0
Ford Windstar LX
Introduced in 1995, the Windstar LX was a first generation Windstar model powered by a 155 hp 3.8 L V6 engine, which can generate up to 220 lb ft of torque.
1,653 Questions
Can a transmission from a 1995 3.8l Windstar be put in a 2000 Windstar?
Maybe, 95 windstar has a different plug for transmission shift and the netrual safety switch ,But the plug for the trans can be changed,also you must have both in front of you to compare.95-97 ,98-01,your trans is an AX4N and uses syn fluild,,the car computer makes the trans shift.95 is an AX4S,I think it will work but as always you will have things to deal with.
I broke down and brought it in to the dealer. He said there was a trip switch mounted at the rear latch mechanism that needed replacement ($40). I was able to replace it myself.
This is very common on all Windstars.
Try lubing the contacts, cleaning the track where the door wheel rolls on rocker panel, and make sure there are no obstructions anywhere in the doors path. it happens to mine about once a month and there is usually dirt in the path somewhere which trips a safety sensor
You might also try cleaning the set of contacts and the pins. This is easiest done with a pencil eraser - simply rub the eraser on each contact to remove the oxidization that naturally starts to build up.
The door works on a "cycle" and the electronic pad on the door pillar may have become dirty.
Open the door and close it, and open again manually. pushing it all the way open until it locks into place. then actuate it with the door close button on your overhead console. If it does not work, then take a clean rag and window cleaner and wipe the electronic pad on the door pillar to ensure there is a good signal being sent.
Try cleaning the brass looking contacts on the door and the ones on the door jam.
How do you tell if water pump is leaking 2001 ford windstar?
Somewhere on the underside of the pump near where the shaft that the pulley is mounted on, there will be a small hole in the pump. This is called a weep hole and water will leak out of there slowly if you have a bad pump.
What cause a passenger window on a 2001 ford windstar not work?
Each door has it's own motor; replace it. It's more than likely a dealer's item or your local junk yard!
GranInOregon
Where is the pcm fuse located on a 2006 dodge ram 1500 with a 5.7 engine?
the pcm fuse on the 06 ram 1500 is #31
What are the lights called in the front bumper of a 1993 Ford Windstar van?
"Cornering" lights - as they only come on when the turn signal is active, which *usually* means you'll soon be turning the corner ;) See "Related Questions" below for more
Where can you find a vacuum diagram for a 1989 S-10 Blazer with a 4.3L V6 tbi?
if you go to your to local library and ask them for a service manual on your vehicle you can find it in there or there are places on the internet or you can ask your local gm dealer On most vehicles like this it is usually on a sticker on the fan shroud.
What is the spark plug gap on a 1987 Mercedes 190E 23?
Gaps are from .028" thou to 0.035" thou. Preference is for 0.028" thou.
Where can you find a diagram for the location of the coolant sensor for a 1986 300ZX?
The 300ZX Shop Manual has one page visual for all the components, the sensor located on the drivers side just to the right side of the Distributor. Its screwed into the block near the top of the block and has two fine wires coming out of the sensor.
How do you find oxygen sensor rear for 2003 windstar?
All O2 sensors are located on the exhaust. Follow the exhaust headers off the engine. There are two. There will be an o2 sensor sticking out of the pipe that is bolted to the header. It will be screwed into the pipe with a wire connector connected to it. There is also one possibly after the Catalytic converter. It just depends on the emission package. I assume by the "rear" you mean the o2 sensor in the back of the engine. Try jacking up the vehicle or if you are thin you can lay underneath the vehicle to spot the one in the back. That is the only way to get to it without taking the whole cowl section off the top of the engine. Hope that help.
Your car wont accept the freon?
Make sure your setting inside is on "max" or "recirculate". If so, and the compressor doesn't kick on, then disconnect the low pressure cut-off switch usually located on or near the accumulator canister. Use a paper clip or jumper wire to jump across the two terminals on the connector. This should kick the compressor on and pull in the freon. MAKE SURE YOUR HOSE AND CAN IS CONNECTED TO THE LOW SIDE CONNECTOR CLOSEST TO THE ACCUMULATOR!! Make sure your setting inside is on "max" or "recirculate". If so, and the compressor doesn't kick on, then disconnect the low pressure cut-off switch usually located on or near the accumulator canister. Use a paper clip or jumper wire to jump across the two terminals on the connector. This should kick the compressor on and pull in the freon. MAKE SURE YOUR HOSE AND CAN IS CONNECTED TO THE LOW SIDE CONNECTOR CLOSEST TO THE ACCUMULATOR!!
What is the spark plug gap on a 1994 LeBaron 6-cylinder?
Spark Plug Gap is .035, Torque then to 20 foot pounds.
It feel INSIDE the headlight housing? Yikes. Well, you're going to have to remove the whole housing assembly, and get that part out. It would be very dangerous to leave it in there. Use the other headlight as a reference to put it back where it belongs.
What causes the overdrive light to flash when going over 75 mph on a Ford Windstar SE?
on our van it was the vechicle variable speed sensor.
On mine it was the 1st sign of Transmission going out and $3000 repair
Yes there are 3 fuse boxes in the 2001 olds alero. One on the side of dash on drivers side and one on passenger side of dash by the doors..also one in the engine.....power windows should be in the drivers side fuse box..if not they are in the passenger side fuse..30amp i believe..
What are the spark plug gaps for 1.1L Fiesta MKII 95?
The 2007 NGK catalogue lists the 1.1 Fiesta plug gap as 1.00mm.
How do you set the clock on a Ford Windstar?
It appears there are a couple of the different radio 'head' units and stand-alone clocks in the various Windstar models, so the instructions would be different.
Best to reference your Owners Manual for the specific model in your vehicle.
If your manual isn't handy, see "Related Questions" below for finding an online copy for quick and easy reference.
with radio on,,,,hold down clock button and press seek - or + at the same time to set mins or hours
AnswerFor the radio unit that has the 6 CD changer built-in, press the "Menu" button to bring up the clock settingsWhere is the ecu on a 2002 ford windstar?
The 2002 Ford Windstar ECU can be found on the firewall in the engine compartment. The ECU will be on the drivers side of the firewall.
What is the proper spark plug gap for a 2001 Ford F-150 4.2 V6?
The Plug Gap for this Truck is .054 all new plugs come pregapped. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information. Most vehicles have a sticker just under the hood toward the front of the vehicle that has information which says the vehicle is in compliance with your state as far as that year's environmental quality goes. This sticker also has helpful information about your engine...ie size, displacement and spark plug gap. Another idea would be to visit the library and look into the repair manuals there or buy your own.
What does a flashing temperature warning light on a cold 1989 vw jetta indicate?
When mine flashes it means that the coolant level is low.
This Atlas LL8 inline 6 is notorious for noise when started cold in the older versions. Some help is achieved by using Mobil 1 5W-30 Synthetic oil. Do not use a heavier weight oil as that will compound the problem and may lead to early engine failure. There are many of these engines with over 200,000 km still running fine at this point in time. www.trailvoy.com is a forum dedicated to these types of vehicles. You can get realtime answers by the other owners on line.
How do you replace the pulley tensioner on a 1994 Chrysler lebaron?
If you are lucky like me you spray a lot of WD40 on the hub and use wrenches to work it back and forth until you feel the spring action. otherwise, good luck . use PB Buster it is better than WD 40 It is made for freeing rusted bolts and screws
What causes the speedometer on a 1998 Ford Wind-star to stop working when the transmission warms up?
We have a 98 and it seemed that sometimes it wouldn't shift right, and the speedometer would all of a sudden stop.I would drop it down to second gear and it would stop, and straighten out. Quiestion to you: Do you have a check engine light on? If so, take it to your nearest Auto Zone, have them do test on it. 9 times out of ten it will proboly say it's the speed sensor. Try that.
