answersLogoWhite

0

🚗

Car Starting Problems

Some of the common car starting problems stem from a discharged battery, a bad fuel pump (or no fuel), a weakened starter motor, or a broken electrical connection. Checking each part will help troubleshoot why the car won’t start.

5,524 Questions

Why does my Car only starts when its hot?

more then likely you really need an oil change with a lighter oil so when it gets cold the oil doesn't get so thick and hard to move.

Your 2002 suburban turns over but will not start what can be the problem?

A 2002 Suburban that turns over but will not start is not getting fuel to the injectors, the ignition system is defective, or the spark plugs are worn out. Performing a full tune-up of the engine will solve most of these issues.

When you start the car it run but when you hit gas pedal it cuts off?

i have had that problem, and it sounds like the fuel filter is clogged, you will need to replace the fuel filter.

Why would a 1989 Ford Probe start then shuts off if the car is getting fuel?

My neibor recently had the same problem with his 89 Probe. First remove and check the spark plugs. Fuel-Injector Cleaners, etc. tend to foul out the plugs. They may or may not need replaced. Just take them out and if they are black and/or look or feel wet, clean them up with a wire brush and a clean cloth and put them back in. If it still wont stay running, check the computer for codes. The procedure shouldn't be too hard to find on Google or similar. subminted by MiddleEartHippie(on AIM) I just had this problem with my 89 probe and it drove me crazy, turned out to be distributor needed replacement, also my tachometer went alittle hay wire while i kept foot on gas to keep it running.

What if Car will not crank over at all with fully charged battery?

Engine will not "crank"

Without doing a "hands on" troubleshooting of your vehicle, none of us can tell you specifically what is the cause of the problem.

Therefore this answer will be generic in nature. Here are some possible causes that I can think of at the moment:
  • A connector has become disconnected or loose somewhere in the "start" circuit.
  • Corrosion or road film has developed on the metal contacts within a connector or terminal connection.
  • A wire has become cut or broken.
  • The starter solenoid has become defective.
  • The ignition switch start contacts have become defective.
  • The starter has become defective.


There are surely other causes that I've overlooked at the moment. Good luck!

Where is the started located on a 1978 Oldsmobile delta 88?

It is located under the vehicle directly beside the front drivers side tire.

How do you keep the car battery alive when car is not in use?

take it out store in a dry place that's warm and not on concrete it will draw the juice out of it.

Why is the car taking longer to start when the key is put in the ignition?

A car may take longer to start in extreme cold, especially if it has an older, weaker battery. In any temperature, a car will take longer to start if it has a dying battery.

How do you figure out what the problem would be starting a 1993 mercury cougar that does not want to start in the winter?

Try unpluging the Ignition control module while the key is in the on position. Wait until you here the relays click, then plug it back in, next do not shut the hood or door, try starting it. If it starts, then you either have a bad Ignition module, bad harness connector or a sticking relay. This is the problem I have on my 94, but it happens more when it is hot. I discvered this while searching the internet for my prolem. I saw this for both hot and cold conditions. It is call the famous Ford connector wiggle test. Good luck. If you find it to be something else, please respond back to this post as I have still to this day not figured out what the exact problem is. Still wiggling connector Run1

The key will not come out of the ignition or start in a 1997 Chevy blazer but it does turn over and the neutral safety switch was replaced What could it be?

replace entire ignition switch. refer to Mitchell Manuel for precise removal instructions and special tools needed. ++ ANSWER ++ Mine did that for about a month. I just kept turning 97 Blazer on and off till it released the key. Been about a year and it hasn't repeated. Sure was frustrating. At one point I was leaving the key in it (throw a towel over the column) and used a spare key to get in & out. That is what insurance is for right?!!

Why won't a car that has been parked for years start?

Try turning the engine over with a wrench on the end of the crankshaft, removing the sparkplugs will make this easier, if you're unable to turn it, then it's seized. You will possibly need to do a full engine overhaul, to have any chance of starting it.

However, if you can turn it over this way, the fuel is likely to be 'Stale', the complete fuel system will need to be drained, cleaned (especially the fuel tank and carburettor), filters replaced and refilled with fresh fuel. Also check the ignition system, ensuring that there are sparks on all plugs (preferably new ones).

In the morning only mornings you have trouble starting your Toyota highlander and to get it to start I keep the rpm high press gas until it starts. The rest of the day it is fine?

if the car sits over night.. it may take a little longer in the mornings to get going. for instance if its cold.. u wait until it heats up.. do u see where im comin from? i work in the garage at Toyota of Easley

Why did your transponder key quit working after you change the battery?

Most likely the reason is when the battery is disconnected, there is no power to the PMC. On this car, you may have to reset the code, or chip...Try to disconnect the negative cable, and have the key in the ignition (KOEO), it may wqork...Tom..

When jumping off a car and the car wont start but only clicks what is the cause?

Low voltage. Clicking is the starter solenoid. Low battery on the good car, bad cables or a bad connection. If they are all good, then the solenoid may be bad.

How do you disable the Immobilizer Theft Deterrent System on a 2002 Volkswagen Cabrio as now the car will not start after attempting to use the valet key?

The immobilizer can not be disabled, You will need to go to the VW dealer and have the key re-programmed. If it is the correct key.
This problem can occur when the dealer replaces the ECU module - they sometimes forget to tell you that they will need ALL the keys to get them recognized as valid by the ECU.

Trending Questions
A 92 Dodge colt started ran died now it wont start and i have no spark why do i have no spark? What could you have for a starter? What does 18435672 mean? With the key in the 'accessories' position it has power. When the key is moved to the start position the car loses power completely. Any suggestions? Have a tooth broken off of crankshaft sprocket Will that prevent engine from starting? Do you have a bad head gasket when you have little compression and car don't start? What stops a car from starting? What causes the starter to not turn when the key is turned on a 91 GEO Prizm? What is the fuel pressure on a 1994 mercury villager? What is the ideal RPM when a car is started and is just idling? 1996 Toyota 4Runner has intermittent ignition problem All electrical will work but car will not start Might start an hour later Does not stall while engine running Recently replaced the battery and it? Where can you get a vacuum diagram for fuel tank for 1989 dodge ram 100 My truck gets low on gas and dies and won't start unless you fill tank found vacuum lines off? Why does my 1992 Chevy silverado K1500 350 crank but doesnt start? What happens to a car that has a broken crankshaft? 1996 Buick Park Ave has intermittant starting problem Starts fine when cold Runs fine Occasionally won't start after being parked Starts again after attempting to start appox half hour later? Does bad fuel filter make car not start up or downhill? 1989 Audi door wont unlock with key? What happens when a car is running just shut off? Your 1997 Mazda b2300 ran out of gas and still wont start after putting gas in? 1990 Ford F250 turn the key but it will not turn into start it will only turn into run it needs to turn one step further but it is maxed out already have replaced lock cylinder what is problem?