0
Turn Signals and Hazard Lights
Turn signals and hazard lights refer to the lights on an automobile designed to alert other drivers or pedestrians. Turn signals indicate where the vehicle intends to go, while hazard lights warn others of an emergency.
4,468 Questions
What is wrong with a 2001 Nissan Xterra if the blinkers stopped working and the flashers still work?
I believe the flashers are on a separate fuse than the blinkers, that is where I would first start to look, is the fuse box
Why does a 1997 international 4700 truck blows fuses when using left signal?
The wiring in the left turn signal circuit shorted out. Or it can be the socket that the left turn signal light screws into is shorted out. Look for bare wires or corrosion.
2000 f350 turn signals and hazards quit working inside and out fuse is good what could be wrong?
Have had this problem many times. It's one of two things for sure. The multifunction switch or the flasher/turn signal relay behind the dash are faulty. The relay is blue and is a dual functioning relay which means its 2 mechanical relays in one. One for the flashers and one for the turn signals. It even has a little circuit board inside that some times fries and one or the other won't work. If you take the relay apart you can typically see the burn marks on the circuit board. Good luck.
The tail light bulb is the bottom one and is a 1157 that has two elements. One element can still operate for the signal but the tail element is broken. Replace this bulb with a new 1157. Fuses don't control left or right, they control both together. Fuse goes, both go. Check pigtail for corrosion (white looking powdery substance) and clean it if needed, and check for voltage at the pigtail. If no voltage, trace wiring from bad light socket, toward fuse box, checking every few feet, for voltage, until you get a good voltage reading. From that point, back to the tail light socket, the wire needs to be replaced. Don't forget to check the ground, also.
How do you replace the turn signal switch located on a 1992 Buick Regal Custom?
i dont know but getting ready to do it on my1991 but recently did my F150 and it looks the same so start with a steering wheel puller.... remove the steering wheel and unscrew the screws holding the switch onto the steering column... honestly not as hard as I thought it would have been..........
How do you access the flasher relay in a 2003 Mountaineer?
I have a 2000 Mountaineer and my flasher was located to the right of the drivers leg just under the dash. It should be mounted to a bracket there and easily located. On mine, I was having problems and all it was was that the wire had come a little loose. I pulled the wire off and then put it back on and haven't had a problem since.
What would cause turn signals to not flash on a Taurus - Sable?
Check out the "Related Question" below for lots of information about malfunctioning flashers on Taurus - Sables. It's not as bad as you might think...
How do you replace the side marker light on a 2000 Nissan Xterra?
2000 Nissan xterra sidemarker light bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you replace the front side turn signal bulb on a 2001 Buick LeSabre?
2001 Buick LeSabre turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you replace a bulb in a 2006 Lincoln navigator?
2006 Lincoln Navigator light bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
What kind of lights are in brake lights and turn signals?
They used to be incandescent, but more and more often now manufacturers are using LEDs.
Where is the flasher relay on a 2003 Chevy Malibu?
The flasher relay on a 2003 Chevy Malibu is located under the dash near the steering wheel. Look for a bright green plug.
How do you replace back left signal on 1995 Ford Taurus?
you have to take the brake light out of the housing and then twist the amber bulb out
I had the exact same problem 5 years ago. Took it to a shop and they said it wasn't the bulbs but the device that the bulbs plug into that was bad. They claimed that GMC used "cheap parts". They fixed it (it wasn't cheap) and not even a month later, the other side went out. They fixed that as well. Now, 5 years later, I'm having the same problem again. Been searching this site for answers. Was going to start by trying to replace the bulbs myself, but I can't even seem to get the old bulbs out of their sockets. Is there a special tool you are supposed to use?
What is the location of the flasher signal in 1974 corvette?
I assume you mean the Flasher Relay. It is located in the front seating area, passenger side, under dash, mounted above kick panel.
How do you change the hazard switch on a 2002 Chevrolet Malibu LS?
The hazard/signal switch located in the center of your dash is actually all located in the hazard button. It requires a small flathead screwdriver and a little bit of care in trying to get it out. There are two small tangs on either side of the switch that must be depressed and slid out. When you get the switch unplugged, it is as simple as plugging the new one in. Really only a few minute job. Some models (depending on dash configuration) may require that you gain access and remove switch from in behind the dash. This could lead to a bit of extra work in gaining access but still only a 20 minute job.
Where is the signal flasher located on a 1995 Buick Skylark?
Left side of the steering wheel behind the dash board. You would need to remove the underside panel of the dash board as well as a metal plate. You would probably also have to remove the dimmer switch panel and the metal bracket just behind it if you want to see where your hand is going. Access to the flasher is through the underside. Look for a light blue plastic connector.
Where is the turn signal flasher located in a 1994 Plymouth Acclaim?
On your 1994 PLYMOUTH ACCLAIM, the FLASHER is: FRONT SEATING AREA, PASSENGER SIDE, UNDER DASH, MOUNTED BEHIND GLOVE COMPARTMENT You can find this stuff free at autozone.com, repair info, component location.
faulty hazard button assembly, if you are mechanically enclined you can open the button apart and adjust the contacts inside and that will fix it, if not just replace the button assembly.
Check ground on that fixture short in the wiring it sounds like
Where is located the turn signal relay in mustang 1991?
I have a mustang 1991 GT I bought like a week ago,,everything work . but the turns signal no,,,i replace already the swich[turn signal] but nothing,,i replace the hazard swich,nothing,,everything have power,,all the fuse too,really I want to know if they use some relay,,,i check already in the fuse box the hazard relay please somebody know what is the problem,,,,thanks
What is the correct light bulb for a 1993 S10 Chevy blazer rear turn signal?
2057 bulb you can find it cheap at walmart.
How do you replace the turn signal switch located on a 1997 Mitsubishi Mirage?
The turn signal switch is mounted in the steering column. Unscrew all 5 screws in the bottom of the lower cover and remove the lower and upper covers. You should now be able to see the switch itself and how it is mounted to swap it out.
Brake lights and turn signals don't work on Lincoln navigator?
Turn Signal / Brake Light Troubleshooting (check in this order):
1. Check Fuse
2. Check Bulbs
3. Check Flasher Relay
4. Check Turn Signal Switch in steering column and/or Brake switch down by brake pedal.
Most likely its the fuse or bulb. See sources and related links below for bulb information.
