down the dash diver side is the fuse box for a 1997 Honda civic DX
if you have a upgraded stereo sometimes they will not hook the old one back up and it cases the indoor light to not work idk about the dash board
How do you fix a squeaky odometer in your 1996 Geo Tracker?
Unfortunately... you may have to either find another from a junkyard, if they will sell it. Or have the dealership replace it. I have had mine buzz for 2 years now, being too lazy to take care of it. Last month I had the spedometer spin like a propeller and take out the gas gage. Today, the odometer stopped working. Takeing off the panels and removing the instrument panel is easy. Getting the Spedometer cable reattached is difficult. Probably have to remove most of the dash just to get my hands in there.. I've had the problem and it's especially when it's cold. I removed the instrument panel and the harness, removing the speedo cable isn't easy but if you remove the cable from underneath first, you'll be able to have enough to get ample cable up from the back, of course the grommet will proably come out from the firewall but that goes in easily especially if you spray it with PAM. After I had the instrument panel off, I lubed the inside of the cable connection on the back of the speedo and put everything back together. I used a lightweight grease that will stand up under use and heat. My speedo is now quiet. You need to be real careful when removing the cable as you can break the plastic end if you're not careful then you ned a new cable. OEM is about $100. but I've also seen aftermarket for about $20. Just have a warm day and if you haven't taken the panel off before, I heartily suggest a book and at the least patience. You can get scraped hands doing this but it's worth it. Take care and good luck. Steve H. If your not in the mood to do all that,,, who would be,,, simply remove the front left speaker, reach your hand down inside, feel the cable, about 6 inches down, round and firm, move it up or down, then drive it and see, I did it like he did, the hard way, and it didnt do anything, a few days later I remembered it was pretty close to the speaker, and decided to try again before it drove me nuts, pulled of the speaker, pushed down hard on the cable until it felt like it caught and stayed put, got in, drove, and a year later it's running fine
Sounds as though it could be a few areas to look at, 1. check that it is not the bulbs, (access through rear plastic compartments inside car). 2. check that the fuse for reverse tail lights is not blown (front fuse panel next to accelerator pedal)and 3. try to remove the cover plate or sleeve around gear stick as there is a small switch that activates lights when put into reverse (may have dislogded the wiring). Hope this helps.
The end of steering wheel is known as a track rod end. It connects the shock/ brake and drivershaft knuckle with the help of a small ball joint.
When should you change the cam-belt on a lupo?
On the one litre models it should be checked at 40,000 miles and changed at 60,000 miles or four years. Which ever comes sooner.
this link is prettyh usefull http://www.vwwatercooled.org.au/newforum/upload/showthread.php?t=24357
Congratulations - you have a short in the electronic locking mechanism. Probably also causing your interior lights to stay on and problems with the alarm? Good luck - my VW dealer in Richmond, VA took three tries to get this repair right, but then again they are morons.
AnswerI just received a new latch and am going to see if that fixes things. My alarm doesn't give the 'armed' sound if the deck isnt' latched but my interior lights are not stuck on (at least). AnswerHey, let me in on this one! I have an 2001.5 GLX with the same issue. I am starting to hear that beep in my dreams now! Add in the fog lights that decided to stop working, the high price of gas and now the trunk! But I still love it regardless, so has anyone had any luck with fixing this? Thanks! AnswerHi. I had this thing driving me insane as well. I found on mine that it was the rear load cover that was not allowing the door to shut and grab the second stage of the locking catch. With the load cover still in place, but turning the handle-flap down towards the floor, it now shuts properly (with a nice clunk sound) and the alarm doesn't go off at all. Hope this helps... AnswerHere's how I fixed mine:This sounds more complicated than it really is. Toughest part was finding a small enough rubber-band :-).
Where do you find the wiper wash relay on a polo?
Hi, In my 1999 Polo it is in the gloves box under the steering wheel. You can open then take down its door by pulling it upwards and behind that you can find all the relays. As I remember number 9 is the wiper's one.
What does exhaust gas warning lamp mean ona2003 polo?
why does the exhaust gas warning lamp symbol come up on the dash board
How do you reset service inspection on 58 polo?
switch on ignition lights by turning key. press kilo reset button and hold in whilst starting car. service inspection will flicker. release kilo button and switch off the car and it will be reset.
How do you turn on the spot lights fog lights on a 2002 volkswagen polo?
You should turn the lights on, (should be a nob thing that you turn) just give it a pull and it should slide bank and your spots should be on. One more light pull the fog light will go on.
Where is the outside temp sensor located in polo 16V 2003?
on most cars the sensor is located behind the front bumper
its the warning light for the brake system
On the 1987 Honda Accord DX I recently acquired I believe all 3 of those things are controlled by the ICU (Integrated Control Unit), under the dash above the hump. It has one connector plugged into it. Maybe yours has a similar unit that is unplugged.
On my Honda accord there is a seat belt control box that is under then passenger seat. Mine was unplugged and cut all power to seat belt alarms and power seat belts
How do you open polo 1.4i manually?
put the key in the drivers door lock and turn it clockwise. You will need to start the engine within a few seconds or the alarm will go off.
I'm not a mechanic, but if this is a 4.0 L SOHC V6 engine, they have 3 timing chains. A main timing chain from the crankshaft to a "jackshaft" which is located where the camshaft is on the 4.0 L OHV engine. A 2nd timing chain from the jackshaft to the driver's side cylinder head at the front of the engine, and a 3rd timing chain from the jackshaft to the passenger side cylinder head at the back of the engine. When you said you have no compression on one side, I wonder if something has happened to one of your secondary timing chains ?
How long should hold the injector in place at the injection site?
whats the injection??? I believe they are talking about first aid for nerve gas exposure, in which case the injector should stay in place for 5 seconds and immediately followed by the 2 pam chloride
The end of a hat is called something that starts with T. This can sometimes fall of? Can someone please find the answer and put it in the comment i so really need to know. The people who have helped me out thank-you ever so much. I really need to know and i need some help. Thank-you again the people who helped me. Best wishes Love.........????? The end of a hat is called something that starts with T. This can sometimes fall of? Can someone please find the answer and put it in the comment i so really need to know. The people who have helped me out thank-you ever so much. I really need to know and i need some help. Thank-you again the people who helped me. Best wishes Love.........?????
Polo playa 2001 where is resistor for fan speed?
in the bottom of the fan housing located on the passenger side footwell.