0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
How do you service a Chevrolet air conditioner?
Depends on problem--if just a re-charge buy a kit at auto parts or Wal-Mart comes with instructions
What does this warning light on my Ford Fiesta dashboard mean?
There are a number of lights on the Ford Fiesta dashboard, and the owner's manual will have descriptions of all of them. Without more information, that is the only answer possible.
What is the maximum cargo capacity of the 2010 Chevrolet Suburban?
The maximum cargo capacity of the 2010 Chevrolet Suburban is 137.4 cu.ft..
What year is a 350 Chevy engine with casting number 3970010 and v0815tja on front of the block?
you need the date code on the side of the block it will be a series of numbers and letters first its the month, then day, then year
What is the wheelbase for a 1953 Chevy pickup?
what is the wheelbase of a 1953 chevy pickup width and length?
How do you replace front wheel bearing 1992 k1500 Chevrolet?
i may be wrong, but if i recall correctly from high school automotives the wheel bearing has to stay with the wheel it was built for so you have to replace the whole wheel once again though i am not 100% on this
What will the wheels from a 1977 dodge 4x4 half ton pickup fit?
They will bolt right up to a 90's ford ranger and work awesomely.
What makes the engine of a 93 Maxima hesitate?
The EGR (exhaust gas return) valve is defective if you have eliminated the plug/wires, trottle valve etc.
I would have the DMV run the VIN and make sure the car wasn't stolen and isn't currently registered in someone elses name. Then you can apply for a salvage or lost title but I'm sure the DMV will advise to the best of your interest.
How can you hook up an amp to your factory stereo 2007 hhr it has factory amp?
The easiest way is a Line Out Converter. you either splice off the rear speakers or if it was equipped with subwoofer then you can splice into that line. The Line Out Converter just gives you a set of RCAs and then you just hook it all up like normal.
How do you crank up the torsion bars on a 1997 Chevy 2500 pickup?
On the rear of the bars, there is a bolt on each side coming down through the cross member. Tightening these two bolts will lift the front end.
Where is the power steering reservoir in a 1985 Chevy truck?
It is mounted on the rear of the power steering pump . Look in behind the bracket that is covering the pump up and you will see a cap. remove it and add fluid as needed.
What happens if you use reverse polarity battery on car plus keep POS-POS NEG-NEG?
If you operate any electrical device even turning on the ignition, you risk burning out any diodes.
What is the firing order for a 1969 Chevy 396 big block?
1-8-4-3-6-5-7-2 clockwise on distributor cap.
Drivers side head front to rear are cylinders 1-3-5-7
The other head front to rear is 2-4-6-8
Where is the map sensor on a 1994 Chevy pickup 1500?
On the passenger side of the throttle body under the air intake
Where is the blinker switch on a 1992 grand am?
The blinker switch is located inside the steering column housing and is attached to the turn signal lever you move to activate the turn signals. If you are talking about the Flasher Relay, that causes the lights to go on and off, it is located, front seating area, driver side, under dash, mounted above fuse block. There is also a separate relay for the hazard lights. It is located, front seating area, driver side, under dash, above kick panel, mounted in bottom of convenience panel
How many 1978 Monte Carlo with t tops where made?
There are no production numbers for such a configuration, but it was a fairly rare option.
How do you replace a power steering pump on a 1969 Chevy 327 engine?
Remove the belt from your 1969 Chevy power steering pump. Remove the power steering pump hoses. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.
How do you put a torque converter in th350 Chevy?
I assume you have the transmission out of the car. It has to be out to replace the torque converter. The old torque converter will just pull off, but you may have to spin it back and forth a couple of times. When you install the new one, slide it on the shaft and spin it back and forth while pushing it towards the transmission and it will slide back towards the transmission. You have to do this again, because it has two sets of gears that it has to engage. If it doesn,t slide back twice, you will never get the transmission to slide up to the motor correctly. You may get bolts in it, but you will break something trying to tighten the bolts. If the transmission does not slide up to the motor without a lot of force, you do not have the torque converter on all the way. If it does, you should be able to bolt the transmission to the engine fairly easily. Once the transmission is bolted up correctly, you can turn the flywheel to line up the three bolts that hold the torque converter to the flywheel. Make sure you torque the flywheel to converter bolts to the specified torque settings, and they will vary according to the specific transmission, usually around 45 FT LBS.
