Microprocessors

Sensors that contain variable resistors feed information to the processor. Once the right resistance is met due to heat or pressure, the microprocessor turns something on or off like a cooling fan. Sometimes the processor uses two sensors to turn something on or off. Check out logic gates such as NAND gates, AND gates (Input A and Input B turns output on), NOR gates, etc.

the control unit should be built into the right hand fuse box below the steering column.it was in mine anyway...i replaced the fuse box and it sorted out my problem.

In the code, you should see this:

Width:425 Height:500 or what ever.

Change the code into this:

Width:0 Height: 0 and then it will hide your playlist.

This vehicle has multiple CPUs each located inside a Module such as PCM, IPC, BCM, DLM, Radio, Door Latch Module, etc. Please specify what you are talking about.

The transmission control unit is located between the engine oil dipstick and the windshield washer fluid reservoir on the 2002 Dodge Intrepid. The TCM and PCM are one built into one unit on 2002 models.

It will be round with approximately the diameter of a half dollar. Can be metal or plastic. Plugs in with a 3 blade type connector. Is located: UNDERNEATH THE INSTRUMENT PANEL, NEAR THE LEFT HAND COWL SIDE TRIM PANEL.

I want to buy a new computer (desktop) but I am stuck!

I can decide what CPU to choose. Intel or AMD?

Core 2 Duo or i3-i5?

The computer will be for general use but I also want to be able to play a couple of games like Left 4 Dead or Crisis.

Right now I have 500 Euros and I already have a monitor, mouse and keyboard.

What do you suggest

Under the dash and just above the steering column - small cannister shaped flasher units are incorporated into the electrical circuits for the directional flashers and hazard lights.

It really depends completely on how powerful of a processor you have. A low-clocked mobile i7 might have an insufficient clock speed for a particular video game, but it will still shred said game in every manner possible.

In the same sense, a P4 can be 1GHz above the suggest clock speed, and still utterly fail to provide enough compute power to make the game playable.

Newer games rely on your graphics card more than your processor-- This is also important to keep in mind. If the game runs well, the MHz / GHz requirement for the processor is moot.

AVR is usually termed as AVG which stands for the players batting average. HR is the amount of home runs. RBI represents runs batted in. OBP shows a players on base percentage

Try this...... Remove the ignition coil plug, then take a test light and run it between the two terminals of the ignition coil wires. Crank the engine and see if it flashes. If it does and there is no spark, you need a new coil.

well one there is no such thing as a 3 ghz motherboard. Motherboards are the conductors of the information. The CPU does that.

2nd. This depends if your talking about a processor that can do 3 ghz. or One that is factory rated. When you figure that out. Pricewatch.com can give you the lowdown on some pricing.

The ECM and TCCM are located behind the lower dashboard on the passenger side.

Parity bit generator is the error that occures when digital codes are being transferred over channel from one point to other .

This question is literally impossible to answer without knowing a specific part number (and manufacturer which is usually easy to determine because it is based off the part number). The 8051 was first used in the IBM type computer as the keyboard controller to send key presses to the CPU. It has since become an architecture that appears in a number of other places. There are several manufacturers that produce low cost and low power microcontrollers based upon the 8051 with other peripherals included in the same package. Because there are numerous 8051 controllers, there is no one standard for connecting them to power for each may design their controller to meet their own design guidelines.

Older 8051 microcontrollers usually require a 5 V power supply.

Newer 8051 microcontrollers are more likely to require a 3.3 V power supply.

The only way to tell is to read the part number off the chip and look up the manufacturer's data sheets for that part number.

Fortunately, most data sheets are online these days.

A buffer is merely a temporary storage used in conjunction with computation.

They are both computers the difference is that they use different kind of software and cannot be compatible with each other. So you cannot make your car computer play mp3 or something like that.

above the glove box, shouldn't need to remove the dash just the glove box.

The first microprocessor was the Intel 4004.

Not yet.

A45C:

Decimal = 42076

Octal = 122134

microprocessor 8085 is basic 8 bit microprocessor by Intel Corp. it has 64Kb memory and 16 address buses and 8 data buses it has 40 pin ic. 8 address and 8 data buses are multiplexed with each other for reducing the total number of pins from the microprocessor 8085 . it require 5MHz clock frequency for operation. only a crystal which connected easily across two pins of microprocessor can provide this clock.

PLATFORM

They are not.