Mitsubishi Lancer

Cam position sensor is in a mystical place called under your timing chain cover.... good luck

4, two front and two rear, I recently had to change the rears anyway, since it was misreading its information and causing the service engine light to come on and they wouldn't pass my emissions inspection.

No

Why would you "bleed oil" changing the oil in this car would be no different then changing it in any other car. Simply decide what Oil you are going to use [http://www.goodoil4u.com/comparative_motor_oil_testing.html Synthetic or Conventional] and purchase the correct amount and filter. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.

Clay is a good insulator because It doesn't have any metal inside, and it's compact.

I belong to the FTO owners club here in England. I found some information you may be looking for. http://ftooc.org/phpbb/viewtopic.php?t=18530&postdays=0&postorder=asc&start=0

the srs system needs to go through a self check then the codes will be able to be cleared.this will only be reset if the relevant parts have been replaced .there are many reasons why the lamp may be on,all the codes and details will be retained in the srs ecu for ever.this information will be used in the event of an accident .There fore it is not in anyones intrest to try and switch the srs light out unless the faults have been repaired in a professional manner

The 2004 Mitsubishi Lancer-Evolution has a 5-speed manual.

The Service Reminder Indicator (SRI) is fitted to all 2000 EuroVans It stores two sets of information: Oil Change and Inspection Service. Here is the method to manually reset the SRI after performing a service: Switch ignition OFF.

Press and hold down the trip odometer reset button (at the lower right of the instrument cluster).

Switch ignition ON and release the trip odometer reset button. It is not necessary to start the engine; merely turn the key until the ignition is ON.

The trip mileage area now displays "Service OIL".

If trip odometer reset button is now pressed again, the display turns to "Service INSP". Pressing the button again will cycle the display back to "Service OIL".

When the reminder that needs to be reset (either OIL or INSP) is displayed, turn button for setting the clock (at lower left of instrument cluster) to the right. The display changes to "Service ----". That reminder is now reset.

The second reminder is unaffected unless it is displayed by pressing trip odometer reset button and the clock button is turned right again.

Switch ignition OFF and back ON to resume normal display.

FROM A HAYNES MANUAL

The keyless lock might stop working on your Mitsubishi Lancer because the battery is dead or because there is a problem with the wiring. You might also have a problem if the brain or computer of the vehicle is damaged.

ignition. blue
memory. red and green

press the reset button nope, that does not do it. whoever gave that answer (press reset button) must be joking. the proper procedure iswith engine shut offyou then proceed to disconnect the battery andleaveitdisconnected for a few minutes (15 minutes should be enough). this will erase the "driver profile" in the ecu. then reconnect the battery, start theengine, turn on the a/c AND let it idle for about 20-30 minutes. this idle time is very important since it allows the ecu to reacquire the engine parameters it needs.if you don't let it idle for at least20 minutes then you'll see your mileage go down and it may not shift right (for those with a/t). also be sure to keepthe transmissionin park or neutral so as not to interfere with the ecu resetting itself. don't press the brake or accelerator pedals either.

You can install something like this

[url]http://www.audiovox.com/webapp/wcs/stores/servlet/ProductDisplay?catalogId=10001&storeId=10001&productId=341067&langId=-1[/url]

For the 2.4 litre engine:

4.3 litres if changing the filter as well

the only stock lancr that has a turbo from the factory that isn't an evo is the 09 lancer ralliart. if you would like to buy a turbo kit for a new 2008 lancer or above, you can find one at roadracemotorsports.com.

Have your servo control checked

when you hook up the battery and the alarm goes off hit the unlock button on your door lock remote.

The 2003 Mitsubishi Lancer is 14 ft. 9.6 in. (177.6 in.) long.

The curb weight of the 2003 Mitsubishi Lancer-Evolution is 3263 lbs..

Yes it can as dark and light colors absorb and reflect light. The darker the more it absorbs light and heat energy.

Amazing what you can find on eBay. Including Mitsubishi parameter unit FR-PU03.

there are 2 adjustment screws for the lancer 95 model...the first screw is located near the radiator(of course both sides) the other one is almost at the edge of the of your hood..if your going to adjust the height or the beam of your headlight you should adjust the screw near the hood(but you need patience in adjusting your headlight) if you want your beam higher you should turn the screw to the right but if you want it lower just turn in to the left...like what i said you need a lot of patience in adjusting the headlights...the other screw is for adjusting the width of your beam...

In the Lancer CVT transmision there are to simplify things a series of "belts" that allow the transmision to vary the gear ratio based on the vehicle's needs. For example, if the driver accelerates quickly it will switch through the gears and keep RPMs high as you accelerate to maximum speed; conversely if the driver accelerates slowly it will maintain low end torque to and keep RPM in the medium range to maximize fuel economy.