Where is the speed sensor on 2003 Pontiac grand am gt?
I have an 03 grand am gt, the speed sensors are built into the hub assembly on each wheel.
What does it mean if first you had no heat and now you notice no antifreeze in your overflow tank?
Coolant leak?
Check to see if coolant is getting mixed with engine oil
Run engine to normal operating temperature and remove oil dipstick, let a drop fall on hot part of engine - oil will smoke coolant will sizzle.
If coolant is mixed with oil could be a bad head gasket.
If coolant mixes with oil you won't need any special tests to see it. When they mix it will look like a vanilla milk shake.
The newer coolant return systems are designed to keep the coolant level inside your radiator and engine full. When you car cools down (after running at normal temperature) it is designed to pull coolant out of the return reservoir back into the radiator. If the system gets too much pressure (usually from getting too hot) it will push coolant into the reservoir and then pull it back in as it cools. If the system has a leak then it will always pull back in more than it pushed out and the reservoir will have all coolant removed. Then the system will begin to draw in air causing the engine to eventually overheat from lack of cooling.
Your heater works from the hot coolant passing through a small "radiator" under your dash. If the coolant is low then little or not hot coolant will pass through it.
How you replace a fuel pump for a 2001 Pontiac grand am gt?
How do you remove the fuel pump from a pontaic Grand Am GT 2001
What size for a Pontiac grand am gt 2003 drivers side wipers?
The 2003 Pontiac Grand Am takes 22" drivers side and 17" passenger side wiper blades. See related link below. To ensure correct attachment as well as length, lookup exact wiper part numbers by make, model and year of vehicle.
I HAD THIS SAME PROBLEM ON MY 2002 GT1, IT ENDED UP BEING THE PASSENGER SIDE ABS SENSOR SWITCH WHICH IS PART OF THE WHEEL BEARING ASSEMBLY.COST ABOUT 160.00 AND TAKES ABOUT 1/2 HR TO INSTALL YOURSELF I ALSO HAD THAT HAPPEN BECAUSE THE BATTERY WAS BAD BUT IT STILL WOULD START THE CAR
Where are the spark plugs located on a 1993 Pontiac Grand AM?
Look in the manual for the car. If mot a dealersip will know simply call the part department at a GM delaership on the 2.3 liter 4 cylinder the plugs are under the metal cap on top of the engine which has either sohc or dohc on it.. they are on the firewall side once you remove the cap.
tps or idle speed motor
How do you remove the rear inside door panels on a 2000 Olds Alero?
pop the switch panel off and then the door mount support with a socket
What size socket do you need for the axle nut on a 2006 Pontiac g6?
once you remove the retaining tabs off of the washer that are covering the nuts, it takes a 34MM DEEP SOCKET
Pontiac grand am gt 1998 coolant temp sensor?
I have a 1998 Pontiac Grand AM GT that coolant sensor went bad. So how do you change it with out breaking the coolant
Where can you find a diagram for a Pontiac Grand Am engine?
Try alldatadiy.com for diagrams - but you have to pay a minimal fee.
Would a dirty fuel filter cause engine surging on a 1999 Pontiac Grand Am GT?
A) Change the filter, $25. B) Have injector system cleaned etc., $100. C) I had a surging problem 45-50 MPH. Battery terminals were corroded. I do not know how it even started. It was the original batt. 129,000 miles, 7.5 years old. I bought the car used in 2005, a 1999 (12/98) GP-GT @105,000 mi. I discovered the terminal problem when I had starting problems a week ago. The negative terminal was loose, and the positive terminal was "solid green/white" corrosion. Cleaned the terminals, replaced the battery, it was due. Behold my surgging stopped, tranny shifting is smooth, mpg & fuel read out is working dead nuts now. Check it out it worked for me. Dennis
platinum plugs atleast that's what they come with from the factory
Will a 5X115 bolt pattern work on a 5X4 and 3 quarters bolt pattern?
no. 5x4.75 and 5x120.65 are interchangable. these are also known as "small Chevy bolt patterns"
How do you replace the license plate bulb in a 1995 Pontiac Transport?
unbolt lens, remove bulb socket quarter turn
Is there a way to disconnect the anti theft feature on a 97 Grand Am GT?
Just go to any dealer and ask for assistance, they should do it for free.
How do you adjust tensioner to replace thrown belt on 1992 buick lesabre wac v6 4.3?
The tensioner is automatic, no adjustment needed. If you threw the serpentine belt then look for a misaligned pulley or worn tensioner wheel. If you need to move the tensioner to get the belt back on then look for a square hole in the tensioner arm. Use a breaker bar with the appropriate sized square (probably 3/4") to move the arm to get the belt back on.
probably tensioner is bad like a failed bearing
Where is the ECM ignition fuse on a 1988 Chevy Beretta GT?
Your ECM should be located on the passenger side of the car. remove the glove box and it should be on the outide wall. I am not sure that there is an acual fuse for this. but that is where the ECM is located. i hope that this is helpful.
What is the stock tire size for a 1992 Pontiac Grand am?
Go to tirerack.com and put in your info.Go to tirerack.com and put in your info.