0
Oldsmobile Aurora
The Oldsmobile was a mid-size 4-door luxury sports sedan produced by General Motors from 1994 to 2003. It was powered by a 4 cam 32 valve 4.0L V-8 engine and featured a 4-speed automatic transmission.
1,019 Questions
Where is the throttle body on a 1995 Oldsmobile Aurora?
It sets on top of the intake manifold and between the air snorkel. If you follow the air snorkel from the air filter box to the engine, you'll find a large hose clamp securing the snorkel to a cast metal part. That is the throttle body.
How do you repair the power windows on an Oldsmobile Aurora?
Change the breaker under rear seat next to battery. Also check to see if there are broken wires inside the boot between the driver door and car body. The boot can be pulled back off the door and slid a little into the body to see wires and repair if needed.
Where is the turn signal flasher located on a 1999 Oldsmobile Aurora?
Behind LH Side of I/P, Under Steering Column Brace, pn# 10041073
What is the possible solution to a mis-fire in the 7 cylinder on a 1998 Oldsmobile Aurora?
check for bent or burnt valve check for bent or burnt valve
I've been a gear-head (racer, collector, etc..)all my life and have never really known different fuels to cause a problem, other than pinging, on newer cars. Until now, that is. I had been running the lower octane fuel in the Aurora then decided to begin running premium. After the first two tanks there was a noticeable difference in performance, smoothness, etc. Also, the fuel mileage picked up almost 2mpg. This car is one that definitely needs premium fuel and I'll never put the lower octane stuff back in it.
Answerit will more than likely PING when accellerating under load.if you mix fuel grades it should be ok. i run reg. all the time.no problem.How long will it take to change a altinator on a 95 aurora Oldsmobile?
If all goes well, about 4 hours.
You will need to...
- remove plastic shroud from under engine compartment
- disconnect coolant lines
- remove rad only, not a/c as book says
- remove rad support to get it out, it just slides out
- remove serpentine belt
- remove a brace under engine compartment to let the alternator fall out
- remove alternator
That's about it. You do NOT need to remove the a/c lines and condenser as the manual says. If you remove only the rad and remove the brace from under the motor, you have tons of room to let the alt. fall out the bottom.
I did mine about 3 months ago. It took my father and I about 2.5 hours to do as everything went rather smoothly. If I remember correctly, I think you might also have to remove the oil filter as I think it was right near the alt.
It is not as involved as it looks in the shop manual. It is a little tight so expect to do quite a bit of "fingering" bolts out. I would suggest some cotton gloves dipped in rubber to grip them.
Where is the Low pressure air conditioner recharge valve for 2001 Oldsmobile aurora?
Against the firewall
How do you replace crankshaft position sensor on 01 3.5 aurora?
Not very hard. You have to take the starter out (or at least I did). I did the work from underneath the car. Take the battery cable loose. Remove the starter. The crank sensor is held in with one bolt. Take it out, clean everything off, put the new sensor in and plug it in. Make sure the sensor wires are tie-wrapped or otherwise strapped down so they don't vibrate over time and break. Re-install the starter. I have read that you should "calibrate" the sensor but you need a diagnostic connection to the computer to do it. I have not done this on my car and don't seem to have had any issues and it's been 10's of thousands of miles.
Where and how hard is it to chang a oil pump on a Oldsmobile delta 88 3.8 liter?
Oil pump is in the oil pan. You can change it in the car. It is alittle difficult!
Where is the multi-purpose switch for a 1995 olds aurora?
A multi-purpose switch is the blinker- high beam switch on the stearing coulm of the car.
How do you change a brake light in a 2002 Aurora?
You have to do it from inside the trunk. Remove the plastic screws that hold the cargo net in (they should just screw out). Then, pull the plastic trim that was under the plastic screws out to expose the studs that hold the tail lights in (there should be 2-3 studs). Remove any screws if there are any present and the entire taillight assembly should be loose enough to remove. Pull the assembly away from the car, be careful not to short out the cords, and remove the bulbs just like you would any bulb.
Aurora 1999 all blinkers going too fast?
1999 aurora all blinkers going too fast. then left blinker stops completely
Where is the starter in a 1998 Oldsmobile aurora?
under the intake manifold you have to remove the engine cover to get to it.
How does a air dam work on 1997 Oldsmobile aurora?
They all work the same way they direct on coming air up into the radiator for cooling
What is the firing order for a 1995 Oldsmobile Aurora V8?
Knowing the firing order of a cars engine will help diagnose problems later. The firing order of a 1995 Oldsmobile Aurora V8 is 1-2-7-3-4-6-8.
What could cause the rear wheel of an Oldsmobile Aurora to bounce?
the answer is you just don't do that. and if you did. you must of hit a horse. because otherwise. the wheel wouldn't bounce. only everyone in the world knows that.
Fuel tank pressure sensor location?
The fuel tank pressure sensor is located at the top of the fuel tank. The fuel sensor is best seen when the tank is removed and made to face down.
Where is the fuel filter located on a 1999 Oldsmobile aurora?
These sensors are located above the oil filter mounting bracket. You will need to drain engine oil. Use 10mm socket with extension to remove the oil filter mounting bracket. Then, use a 10mm socket to remove the bottom CPS, the upper one is more complicated due to AC line is on the way, gently, pull down on the ac line and remove the upper CPS. Be very patient because depending on how clean your car is, stuff falls in your face, wear clear goggles. Remember, this vehicle uses two CPS, so replace both, but if you only have one sensor on hand, replace the upper one first and use the best of the twos, for the bottom. Good luck..!
Heated seats not working in Oldsmobile silhouette?
A very common cause for heated seats not working is that the heater element has burned out on either the cushion heater element or the seat back element. The way the system is wired, if one goes bad, neither will work.- techJK ----------------------------------------------------------
Has anyone ever heard of a 1998 Oldsmobile aurora breaking spark plugs and causing a misfire?
9/26/06 Never heard of that but I do know for a fact that year and motor had a problem with the head and gaskets letting coolant into cylinder wall causing misfire could also be seizing your plug and breaking during removal hope this helps you
