Buick Regal

Yes.

The power of the engine and the maximum speed of Buick regal sedan automatic 1970 is 3.8 L V 6-cylinder and 65 to 70 mph.

I know that on the 1990 3.6 231ci it is just under the air intake manafold. Two wires attached to it with a clip. You might ave to remove the air filter "system" to see it.

i had this same problem. changed my fuel pump, gas filter,and found out that there is a fuel pump module a-k-a resistor located in the front right fender behind and under the battery. it burned out. changed it and the car runs like new again.

you DONT it is a required safety feature that they also be on - they act as sidemarkers.

Havent you read "unsafe at any speed"? That's when they mandated it!

Or you can pull the DRL fuse and use the lights whenever you want. just use your head when its dark or skies are grey and so is your car turn something on.

If the radio has both knobs to the left of the radio, then you will pop off the trim that surrounds the radio. Behind this trim you will find the screws that secure the radio. Caution- there may also be a rear support bracket which would require you to crawl up under the dash and unbolt it. The wires are probably long enough that you can unplug them after you remove the radio from the front. Installation is in the reverse of removal.

If this is the type of radio that has a knob on either side, you will take the knobs off the radio, and remove the shaft nuts that hold the front of the radio in. A 5/8 inch spark plug socket would probably fit these shaft nuts. This radio also has a rear supposrt bracket that requires crawling under the dash to get at. These bolts would be a 5/16" or 8MM size. Disconnect the gang plugs and antenna before you pull the radio through underneath and back of the dash.

Use an 18mm wrench and place it on the belt tensioner pulley bolt. - The bolt has reverse threading so it will tighten as you apply counterclockwise force. Pull the wrench back towards the passenger compartment with your left hand (It takes some strength but it can be done). Then pulll off the belt from above the alternator. Careful not to let go for it'll ruin your day. Follow the schematic located on the front left of the car as you replace the everwinding belt. Once everything is aligned pull back on the tensioner once more as you finally engage the belt on the alternator. You're done.

Look on passenger side rear of engine

4.5 qts

The 1998 Buick Regal wiper blade sizes are 22" wiper blades on both sides front. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.

The VSS sensor on the '87 Buick Grand National is connected to the speedometer. You have the remove the dash to gain access to it. There you will find the three wire connection into the rear panel. The little green box is attached to the fire wall, the female end connects to the speedometer. You have to disconnect the speedometer cable under the hood for slack when pulling out. Remove dash trim, and lower steering column. This will make it easy to remove the speedometer. The speedometer is plug and play. Just pull it straight forward it will come out after you remove the screws. There you will find the connection of the VSS sensor follow the three connection down to the module "Green Box". Once you locate the VSS sensor there you will find it's connected by two separate plugins. One black and one white. Very easy to attach. Reverse process to complete installation.

between the transmission and the transmission housing

Levels are probably not fine. Check the radiator not the overfow tank for proper level. The radiator should be full to the top.

22" wheels are the largest size that'll fit w/o requiring special lift kit. But you can go bigger w/ some modifications. Go to Youtube or CarDomain.com and type in Buick Regals 1997.5-2004 and stroll through the photos you'll find Regals with even 28" wheels. I couldn't believe it till I seen it. I own a 1997.5 Regal LS and I'm doing 24s this Spring.

yes you do there are pics out there the show the correct mounting holes to use

YOU HAVE WATER UNDERNEATH THE PICKUP SENSOR IN THE DISTRIBUTOR..PULL THE DISTRIBUTOR CAP UP AND SQUIRT WD-40 INSIDE THE DISTRIBUTOR AND THIS WILL DRY IT OUT..IF IT CONTINUES THEN HOLD A HAIR DRYER UNDER THE CAP BUT THIS TAKES A VERY LONG TIME..DONOT UNDER ANY CIRCUMSTANCES TAKE OUT THE ACTUAL DISTRIBUTOR AS YOU WONT BE ABLE TO PUT IT BACK IN WITHOUT LINING UP THE CAM SHAFT AND I CANT BEGIN TO TELL YOU HOW TO DO THAT..ONLY REMOVE THE CAP..IF YOU STILL HAVE A PROBLEM GO BUY A NEW DISTRIBUTOR CAP AS YOU MAY HAVE A PIN CRACK THATS LETTING IN ADDITIONAL MOISTURE..IF IT STILL DONT WORK YOU WILL PROBABLY NEED TO GET A MECHANIC TO REBUILD THE DISTRIBUTOR. I HAVE BEEN THROUGH THIS MYSELF.

you have no idea what your talking about, theres no such animal a distributor cap on a 3.1 l buick century, its distibutorless.......

Under the hood, on the top left rear of the gray plastic intake manifold cover, the letters "PCV" are raised, it is directly under it. Remove that 1 plastic nut, gently lift off the plastic cover (if it's still on ther vehicle) then remove the 3 metal nuts from that plate the spark plug wires are resting in/on, remove the cover plate and pull up the spring, it's attached under the spring.

where is the 91 vandura G2500 Instrument Panel Cluster Relay located :milsunworld@yahoo.com

For going to movies at Regal Cinemas you earn points towards free things such as popcorn, soft drinks, and even free movie tickets. The more points you earn the more rewards you get.

I dont know about a regal limited but I have a 1992 buick regal gran sport 3.8 liter engine if your standing in front of the car look on the left side of the engine you will see the power steering pump it is under the pump you have to shine a flash light down the firewall to see it and can only get to it from under the car.

You will need an OBD2 scan tool or code checker to read the code. There is no shortcut on resetting the lamp. It's coming on for a reason. Find out which code is setting, repair the condition and then clear the code. Most of the time, once the repair is made, the vehicle will need to make two or three "trips" without a failure before the lamp will reset. Russtech67

The PCV valve for a 1999 Regal 3.8 is located on the top of the valve cover. The valve pulls out to replace it.

Disconnect the Regal battery. Remove the alternator belt. Disconnect the alternators wiring, then unbolt and remove the alternator. Reverse the procedures for installation.

You must first remove the Trim plate from the dash. There is a good procedure here:

http://www.wbodydb.com/tutorials/audioinstall/Regal97-00.pdf

The above procedure is for removing the stereo, but describes how to remove the trim plate first.

There is also a youtube video that describes repairing the instrument cluster here:

http://www.youtube.com/watch?v=84FAjLxoK00

I believe you can simply use a deep 9/16 1/2 inch drive socket on a long extension and put the socket on the nut on the shock and simply rock the bar back and forth and break the nut off and the shock will drop down.