0
Dodge Grand Caravan
The Dodge Grand Caravan is a long-wheelbase (LWB) model introduced in 1987 by Chrysler. This is the first generation of the family of minivan produced by the carmaker. It came in three trim levels: base, upscale LE and mainstream SE.
3,420 Questions
Is dodge caravan 3 liter engine made by Mitsubishi?
It was a Mitsubishi design, but I believe Chrysler built them.
It was a Mitsubishi design, but I believe Chrysler built them.
How do i change my Engine in my 2001 Dodge grand caravan?
It's not a job for a novice, you didn't say you were upgrading, so I assume you are simply replacing. First if you determine bottom end of engine is worn out and needs a rebuild or replacement, get a few estimates for each, You can either rebuild the existing or replace it with a lower mileage junkyard motor and have it done by a small shop or you can try to do it yourself, but still need to decide which route to go to refresh engine.
The engine is removed out the bottom on 2001 Dodge Grand Caravan.
What would cause rpm to race then slow while at idle in park on a 1998 Saturn SL 2 coupe?
your airflow is uneven
check the airflow sensor wire/ sensor
How do you change the starter in a 1998 Sentra?
This is how I did it.
Disconnect the battery negative terminal.
I removed the right drive shaft. This made it possible to reach the starter from under the vehicle.
Then I removed the brace that bolts to the block and intake manifold.
Then remove the electrical connections on the starter, one with a 12mm wrench from under the car, the other is a plug you can reach from the top (if your arm is skinny enough!).
Then remove the starter top bolt from above. It threads into the starter from the transmission side.
Then, from under the car, remove the starter bottom bolt.
The starter can then be removed from under the car.
As many a repair manual has advised: "Assemble in reverse order of removal."
Good luck!
can be a number of problmes take it toyour dealer to have it check out u don't know exactley where it is comming from or wt is making it do it they can tell u
Answermost likely one of your belts u need to take it in to have it checkd and looked at to fix the problemWhere are the speedometer sensors on a 2002 dodge grand caravan?
they used to be on the front wheels?
Why is the airbag light on all the time on a 1997 Ford Taurus?
It means the computer has detected a problem in the airbag system. Usually this will cause the computer to deactivate the airbag system. (Meaning the airbags will not work in an accident) The dealer can tell you what needs repaired.
How do you change the alternator on a 2001 Dodge Grand Caravan?
Hi firts remove the serpentine bealt. the alternator have 3 screws .
remove the 2 conector ground and voltaje.
1 upper remove this with 15mm .
2 screws lower. this is very easy I removed this yesterday.
What is the drag coefficient of the 2007 Dodge Grand-Caravan?
The 2007 Dodge Grand-Caravan has a drag coefficient of 0.35 Cd.
What would make a gurgling noise while idling and at low speeds in a 2001 Dodge Grand Caravan Sport?
Low coolant? Cooling system airbound?
Is a 1995 Caravan transmission compatible to a 2000 Caravan?
No, the range sensor/neutral switches are not compatible.
No, the range sensor/neutral switches are not compatible.
How do you fix leak on 2000 dodge caravan solenoid?
If the transmission solenoid pack is leaking it must be replaced. It can not be repaired. You replace the solenoid by removing the cooler hoses, the input speed sensor and the three bolts that hold the solenoid. remove the solenoid, clean gasket surface and reverse previous steps. Final step is to top off transmission fluid.
How do you change the starter on a 1991 Mustang?
I would recommend buying a high torque mini starter when replacing the stock starter(stock mini starter 92-95 mustang). It is very easy to install, you will need to run a new power wire from the left terminal of the start solenoid (facing the firewall) to the 5/16ths terminal on the mini starter (smaller terminal). Putting in the mini start you will notice a huge difference in space making it easier to run long tube headers and clearance for heat transfer.
basic tools needed:
floor jack
(2) jack stands
3/8 drive ratchet
3/8 drive extensions
3/8 socket
1/2 socket
9/16 socket
optional tools: 6 pack of favorite beverage
basic steps are:
1) Disconnect battery negative terminals.
2) Jack up vehicle on a level surface and place vehicle on stands. you can lift one side at a time or use the K-member to lift the front all at once.
3) If your 79-93 Mustang is equipped with a V8 engine, the starter will be located on the passenger side rear of the oil pan and is bolted to the front of the transmission. Using the 1/2' socket, remove the Mustang Battery/starter cable bolt located on the forward end of the starter and set it aside.
4) Next grab your 9/16 socket and remove the lower starter bolt and set it aside.
5) The top starter bolt can be somewhat tricky to remove and there are several different methods to do so. The easiest way to remove the top starter bolt is to use a few feet of extensions and work from the front of the engine.
Install:
Installation is the reverse of removal. Hold the new starter motor in place to get the upper and lower bolts started. With this application, there is no need to use a shim, just make sure that the starter bolts are good and tight(do not over tighten). Reconnect the starter cable to the front of the new starter using the 1/ 2 bolt (or follow instructions for mini starter). Also make sure that the contact surfaces of the starter cable are clean. Reconnect the battery and again make sure the terminals are clean and making a good contact. Before taking the car off of the jack stands, put the key in the ignition and bump the starter over to ensure all is working properly. Once this has been done, it's time to carefully set the car back on the ground.
Where is the fuse for the horn is located?
It is located in the fuse box under the hood; usually near the battery.
Can you drive when the rt front axel is grinding?
Not recommended can seize or break cause injury to you and other motorist.Also the more it is driven the more other parts may be damaged.
Could be a bad ignitor, those were notorious for overheating and cracking in years up to 1994. The ignitor is the trigger circuit inside the distributor, by the way.
I replaced distributor and problem was fixed
I had the same problem on a 1991 626. It also was a bad igniter that I believe is built into the distributor. The mechanic said to replace the dstributor, I did, and it's still running fine. (4years later)
Bill Smith
What year caravan engines will fit into a 1994 caravan?
Any engine from a 1991-1995 Dodge Caravan, Plymouth Voyager or Chrysler Town & Country should work fine
How do you reset the air conditioner in the van?
Here is how you should reset/recalibrate the A/C in a dodge caravan. Mine is a '97.
COOLDOWN TEST ENTRY
TO INITIATE TESTS:
Set Blower motor ON HIGH
Set Mode position to Panel
Open all A/C outlets
Set Temperature to Cold (Both slide pots if equipped)
Depress WASH and A/C simultaneously for 5 Seconds
NOTE: Prior to start of test, If the evaporator is already cold, the system will fail test. To correct, operate system with A/C OFF and the blower motor ON high for three minutes prior to starting test.
RESULTS:
All LED's will turn on for 5 Seconds
Cooldown Test is running when A/C and RECIRC. are alternately flashing. If A/C and RECIRC. are flashing simultaneously, Cooldown has failed.
answer found at www.allexperts.com
most likely the lock actuator plastic gears a stripped and slipping go get a new lock actuator
When do caravans open in skegness?
Caravans in Skegness typically open for the season around March and remain available until the end of October, depending on the specific site and its management policies. Many caravan parks may have varied opening dates, so it's best to check with individual sites for their exact schedules. During peak season, which generally runs from late May to early September, availability may be higher.
