusively in the Middle East, the US, Puerto Rico, Mexico, Chile and Canada.
1,008 Questions
How do you know if you have a timing belt or timing chain on a 1998 Toyota tacoma prerunner?
2.7 has chain, 3.4 (6cyl.) has belt
How do you remove the center console on a 1998 Montero?
The center console is held in place by 4 screws...2 screws inside the arm rest storage area and 2 screws on the change tray below the hand break lever. Be sure to pull up the hand break lever to lift the center console off...Good Luck
How do you replace alternator 2001 sequoia?
To replace the alternator on a 2001 Toyota Sequoia, first disconnect the negative battery cable to ensure safety. Remove the serpentine belt by loosening the tensioner, then unbolt the alternator from its mount. Disconnect the electrical connectors and positive battery cable from the alternator, and then install the new alternator by reversing these steps. Finally, reattach the serpentine belt and reconnect the battery.
How do you open your trunk from inside the trunk?
I would be calling for help, not asking how to get out in the Internet!
1994 Mazda B2300 ABS light will not go off how do I troubleshoot this?
Did you try disconnecting the positive battery terminal for a minute then reconnecting it? Soemtimes this will reset the computer and the light will go out.
This is a little tricky if you don't know how to do it. The crank is actually on piece of plastic molded. It is held onto the shaft by a keeper that snaps onto the back part of the handle. It is a little trick to get off with standard tools but a flat head screw driver usually work.
Push the plastic door panel back away from the crank you should be able to see the keeper snapped over the plastic part of the crank that goes onto the shaft. The keeper is sort of a circular spring with an opening. Find and flat head screw driver that will part the opening in the spring far enough to slide it off. The crank handle pulls straight off.
Does a 2003 Honda cr-v 4cyl have a timing chain or a timing belt?
The 2003-05 Accord 4cyl has a timing chain. The 2003-05 V6 has a timing belt.
I own a 2002 CR-V, 4 cyl. It has a timing chain. The '03 is out of the same series so I would assume it also has a chain. But, to be sure, call a dealer's service department and ask them. They'll know right away.
How do you replace the rear liftgate handle on a 2002 Toyota Sequoia?
12/2/08
Toyota Sequoia rear hatch latch assembly replacement. 2001-2006 models
I recently found it necessary to replace the rear hatchdoor latch assembly. It had broken and there was no way to open the rear hatch from the inside or outside.
The 2001 Sequoia sold in 2000 had 89,000 miles and was maintained well. It looks like this plastic part that failed is just a weak design and most or all will fail at some point.
1. You can open the rear hatch from the outside if you can get the small piece of the broken lever out of the square hole that is on the right side of the handle grip area. You will need to use a strong piece of wire or a screwdriver type tool with a slight bend on the end. The lever that pulls on the cable that opens the latch is located above the opening in the handle grip area, accessed through the small square hole. Insert the tool that you made and fish around to find the cable lever; you will need to have the tool pointed up to find the lever. Once you find the lever pull down to pull the lever. Note: make sure that the hatch is unlocked or it won't open.
2. If you can't locate the lever or can't make it open from the outside you will need to do it from the inside of the vehicle. This isn't fun but it can be accomplished with a little sweat and a few choice words thrown in.
3. You can work from the outside of the truck at this point, roll the rear glass down to give you access. The plastic trim pieces on each side of the rear glass can de popped off by hand, they each have three plastic barbs that hold them on. Remove them carefully and pull straight out to remove them, this will give you access to the large rear piece of plastic trim that covers the inside of the rear door.
4. Remove the vinyl pull-strap that is located on the rear panel, use a #2 Philips to do this. Now start to remove the large inside door panel. This panel has the rear glass inside rubber anti-rattle blade attached to the top of it. (If you were able to open the hatch door from the outside you can remove the inside panel by starting at the bottom of the panel and using a thin blade to lift the panel away from the door and then pop the plastic barbs loose, then lift it up and off of the door sheet-metal.) Starting at one corner, bend out and pull up on the panel where it is hooked over the top of the window opening sheet-metal. It takes a little force to get it started but be persistent, once it is started work towards the other end. Once it's loose at the top you can reach inside and pop loose the plastic barbs that retain the panel and remove it completely.
5. You now have access to the inside of the hatch. Remove the three round rubber grommets, this give you access to the latch lever that pulls on the release cable. Reach inside with a screwdriver push down on the lever and you will be able to release the latch on the hatch door and open it.
6. There is a white plastic cover covering the cable attachment point, remove it by pulling down and away from the assembly, it clips onto the assembly bracket and helps secure the cable to the lever attachment point. You can now release the cable from the assembly, remove the screws holding the license plate recess cover and the nut holding the key cylinder assembly and then remove the cable assembly bracket, (two nuts). Now you can remove the license plate recess panel and the broken latch lever assembly that is attached to it as a unit.
7. You can't just purchase the ($2.00) plastic piece that broke, Toyota will make you purchase the entire assembly, $63.00. By the way I shopped around and got three different estimates from Toyota Dealers, ranging from $280 to $360 to do this job. This first repair took me seven hours because I didn't know what I was doing, I spent 3 hours just attempting to open the hatch, I could do it now in about two hours.
What is the rear head room of the 2006 Toyota Sequoia?
The 2006 Toyota Sequoia has 40.6 in. of rear head room.
What size door speaker does a 2003 Toyota sequoia have?
mine has 6 1/2 but they need adapters for new speakers....
Where is the oil level sensor sender found on your 2001 E320 and how is it replaced?
It seems to be a black instrument stuck on the upper side of the oil pan directly above the drain plug.
How do you replace a rear tail light bulb on a 2004 toyota sequoia?
2004 Toyota Sequoia tail light bulb replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How much is a rear window motor in a 2004 sequoia?
It's probably not the motor but dirt on the window and inside. Push firmly against the bottom of the window several times after cleaning it and then try to open it. It make take 5 or 10 tries. If that doesn't work you can take the panel off the door and tap on the motor with a tool to loosen up any dirt. Once you get it to open again, make sure you open it ever couple of weeks to keep it moving. Don't let Toyota tell you that it's the motor before you try this fix.
How do you replace the front turn signal lamp in a 2001 Toyota sequoia?
2001 Toyota Sequoia turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Problem with the ABS.
How do you replace the cabin filter on a Toyota Corolla?
Here is a link to a page with installation instructions. We sell these filters for $9.95/each on eBay. You can find our current listing by pasting 220198445075 in eBay's search box or visit our eBay store, ToddandNaomi.
Hope this helps.
ToddandNaomi
I need instructions for replacing a starter on a 1993 cadillac fleetwood broham.
2002 sequoia. can the home link panel blubs be replaced?
Yes they can. That whole assembly comes down by removing two screws. You can get the bulbs at the dealer or you can order very similar ones that work from Mouser Electronics. mouser.com Search tundrasolutions.com for answers. Toyota part # BULB, W/CAP 90011-11038 Mouser part #560-DNW1DW10 Good Luck
What is the curb weight of the 2007 Toyota Sequoia?
The curb weight of the 2007 Toyota Sequoia is 5100 lbs..
How you change the oil filter on a Toyota sequoia 2008 5.7?
I think you may want to read the following before you try to drain the oil on your 2008 Sequoia if you have a 5.7L engine: I've answered this question several times: I own a 2008 Tundra 5.7L and I believe it's the same drive train for both vehicles.
-----------------------------Heres my answer to the question---------------Where do you get the oil filter wrench for the 5.7 L Toyota Tundra?----------------------
I had a conversation with the parts man at my Toyota dealer today I asked the same question. I also own a 2008 5.7 Tundra.
First of all, if you found the oil filter you know how hard it is to get to. (Drop the skid plate.) Then you discovered that there was no ordinary oil filter like you've ever seen before. And finally you got to the paper filter after removing the oil cover plate. (Yea! I'm not kidding.)
Well the parts man told me that you can't just purchase the tool to remove the filter it's a special tool that you can only get through MAC tools. You know the guys that drive the big white tool trucks, and it's expensive. NO ONE ELSE SELLS THE TOOL! NO ONE!
So I've decided to let Toyota do the oil changes. $80 and they rotate the tires too.
I'll bet you can't find the transmission dip stick either. Because there is NONE. Something else new to confuse you. They told me that the 5.7 tranny is designed to go 100,000 miles before an oil change in the tranny. The tranny must be brought up to a special temp and a special tool has to be used to check it and fill it. (Frustrating isn't it.) Something else that I decided to let Toyota do. I'll bet you looked in the owners manual to find out where the oil filter and tranny dipstick were, and could not really find anything. (Right) I also looked.
If you look in the manual to find how to change the "CABIN filter" (Bet you didn't know there was one) you won't really find anything either. It's easy, it behind the lower glove box in the Tundra. Open the Box, Remove the brace on the right side. Squeeze the sides of the box inward a little and pull it out. You will see a trap door. Open it and pull out the cabin air filter and replace it. Instructions come with it when you buy a new one at any auto store. (Cost about $25) Toyota charges $58 to do this same thing.
I've resigned myself to checking the air in the tires. Oh wait, the 2008 also does that automatically. The tire reset button is under the dash by your right knee. (Sigh!)
How do you remove a stereo from a 2001 Sequoia?
1. Tilt the two center vents up and remove the screw at the top of each opening.
2. Remove the climate controls round knobs by pulling them straight out.
3. Gently start prying the center trim away from the structure behind it. It helps it you start around the climate control section, there are about 6 clips total that are holding git in place. Use a plastic putty knife or something similar - don't get aggressive.
4. Pull the trim facade off.
5. Remove the 4 bolts for the stereo - 1 in each corner.
How do you change the antenna on the 2003 Montana?
You can't unless you wan to replace the windhield. The antenna is built into the windshield.
Where is the evaporator drain tube located on a Toyota sequoia?
As you face the engine look on the firewall, on the left side, toward the bottom, as a reference you will see the automatic transmission amber/brown colored dip stick head, just past it you will see two polished aluminum tubes, to the right you see a black rubber tube jutting straight out of the "wall" that is it!
I have a picture but can't get it to post?
Chilton Manual has a picture although it isn't very good for a black and right it does help as a reference check in the local library for the manual if you don't wish to buy it !
