0
Ford Bronco Eddie Bauer
The Ford Bronco Eddie Bauer was one of the three models of the Bronco product line. Eddie Bauer is powered by a V8 engine and has an automatic transmission mechanism. It also has rear cargo panels for the cargo net and cover.
705 Questions
Where is the flasher for the Ford Ranger 1999?
It is behind the pannel directly below the steering wheel. It is yellow. It is behind the pannel directly below the steering wheel. It is yellow.
How do you replace the 3 spark plugs on the back of the 3.4 Alero engine?
Unbolt both front engine mounts and use a ratcheting strap, pull the engine forward as far as possible. Then reeeeeach. :) You might find it's easier to remove the plug wires from underneath the car. A ratchet with elbow and an extension(s) are highly recommended for getting to the plugs. you can do it without going to the trouble of moving the engines. it just takes alot of patience and a rachet with a universal joint on it. Or, you can follow the wires to the back one at a time (make sure the engine is cool)and unplug one wire at a time, then unscrew the plug. if you stand at the side of the car while you are doing it you can just about see what you are doing. just be patient and you will get through it. after i did it once, it became rather easy.
Where is the speed sensor located on a 2002 Kia Rio?
top of tranny below throttle body one plug in and a 10mm bolt holding it down
Why is my 89 ford bronco hard to start and have small puffs of white smoke?
The white smoke could be caused by coolant leaking into the combustion chamber, though a cracked head or bad gasket.
How do you remove your factory radio from a 1996 bronco?
It should have ( 4 ) small holes around the radio corners, simply take some cut up clothes hanger and insert them into the holes and pull out, you may have to work with it a little bit they usually don't come out the first time.
Do you need to bleed brakes on a 95 corsica when you change brake pads?
normally you shouldn't have to,unless you've disturbed the hydraulic side of them
How do you replace tps switch on 1990 ford bronco 5.8L?
Same procedure. http://www.fullsizebronco.com/forum/showthread.php?t=53840&highlight=ultimate+tps Good Luck!
1997 ford f250 truck what size wrench is needed to take off the belt tensioner?
a T-50 star bit is needed to remove the bolt
Where is the speed sensor located for a 1989 integra?
The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.
How do you replace steering tie rod end adjusting sleeve?
To replace the steering tie rod end adjusting sleeve, first, safely lift and secure the vehicle, then remove the wheel to access the steering components. Loosen and remove the tie rod end from the steering knuckle and unscrew the adjusting sleeve from the tie rod. Install the new adjusting sleeve by threading it onto the tie rod and reconnect the tie rod end to the knuckle, ensuring proper alignment. Finally, torque all fasteners to the manufacturer's specifications and reassemble the wheel.
How do you change leaf springs on full size 1989 ford bronco?
To change the leaf springs on a 1989 Ford Bronco, first, safely lift the vehicle and secure it on jack stands. Remove the rear wheels, then unbolt the U-bolts and any associated hardware connecting the leaf springs to the axle and frame. Once the old leaf springs are removed, install the new springs by reversing the removal process, ensuring all bolts are tightened to the manufacturer's specifications. Finally, reinstall the wheels and lower the vehicle to the ground.
Can you manually roll up the window on a ford 1990 bronco?
Yes, you can manually roll up the window on a 1990 Ford Bronco if the power window mechanism is malfunctioning. You would need to access the window regulator assembly, typically by removing the door panel. Once exposed, you can either use a tool to turn the regulator manually or reattach any disconnected components to restore functionality. Always ensure safety and consult a repair manual if you're unfamiliar with the process.
What is the toggle switch for under the dash on the drivers side?
The toggle switch located under the dash on the driver's side can serve various functions depending on the vehicle model. Common purposes include activating auxiliary lights, controlling a fuel pump, or enabling features like a security system. It's essential to refer to the vehicle's owner manual to determine its specific function, as modifications or aftermarket installations may alter its original purpose. Always ensure that the vehicle is off before attempting to use or investigate such switches.
