0
Pontiac Grand Am
The Pontiac Grand Am is a mid-size car manufactured by General Motors’ Pontiac division. Available as a 2-door coupe/4-door sedan, this model was produced in five generations. The fourth and fifth generation models belong to the compact car class.
2,070 Questions
How do you replace the fuel pump on a 2000 Pontiac grand am?
Drain the fuel tank and then remove it from the vehicle. This will give you access to the fuel pump.
The security light is flashing on 1996 Pontiac grand am causing staring problem?
I thought I had the same problem with my grand am, and it turned out that I needed to go to the dealer and have the transmission fluid flushed, and changed. It seem this is not someone a car owner can do unless they have a way to pick the front end up to let the ait out of it. I had to do it around 80,000 miles
How to change the front brakes on a Pontiac sunfire GT 2000?
If you go to advance auto, or auto zone and purchase a haynes manual for 10 to 20 dollars, it will describe in detail (including pictures) of this repair, and many more for this automobile.
Where is the water pump located on a 1989 Chevrolet Corsica V6?
The water pump is located behind the water pump pulley. The water pump pulley is the smooth pulley at the top closest to the front of the car. It is held in place by 4 bolts with 8mm heads. The pump is held in place with 5 bolts. Warm the engine to operating temperature before removing the bolts or they may break off causing you greif.
Where is the crank shaft sensor located in a 2001 Pontiac Grand Prix?
most likely behind the plate covering the timing gears, at the front of the engine.
Just had the same problem on my Grand Am. It was the water pump.
Where is the EGR valve located in a 97' grand am se?
1. Open the hood. 2. Find the intake/exhaust manifold. On the top front of the motor. 3. Look on the right side of the manifold. It is the round thing, about 1-3/4" diameter and about 2" front to rear. Housing is metal, semi bright. 4. It is attached with two safety bolts (5 point if I remember correctly) internal. Easy to get to and easy to remove.
How do you remove the window handle on a 1998 Pontiac Sunfire?
there is a clip on the back side of handle u will need a special tool for that just go to a local automotive shop im sure they will pop it off for u and u can just put the clip back on the handle and push it on ur self when ur done
Where is the fuel pump relay located on a 1992 Pontiac Grand Am?
There will be 3 relays grouped together on the passenger side of the car. Usually back by the firewall and bolted to the inner fender. One of these will be the fuel pump relay...but I don't remember which relay it is.
2002 grand am has P0300 code but misfires on only cylinder 4?
What is happening there is that the computer may not be able to detect the misfire in the electrical system, but is finding too much raw fuel downstream in the catalytic converters that tells it that the fuel is not burning completely, thus a misfire. Could indicate that the problem is mechanical not electrical.
Where is the thermostat on a 2004 Pontiac grand am 3.4L V6?
under the throttle body behind the exhaust pipe on the driver side of the motor nothin but net
the heater core will need to be replaced with a new one. go buy a book and plan on spending a complete saterday on it.
Where is the coolant bleeder valve on a 1998 Pontiac Grand Am?
looks like there is a coolant bleed valve on top of the water pump casting on top of a 2 inch high PC of metal tubing one small needle valve with a 6mm hex nut
What way does the spring go on a thermostat for a 1996 grand am 2.4?
Should go in the engine end Should go in the engine end
Where is the location of the automatic transmission dipstick for a 2004 Pontiac Grand Am SE?
It doesn't have a transmission dipstick. The fluid level is checked by removing a plug from the transmission housing from under the vehicle. It is best done with vehicle up on a lift and level.
How could you remove a firebird engine in a 3.8 liter 1997?
go to the public library they have a ton of service manuals there i currently have 1 from the library. tells you every step for the 3.4, 3.8 and 5.7 so if ur looking to do a 350 swap just follow the remove for the 3.8 and the install (with some adjustments, like add different mounting brackets and tranny cuz i dont think they match up)
What is the price for an ignition switch for a 2001 Pontiac Gram Am?
the Grand Am ignition switch also houses the anti-theft sensor for the "security" light. the switch sensor in my 2000 GA went out a couple of years ago, and it cost a bit over $400 to have it replaced. i'd imagine the 2001 would be about the same.
How do you replace the ignition on a 2003 Pontiac Grand Am?
If it's 2.3 2.4 quad-4, for most-Take off alum. cover on top of engine. Lift straight up-the "boat" housing will be attached to the underside containing the coil packs. Pay attention to how everything goes together. The boots are clipped on to the "boat" & push straight down onto your plugs. The biggest trouble with these ignition systems is the boat housing causes the ignition to arc all over the place. it is called that because when inverted looks like it has smokestacks. Replace that before you buy anything else. 9 times out of 10, that's all it needs.
Where is the water pump located on a 1993 Cadillac Seville V8?
Loosen and remove the bolts in a crisscross pattern from the center outward. Insert a rag into the block opening and scrape off any remains of the old gasket.
WARNING When working on the coolant system (for example, replacing the water pump or thermostat), a certain amount of coolant will spill on the floor. The antifreeze in the coolant causes it to be very slippery. Always immediately wipe up any coolant that spills to reduce or eliminate the chance of injury.
When replacing a water pump, always follow the procedures recommended by the manufacturer. Most often a coating of good waterproof sealer should be applied to a new gasket before it is placed into position on the water pump. Coat the other side of the gasket with sealer, and position the pump against the engine block until it is properly seated. Install the mounting bolts and tighten them evenly in a staggered sequence to the torque specifications with a torque wrench. Careless tightening could cause the pump housing to crack. Check the pump to make sure it rotates freely. The water pumps on many late-model OHC engines are driven by the engine's timing belt. When replacing the water pump on these engines, always replace the timing belt. Make sure all pulleys and gears are aligned according to specifications when installing the belt.
Why does your 2000 impala not crank after your security light comes on?
passlock has been activated you have to turn the key to the on position for 10 minutes for the computer to reset but it may take up to thirty minutes or longer to crank sometimes.
Where is the fuse for a sending unit on a grand am?
there is no fuse for the fuel sending unit. its a called a fuel pump relay and its located under the hood o the drivers side in a black box that says fusees.
Where is the crank sensor 2001 grand am 2.4L?
It's located just above the oil filter on the front of the motor.
