0
Ford Windstar SEL
The Ford Windstar SEL was a second generation Windstar model manufactured by Ford Motor Company from 1999 to 2003. Some of the features of this vehicle are adjustable head restraints and an LCD screen.
639 Questions
What type of refrigerant does a 1999 Pontiac Sunfire take?
In the early to mid 90's all manufacturers were forced to convert to 134A
1989 ford f 150 gas tank size?
The front tank on an 8 foot bed is 19 Gallons. The rear tank on an 8 foot bed is 14 gallons. On a 6 foot bed the front tank is 16 Gallons and the rear is 12. The front tank on an 8 foot bed is 19 Gallons. The rear tank on an 8 foot bed is 14 gallons. On a 6 foot bed the front tank is 16 Gallons and the rear is 12. On mine, i believe the front is 19 gallons and the back tank is 16 gallons. However, i have seen front tanks for sale that are 16 gallons also, but they may be just smaller replacement tanks that fit.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
100.000 k/m 60 000 miles
When should the Timing chain on your 1997 Ford F-150?
Normally, not until an overhaul. But if you hear the chain making noise or the timing changes due to the chain jumping a tooth, then replace it, and all gears.
What year is your vehicle, and what year vehicle are the seats from?
If your vehicle was designed for heated power seats there should be an open port for the harness and relay. The proper procedure is then to aquire the stock harness and wire bundle (check a junk yard), plus the correct relay and fuses. Route these wires in the factory clips ( there should be a molded plastic channel for all wires in the floor near the center column or kick plates) and through the precut locations in the carpet. Plug them into the new seats. Plug the relay into the factory location. Add the fuses to your fuse block. If the heaters require a separate switch on the dash there should be precut locations with plastic slugs in them. Punch out the slugs and replace them with the switches. Test the seats. If they do not work consult a professional installer.
If your vehicle was not designed for this option contact an MECP certified car stereo installer and they can wire this for you.
I would charge around $300 in labor, plus the 15% over the cost of any parts. You would be looking at a fee of $450 or so through my shop because this is about 2 hours of work (really only about 45 min if precut by Jeep) after I get the parts. Best case is a full business day, likely 2 because of parts. Believe it or not, that is pretty fast and cheap. A dealer will probably charge around a grand and have your vehicle for 3 to 4 days minimum.
How do you reset anti theft on 1990 deville?
Got One That Does Some Crazy Things Too. Try Locking Your Door With The Key, Then Unlock With The Key. This May Do It. Best To You
What is the size of a gas tank for a 2007 Dodge Ram?
1500 Short Box 98L (26 US Gallons)*2500/3500 Short Box 128L (34 US Gallons)*All Long Box 132L (35 US Gallons)*Cab/Chassis Models (Standard/Rear- Mount) 197L (52 US Gallons)*Cab/Chassis Models (Optional/Mid-mount) 83L (22 US Gallons)*
How do you program a keyless entry remote on a 2000 Ford Windstar?
Turn Ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. All doors will lock then unlock to confirm programming mode. Within 20 seconds, press any button on remote transmitter. Door locks will cycle to confirm programming. Turn ignition to OFF. Locks will cycle again to indicate end of programming mode.
What does the brake light switch do on a 2002 ford windstar?
Brake light switches are pretty universal in function:
* Activate the brake lights * Send an electrical signal to the shift interlock (or similar phrase) - allows the vehicle to be shifted out of park. This has been a safety feature for many years.
Brake switches are mounted to the brake pedal arm and has a simple wire connection and just a bolt or 2 for mounting.
Easy to test, easy to replace.
What kind of noise does a bad front wheel bearing make 2000 sable?
It will rumble and increase with speed.
Where should the timing marks be relevant to the timing chain on z24?
The timing marks should be dot to dot.
Check your manual. There is a fuse for the seat motors, pretty sure it is independent of anything else.
Does the 2003 Subaru Outback 3.0 engine have a timing chain that needs to be replaced?
no, its a belt, check your owners manual for the mileage interval it will need to be changed at
What size gas tank is in 2007 HHR?
When driving a car, it is important to know how much fuels its tank will hold. A 2007 HHR has a fuel tank capacity of 16.0 gallons.
How do you replace the bulb in a Ford Windstar cornering light?
There are screws that connect the outer portion of the fender (the black painted part) to a black plastic piece underneath the car and going up into the wheel well. From the point where it goes from horizontal (ahead of the wheel well) to vertical, remove three screws in both directions. You may have to get a pair of locking pliers (vise-grips) to start them.
Once removed you can lay on the ground and look up into the space where the light is. You can twist and remove to replace the bulb, and it also looks like there's enough room to get tools up in there if you have to replace the lens. Bulb: 3156k
What would cause the backup sensors to stop working on a Ford Windstar - Freestar?
It was just a few months after I bought my 99 Windstar that I had problems. It always seem to happen after it had rained and when I got to the dealer the problem went away. After numerous trips they seemed to finally resolve the problem.
I was told that they used some kind of marine sealant on the sensors. It would appear that when it rained or after I washed the van the sensors would short out. That seemed to work for about 2 years now the problem has returned. The sensors seem to work after a few days of no rain. I think the sealant has broken down.
How do you calibrate the compass on a Ford Windstar when the instructions in the manual do not work?
Your automatic dimming rear view mirror may not be working as well. If so, you have a blown fuse. A 5 amp fuse I believe.
2003 Ford Windstar Error code 16 what is it and the fix?
code 16 is B2290 bad occupancy sensor, it's an airbag safety system code and you can find it under the passengers seat. You can check the wire connections there, but a good scan of the system will need to be done to really isolate the issue.
How to change the motor mounts on ford wind star?
To replace motor mounts, they are unbolted and the engine is raised off them. You can use a mobile crane (cherry picker) to lift the engine. The mount is replaced with a new one. Install the engine mount bolts loosely on the block. Leave them loose during engine installation so that the mounts can be more easily aligned with the frame mount brackets. A rolling head prybar is handy when aligning mounts. Use the pointed end to line up the mount bolt holes before installing the mount bolts. A rolling head prybar is helpful when aligning motor mounts. Do not use the engine mount bolts to pull a V-type engine into place. Use shims if necessary to fill any gaps between the mount and block. The Automotive Engine Rebuilders Association reports numerous cases of block distortion resulting in scuffed pistons in cylinders, near mount that were forced tight.
What size gas tank does a 1994 Ford Escort Wagon LX have?
Fuel capacity according to ford specs is 13 gallons for a 1.8 L engine and 11.5 gallons for a 1.9 L
