0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
How do you install aftermaket speakers for 93 g20 infinity?
Install speakers by connecting them to stock speaker wire if you do not plan on running your own. Next, disconnect both wiring harnesses from the 2 rear trunk mounted amplifiers (IF 1993.5 model with-out automatic seat belts) or 1 amplifier (IF 1993) and using 10-12ga make enough U-shape wires approx 2" in length and re-connect positive and negative back together. Search on www.G20.net for an illustrated diagram. Install speakers by connecting them to stock speaker wire if you do not plan on running your own. Next, disconnect both wiring harnesses from the 2 rear trunk mounted amplifiers (IF 1993.5 model with-out automatic seat belts) or 1 amplifier (IF 1993) and using 10-12ga make enough U-shape wires approx 2" in length and re-connect positive and negative back together. Search on www.G20.net for an illustrated diagram.
If turn signal switch is bad on a 1986 dodge D100 what will happen?
when my 1986 w-250 turn signal switch went out the brake lights quit working.
How do you tighten a loose overhead console on a 1998 LT Tahoe?
there is a screw at the very front towards the winshield take it out and the unit should come down. take out the front compartment shield it should be empty, then make sure your clips are in place and put screw back in this is made easier with having the shield off when tightened replace shield
How do you disarm the alarm on a Dodge Ram 1500?
As nearly as I've been able to tell, you must either use the Smart Key or the keyfob to disable the alarm. Other than that, you can see if the dealer can disable it permanently.
What can you do to increase the horsepower in your 2.2 S-10 4cyl 5 spd?
I have added the following parts and mods:
accel wires uridum plugs jet chip stage 2 lower thermostat throttle body spacer k&n intake kit Electric fan conversion Cat back dual exhaust accel coils Larger throttle body from 2.8ltr engine from 93 grand am
These mods won't have you burning the tires off, but they will give you a definite increase in your acceleration. If you need more you can buy a turbo kit at this link http://www.maximumboost.net/product_info.php?cPath=21_350_353_354&products_id=423
Another couple of resources:http://www.minitruckinweb.com/tech/engine/0601mt_chevrolet_s10_four_cylinder_performance_parts/index.HTMLhttp://www.stsperformance.com/22performance.htm
http://www.dts2.net/turbos-10/
http://www.lmctruck.com/icatalog/cst/t.aspx
hope those help
It can be a bad sending unit or it can be low oil pressure. Start by replacing the filter with a Motorcraft filter if you have a Ford or Purolator if you have a Dodge, and making sure you are using the recommended weight of oil. If the problem still exists then replace the sending unit.
How do you change a rear pinion bearing on a 1999 Dodge 1500 RAM 4X4?
remove rear drive shaft from vehicle.remove large nut ( pinion nut) at front of diff, which is generally hidden when driveshaft is in place.with a bearing puller remove pinion bearing, replace with new one. install new pinion seal. reinstall pinion cover and pinion nut. tighten to specified torgue.reinstall driveshaft check diff oil for proper amount
How do you replace Brake pads on 2004 Dodge ram 2500 4x4?
The brake pads on a 2004 Dodge Ram 2500 4x4 are replaced by removing the wheels, unbolting the calipers, and taking out the brake pads. The caliper piston must be pressed back in before new pads are installed.
Show me a diagram of the firing order for a 1993 Pontiac Grand Am 3.3L V6?
1-6-5-4-3-2 #1 cylinder is in the front on the passaenger side and you wire it from the top down on the coil pack
Can stock 360 heads and valve train support a cam providing 444467 gross lift?
I believe the stock valvetrain can handle up to a .480 lift before valve springs and pushrods are needed. You can always call Summitracing Tech service. It is free.
The N14 was a 14 liter, inline six, heavy duty diesel engine made prior to the implementation of ACERT emissions regulations in 2002.
Where is the transfer pump on a 24 valve 5.9 cummins?
Factory location was driver side of the block, above the starter. New location is in the fuel tank.
Where is the speed sensor located on a 1997 dodge ram 1500 truck?
on my 4x4 it is on top of the rear diff into the housing..
How can you tell the difference from a limited slip and an open differential?
Three ways:
- Call a Dodge dealer with the VIN # and ask
- There is a tag usually on one of the rear diff cover bolts that says what it is, ratio and what oil additive to use.
- Jack up the back wheels and try turning one of the wheels. With the trans in park or for a manual in gear, in the limited slip the rear wheel will not turn by hand. The open differential will.
Except my truck, It has so many miles on that the guts inside the limited slip are so worn that it acts like an open diff for this test
How many speed sensors are on a 1998 dodge ram?
There are usually two separate speeds sensors on a 1998 Dodge Ram. One is located on the rear of the automatic and one is located on the front of the automatic.
How do you take off wiper arms off of a 1998 Dodge ram?
The wiper arm has either a nut under a cover at the transmission post or a sliding plate . The nut is self explanatory, the sliding plate you will stand the arm up to releive the pressure and slide the plate from under the post.
The red round circle light is the indicator for a failure in the theft alarm or Sentry Key (chip key) system.
The red round circle light is the indicator for a failure in the theft alarm or Sentry Key (chip key) system.
How do you tune the engine on a 2001 dodge ram 1500?
specd-halo l.e.d. projector headlights wiring installation" 1994 dodge ram
