Car Stereos and Speakers

Standard 2 Piece Harness Up To Late 1990

It is most likely either jammed, or damaged so that some part of the player is holding the disk back. the clicking noise is the sound of the motor skipping.

You must bridge the channels

Wire for external amplifier is. Pink and black.

Look;;

AUX right input (Red) (KDC-6025 only)/ Sub Woofer right output (Red) (KDC-X679 only)

AUX left input (White) (KDC-6025 only)/ Sub Woofer left output (White) (KDC-X679 only)

Rear left output (White) / Sub Woofer left output (White) (KDC-MP625/MP6025 only)

Rear right output (Red) / Sub Woofer right output (Red) (KDC-MP625/MP6025 only)

KENWOOD disc changer input

To connect the Disc changer, consult your Disc changer manual.

Fuse (10A)

If no connections are made, do not let the wire come out from the tab.

FM/AM antenna input

Front left output (White) Front right output (Red)

Wiring harness (Accessory1)

When using the optional power amplifier, connect to its power control terminal.

Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna.

Connect to the terminal that is grounded when either the telephone rings or during conversation.

To "EXT.AMP.CONT." terminal of the amplifier having the external amp control function.

Power control wire (Blue/White)

P.CONT

Motor antenna control wire (Blue)

ANT. CONT

TEL mute wire (Brown)

TEL MUTE

External amplifier control wire (Pink / Black) (KDC-X679 only)

Dimmer control wire (Orange / White)

To car light control switch White/Black

To front left speaker

To front right speaker

To rear left speaker

To rear right speaker

White

Gray/Black Gray

Green/Black Green

Purple/Black Purple

FRONT • L

FRONT • R

REAR • L

REAR • R

ACC Ignition wire (Red) Battery wire (Yellow)

Ground wire (Black) - (To car chassis)

Ignition key switch

Car fuse box

Car fuse box (Main fuse)

Battery + -

I would sue him/take the car back.

Through the trunk you'll find 3 screws on each speaker that are holding on the speaker covers. Unscrew those, then from inside your car the speaker covers will lift right off. Also while your in the trunk your going to want to unplug your existing speakers. After you've done those two things, from the inside of your car, lift off the speaker covers, unscrew your existing speakers and lift them out. The 95 Accord comes from the factory with 6 1/2 in. speakers so this means that the speaker bracket or adaptor holding in the speaker is only that big. 6x9s dont fit in the factory bracket, you'll have to take that one off and buy an adaptor that will fit a larger size.

If you look under dash on drivers side there should be a rubber plug in the fire wall pop out plug drill hole into rubber plug the size of your power wire. run power wire through hole. Remove kick panels and lower door trim tuck power wire under carpet replace trim. Just repeat process on 2nd door pop up back seat run under carpet in to trunk. Also it is best to go ahead and run a 0 gage power wire from front to trunk so you will not have to repeat process later. Just connect you power wire to a distribution block. This will give you up to 4 power wire connection points for add ons later.

Car Radio Battery Constant 12v+ Wire: Blue/Yellow

Car Radio Accessory Switched 12v+ Wire: Gray

Car Radio Ground Wire: Brown

Car Radio Illumination Wire: Green

Car Stereo Dimmer Wire: N/A

Car Stereo Antenna Trigger Wire: N/A

Car Stereo Amp Trigger Wire: Pink/Blue

Car Stereo Amplifier Location: Located to the right of the glovebox behind the passenger side of the dash.

Car Audio Front Speakers Size: N/A

Car Audio Front Speakers Location: N/A

Left Front Speaker Positive Wire (+): Pink

Left Front Speaker Negative Wire (-): Violet

Left Front Tweeter: Powered by the same wires as the left front speaker.

Right Front Speaker Positive Wire (+): Light Green

Right Front Speaker Negative Wire (-): Blue

Right Front Tweeter: Powered by the same wires as the right front speaker.

Car Audio Rear Speakers Size: N/A

Car Audio Rear Speakers Location: N/A

Left Rear Speaker Positive Wire (+): Black

Left Rear Speaker Negative Wire (-): Yellow

Right Rear Speaker Positive Wire (+): Red

Right Rear Speaker Negative Wire (-): White

Most locations that sell stereos offer free installs, this is recommended. If installing a radio oneself they should take pictures while removing the old radio and purchase a harness kit to fit the new radio.

6x9's in all four doors. Tweet's in the dash, most 6x9's are coaxial anyhow so forget the dash speakers. =)

I bought a kit from all places, Wal-Mart. Turns out I bought the plastic parts thinking it had the wiring along with it but it didn't. But what it did have was the wiring diagram and I was able to match our 1999 Avalon with the wiring with the new stereo. With lots of thread baring and joining together, it works perfectly. Later at Wal-Mart, they do have the wiring kit that would have made it a whole lot easier.

third spark plug back on the passenger's side of the engine

Yes this amplifier is a mono amp so it is internally bridged. It does not have a stereo output.

After removing the radio from a Mitsubishi Triton, use a grey cable from the back of a CD-ROM in the computer. Connect to a stereo mic jack for the input to add aux lead for iPod.

you gotta take it to a dealer they will have to know the vin # and they will give you the 4 digit code and they should do it for you

You have to remove the door panel. Then it's pretty much self-explanatory.

Remove the covers to your 1997 radio speakers. Remove the radio speaker retaining screws. Remove the wiring harness from the back of the radio speakers. Reverse the process to install your new radio speakers.

There are to buttons "up" "down" press and hold the left one to change the hour.Press and the left one to change minutes.

1 : Purple - class 2 serial data (for warnings, etc) 2-7 : Blank 8 : tan / pink - Left front (+) 9 : gray - left front (-) 10 : light blue - right rear (-) 11 : dark blue - right rear (+) 12 : thick black - negative / ground 1: red/orange - constant +12volt power 2-3 : blank 4: light gray - illumination display function 5: skinny black - ground for illumination display function 6-7 : blank 8: brown - left rear (+) 9: yellow - left rear (-) 10: dark green - right front (-) 11: light green - right front (+) 12: blank Btw.. you do need a special harness if you plan to retain the warning chimes.. the harness actually comes with its own chime instead of hearing it through your speakers. You can also use a t-harness in order to have your old radio still conected maybe in your trunk or something. If you dont care about the warning chimes, then just wire it your self. Hope this helps :/

Well you can run the pink wire to the fuse box then add a switch.....When prompt to do so turn switch on for five seconds......Then turn it back off.....Then turn back on and leave on....TV will come on in 1-2 seconds.

The wiring diagram for this can be found in the owners manual that comes with it at the time of purchase. The wiring diagram for the car hook up can be found in the cars maintenance manual.

Not sure if this will help or not, but a CD gets stuck in my GM car about once a year. In order to get it out, I cut off all power to the CD player by removing the appropriate fuse for about 15 seconds. I put the fuse back in, push eject, and the CD always comes right out.

The front and rear speakers according to the Metra Electronics Fit Guide are 6x8".