You changed your oil on your 98 Chevy cavalier and now it smoking what do you do?
It may just be spillage. Usually some end up on ex. manifold no matter how careful you are. See if it will burn off.
Where is the crank sensor on a 92 Chevy Cavalier 4-cylinder 2.2L?
The crank sensor is located on the back engine wall in the middle, just under the two coil packs (from where the spark plug wires come). There is a wire harness from the crank sensor to the module which holds the two coil pack. The crank sensor is held into the engine by a single bolt. To see all of this, you have to go under the car. I am having an intermittent no start problem with my 93 Cavalier (it cranks, but no spark at all) and I think the crank sensor is my problem.
How do you replace the rear speakers on a 94 Camry?
well the rear speakers in a 94 Camry are 6x9 speakers and u can get after market 6x9 speakers at common large stores like BESTBUY www.bestbuy.com ... anyways when u buy 6x9 speakers at bestbuy they install them for an additional $55 appx.
good luck
Where is the IAT sensor on a 2001 Chevrolet Cavalier?
The 2001 Chevy Cavalier IAT sensor can be found on the right side of the transmission. The sensor will be near the front of the transmission.
How do you know when the fuel injector is bad on a 99 expedition 5.4 engine?
Locate which cylinder is dead, remove the spark plug, if the spark plug is bone dry the injector is probably not working.
1989 Chevy cavalier will not stay running after it is started?
A 1989 Chevy Cavalier will not stay running after it has started if the spark plugs are fouled, the fuel filter is dirty, or it has a vacuum leak. Taking the vehicle to a local mechanic or dealership can pinpoint the problem.
How do you check the transmission fluid on a 1993 Chevy Cavalier?
For a Cavalier, you have to turn her on for a few minutes to warm up the fluid. Then use the dip-stick on the transmission fluid input. May I add that it takes 10 miles of driving to get the transmission up to operating temperture. Check the fluid level accordint to instructions in the owners manual. Sometimes this is hot in park, cold in park, depends on the vehicle. Make sure the vehicle is sitting on a level surface. Do not overfill as this can damage seals.
How do you replace the license plate light bulb on a 1994 Chevy Cavalier?
I had to open my trunk, look inside and find butterfly/thumb screws. I un-fastened them and dropped down the entire light bank including the licence plate. One big strip. You can then access the lights from the back of the strip.
How do you get the door panel off of a Chevy Cavalier?
(STEP 1) Remove the 2 screws that are in the door handle.
(STEP 2) Using a door handle remover found at your local auto parts store for about 3 bux, or better yet, a butterknife...remove the pin holding on the window crank handle (The pin looks like a horseshoe kinda) Then remove the crank handle.
(STEP 3) Remove all the screws along the perimeter of the door panel, I think there are about 5.
(STEP 4) Now just pull the panel out and up. If you here small "snaps" it is normal because it is also held on with clips.
How do you remove the buzzer switch assembly from Chevrolet pickup?
If you are talking about the swith under the turn signal switch assembly with the long copper arms, put in the key to release lock mechanism and it should slide out.
What is the wiring diagram for an 1988 Chevy Celebrity stereo?
what is the wiring diagram for an 1988 Chevy celebrity stero
Where is the transmission fluid plug on a 1994 Chevy cavalier with standard transmission?
I have a 1993 Cavalier in which I finally figured this out and I am assuming that it is similar to the 1994 location. It is not a plug, but a dipstick about 2 inches long which is located on the driver's side near the rear of the transmission. You must get to it from inside the engine compartment. It is the type that has a handle that locks down by pushing it to the right. Just make sure you put it all the way back in when checking the fluid level. The literature I have on it states: "Check both sides of the dipstick and read the lower level. The fluid level must be between the ADD and FULL marks. (Note: Fluid may appear at the bottom of the dipstick even when the fluid level is several pints low.)"
How do read a gas gauge to 1972 vw bug?
when the needle is all the way to the right(away from the red) the tank is full
the closer the needle gets to the red the less gas you have
How do you know if ecm is bad?
Plug in a code reader. If you get no response, bad ECM or a bad wire/fuse going to or from it. But you may get symptoms of stalling,lack of power,bad fuel milage, and many more things that just don't seem right. But the code scanner will be you best angle of attack.
How do you adjust or replace the lifters on a 1996 Chevy Cavalier?
Actually the 96 cavalier i just rebuilt for a guy has an Over head valve engine in it meaning it has a cam inside the block with lifters and pushrods running up to the rockers up top.To start off make sure your engine is set to TDC #1 cylinder adjust the rocker nuts to 0 lash then 1/4 turn to tighten .Then put engine on TDC #3 do the same thing . Then cylinder #4 TDC . Then #2 TDC. Once you have done this on all 4 cylinders install the valve cover and it should fire right up. to do so you will have to remove the valve cover on the top of the engine. it would be a good idea to go to a parts store and purchase a repair manuel for your car if you have never done this type of work.
How do you replace the fuel injector o-ring on a 1997 Pontiac sunfire?
Been there, done that.
First, a little preface. I had two leaking injectors in my '96. My mechanic and I pulled the injectors out to examine them. We found no cracks or any other signs of damage, so we replaced the O rings and put everything back together. While this helped, I still had two injectors leaking. We ended up replacing those two leaky injectors. Everything is fine and my mileage increased by about 3 MPG!
The point is, that you might have leaky injectors, not just leaky O rings. Considering that new injectors are fairly inexpensive, (I paid $76 each at Auto Zone) you might want to just replace them right off the bat.
But on to your question. Getting the O rings on/off the injectors is the easy part. It's a no brainer. But first, you have to get the injectors out of the holes in which they live. (I strongly suggest picking up a Haynes or Chilton manual. Their instructions and illustrations are pretty good and will give you a good overview of the job.) The job is fairly direct. You'll probably need to remove the large air intake tube to gain access. After that, you have to remove the black cover from the accelerator housing. This is the black boxy thing on the left (when viewing from the front of the car) and to the rear of the valve cover. You'll know it by the accelerator cable and maybe the cruise control cable which go into it. Take loose the cables and remove the housing that holds them. You'll see that this needs to be done to get at the left side of the plate which runs across the engine in front of the injectors. It is what holds the injectors in place. The other side is pretty accessible. If I recall correctly there are a couple of Torx screws that hold the plate in place. Once it's off, you can pull the injectors out and replace the O rings or the injectors themselves. When we did mine, my mechanic put some vaseline lookin' stuff on the outside body of the injectors. I guess this helps to slip the new injectors in, and probably helps to keep the O rings pliable. I'm guessing that this was not really vaseline, but an automotive specialty lube. Reassembly is basically the reverse of the above. Hopefully, your problem will be solved..
Take note that I've probably omitted some steps. My memory is good, but it's short ;)
Also note, that this is based on my experience with the small OHV engine. Your car may require drastically different procedures.
Again, please pick up a Haynes or Chilton manual!
FriPilot
For a 1996 silverado, there is no fuse between the fuel pump relay and the fuel pump. There is 2 connectors, one just outside the tank and one inside the tank connecting to the fuel pump itself that could be your problem if the fuel pump is good.
Where is the fuse box on a 1993 Chevy cavalier for the blinkers?
Not in fuse box. Prob. blinker bulb( there's one for each side) they are dash on driver side. they are about 1" round silver cylinder shaped
How do you repair a broken turn signal lamp on a 1992 Volvo 740 Wagon?
You need to replace it. There are 2 screws that hold it on.
What is 08-10-1983 in roman numerals?
VIII-X-CMMLXXXIII this is the answer.
is 8 10 1983 your birthday??? VIII-X-MCMLXXXIII
How do you replace the head gasket located on a 1981 Ford F-100 inline 6?
This is a big job and if you want to do it get a manual on it and do it right. You will need torque wrench etc. I don't know about thermogasket. There is a chance the head is cracked but it has to be checked when off.
If I am understanding your question my 01' Cavalier did this a couple of months ago, the keyless entry wouldn't worked and all you have to do in this case is press the unlock and lock buttons at the same time for a couple of seconds and that should reset it to make it work with the car again! !
Why would a 1997 Chevy cavalier leak coolant?
Leaking radiator radiator hose head gasket water pump Heater core thermostat housing