0
Brake Fluid and Lubrication
Cars, trucks, motorcycles and even bicycles use hydraulic braking. Brake fluid is used to transfer the force applied into hydraulic pressure. In contrast, lubricants enable parts to move opposite each other in a perpendicular manner.
1,926 Questions
What transmission fluid is used in a 1966 Chrysler Newport?
You can use ATF+3 with all older Chrysler transmissions. Do not use ATF+4 Dexron, Mercon, or any other fluid.
Where would brake fluid be leaking from behind the front wheel on a Toyota Camry?
Seal in brake caliper is leaking and needs replacement Flexible brake line to the caliper is leaking and needs replacement
Where is the power stearing fluid on a 2003 buick century?
On the passengers side of the car under the hood. There is a black reservoir near the top of the engine nearly center of the aluminum intake manifold, the cap on the reservoir should be labeled "Power Steering Fluid"
Can you bleed your brakes by pumping them with the master cylinder cover off?
Yes, you leave the cap off and make sure you keep the master cylinder full of fluid at all times. Bleed the brakes starting at the right rear and then moving to the LR, then RF, and ending at the LF.
Emergency brake not adjusted properly? Service brake not adjusted properly? Frozen caliper? Bad or broken brake return springs?
Where is the brake fluid chamber in rover 75?
Looking face on to the engine, there is a plastic cover just below the windscreen on the left. The cover is lifted by pressing two clips in. The brake fluid reservoir can be found here.
This could mean that the light is out on the brake light. It could be a circuit is not connecting properly. Check to make sure all your lights are working properly. If its still on you should have it checked as it might be a electrical problem instead. == Answer ++ It could also mean you have a problem with your master brake cylinder. You should have your brakes checked out before you have trouble stopping.
Where do you add brake fluid on a 2001 Chrysler Town and Country Limited?
Brake fluid is added to the brake master cylinder, under the hood on the driver side, back near the base of the windshield.
How do you check - add and what type of brake fluid on a Ford Windstar?
DOT 3 brake fluid - pretty much a universally specified, and readily available brake fluid.
NOTE: The Owners Manual contains illustrated procedures for checking/filling brake fluid - and the specified fluids for the vehicle.
See "Related Questions" below for a free sources of online Owners Manuals D.O.T. #3
Check the master cylinder to see if it's low.
Answerhttp://autorepair.about.com/library/recalls/bl-recalls-096a.htm
It's a little awkward as it is partially obstructed by the windshield wiper trim piece.
Adding fluid - I usually use a small bathroom dixie cup if you fill it halfway it will fit under there
and you can pour it in
According to the Owners Manual, and the "Related Question" below...
DOT 3
Why is brake fluid leaking from cap?
there is too much in the container If you filled the resevior with brake fluid PRIOR to replacing any of the brake linings, it will cause the fluid to "backflow" into the resevior, thus it will overflow and leak from the cap.
What kind of brake fluid for 2004 Ford Taurus?
The Owner Guide shows Motorcraft High Performance DOT 3 brake fluid
Why is your charade leaking brake fluid from the piston?
Worn seal. Replace the caliber and bleed the brakes.
What type of brake fluid do use for a Ford Explorer 1996?
According to the 1996 Ford Explorer Owner Guide :
( DOT 3 brake fluid ) meeting Ford specification ( ESA-M6C25-A )
Where does brake fluid go in my scenic megane?
Master cylinder reservoir is located on the bulkhead. If you mean where is it going. as the front brake pads wear down the master cylinder level drops slightly. A sudden drop in level indicates a leak somewhere in the system.
How do you clean antifreeze out brake fluid in 1993 Honda accord?
You need to completely flush the system of all contaminated brake fluid. As this is a very serious and possibly dangerous situation I recommend you take this car to a professional and have the system completely flushed and refilled with fresh fluid.
How do you fix a leaky brake line on a 1981 Datsun 4x4 truck?
Unfortunately, there is no "fix" for a leaky brake line other than completely replacing it. Brake lines are under extreme pressure and NOTHING will stop the leak. Attempts at patching a brake line only endanger the occupants in the vehicle when it busts free (and it will)posing a crash hazard. If you have very thick soled shoes, and a very strong left leg, you might try opening the drivers door and dragging your foot. Otherwise, PLEASE have a qualified technician replace that brake line!
Where do you put the brake fluid in on a 2003 Kia Spectra?
while facing the front of car on left side of engine between the left side of the car and the engine{far left] you should see a small box that has some dark oilly looking liquid in it that's it fill to the line on the side of box
How do you add brake fluid to your 1999 Chevy Malibu?
open the cap on the brake mastercylinder reservoir and fill it to the top with Dot 3 brake fluid.
How do you reset brake fluid light on a BMW e46 1999 model?
2. Hold trip meter button (the left button)
3. Ignition key to position 1. The display will show: "test 1"
4. Keep holding the trip meter button until the the display shows: "reset inspection" or "reset oilservice"
5. Release the button
6. Press and release the trip meter buton once. The Display will show the square clock symbol and the month the fluid change is due on
7. Press and hold the trip meter button until the display is showing a flashing "reset". Then release the button. "reset" will keep flashing.
8. Press and release the trip meter button once. The display will show the square clock symbol and the month for the next fluid change
9. Press and hold the trip meter until "End" is displayed
10. Let go of the button and turn ignition key to 0 (off)
Instrutions Courtesy of GoingNuts of e46fanatics.com
How do you stop brakes from squealing?
Brake pad/lining dust can often be the cause of brake squealing when brakes are applied. This is normally remedied by blowing dust out with compressed air.
If your rotors are warped or uneven, this will make a squealing sound. You may need to have your rotors turned or replaced.
I would check two things immediately...brake wear being the first, as most pads are now equipped with "sensors" that contact the spinning rotor to create a reminder squeal. Change the brakes at this point. Second thing would be brake dust as mentioned above, HOWEVER, it is not good practice to blow brake dust with anything. At this point, the rotors must be resurfaced to remove the "glaze" caused by heat and friction to their surfaces. Remember, when resurfacing rotors, or drums, replace all pads and shoes.
Some occasional squealing can be a normal characteristic on many vehicles. Also, if you tend to let the car sit without use for days at a time, learn to live with the squeal. A few drum brake systems (Neon rear drum brakes are of note) have a design that is inherently squeaky.
Disc brakes:
- Check for any of the following conditions:
- Corroded or pitted rotors; glazed rotor surface; grooved rotor surface; incorrect rotor diameter- can all be cured by resurfacing or replacement of rotor in combination with replacement of pads.
- Incorrect pads; hard pads; old pads; pads contaminated with oil or grease; inner and outer pads reversed; left and right pads. Replace pads to correct.
- Bent, out of place, missing, or corroded backing plates, pad shims or rattle clips. Correct as needed.
- Worn or loose wheel bearing.
- Design characteristic. Consider cutting reliefs into pads or coating the back (non-friction) side of pads with grease or spray-on tacky brake silencer.
Drum brakes:
- Poor drum surface. Resurface or replace as needed.
- Cracked shoe linings. Replace.
- Shoes contaminated with grease, brake fluid, or gear oil. Replace.
- Weak return springs or shoe retainers, rusted springs, improper adjustment, lack of lubrication on backing plate at shoe contact points. Correct as needed.
- Inherent to design. Live with it. Also, consider coating the outside of the drum with high temperature enamel type paint. You will need to remove any rust from the drum and clean it with alcohol before applying. Sometimes affixing a spring or heavy band of rubber around the diameter of the drum can alleviate squeak.
If you're using low quality brake pads switch to a better grade.
What is the brake fluid in a 2001 Ford Focus zx3?
ESD-M6C57-A ("Super DOT 4" for MTX-75 transmissions or 'manual transmission' models)
Source: Ford Focus 2001 User's Manual
Can you buy brake fluid at a gas station?
Yes, most gas stations carry a generic form of brake fluid.
