Chevrolet

If the cable connections are clean and tight, the battery puts out less than 12.3 volts fully charged, will not stay charged, has been run down more than once, or is over 4 years old it is probably bad. Remove the battery and have it tested at an Auto Parts Store.

A bad solenoid is likely the reason why your 1994 Chevrolet S10 Blazer won't shift into 1st or 4th gear. Getting it replaced should fix the issue.

At least 4 quarts. Park on a level surface. Drain the oil, remove and replace the filter. Add 4 quarts. Start the engine and let it run for 1 minute. Shut it off and wait 45 minutes. Check the level and add until full. You now know the answer. My guess would be 4.5 quarts, but it could be 5 quarts. Do not overfill!!!

The crank position sensor (for the Chevy Tahoe/Suburban/GMC Yukon/Full size trucks) is located near the back of the engine block, on the passenger side. Near the starter. Note - the crank sensor (as well as the cam sensor) can occasionally leak oil and drip down, making it appear to be a rear main seal leak. If you have a leak at the bell housing, don't automatically assume a rear main leak.

right behind the distributor cap and in front of the firewall if you climb uder and look up you can see it

It is up inside of the drivers side frame rail just behind the cab. You will have to lay up under the truck and look up in the frame to see it.

Yes but theres only a few that will do it. Most dealers don't

.

The 2008 Chevrolet Tahoe has a 4.8 L base engine size.

GM #12345982 is an active part number as of September 2014. It is a special lubricant used for servicing supercharger units.

You can find a Vacuum hoses diagram for gm diesel 6.5 at any department stor. They can be found at Sears or auto motor store. They are also available on Ebay for a bid.

On the passenger side front facing the door...insert two fingers into the handle and pull outward. The fuse diagram is located on the inside on the panel.

on a assembly line

Fine, but Chevys are made all around the world, in the US in Detroit, but there are GM plants in Australia, Brazil, Korea, and several other countries, some make parts, and others make complete cars.

Regards

6.0L

18436572

i have a 1967 chevy c10 truck. i want to know what 5 or 6 speed manual transmission will bolt up to the original 327?

The sensible thing would be to remove the wheel and look . Test some wrenches on it, see what works. -After all you are changing or repairing the most important part of your car. Why take someone else's opinion .

For 2.2L Ecotec tighten the oil pan drain plug to 25 N·m (18 lb ft). The oil filter cap is also tightened to the same spec.

Generally speaking, it should not get any hotter than the normal operating temperature of your engine coolant.

Could be a bad plug wire,spark plug,coil. Really need to know what your working on and the engine size.

.035 or you can go .045 depends on the engine setup but .045 is a safe gap.

Using the Chilton manual for the 1994 Chevy Silberado 2500 would be the best way to know how to do this. It provides detailed instructions along with pictures to insure it is done properly.

19 US Gallons

4 to 6 degrees advanced, or BTDC.

NEW ANSWER: You cannot use a timing light on that year engine, It requires an engine scanner to set the timing. The timing is computer controlled. The scanner will allow your to set the crankshaft and cam shaft correlation and then the computer will take it from there.

The above answer is correct for the early modal 5.7L 350.

On valley cover plate underneath intake manifold. Must remove intake manifold to get to them.

No. The 327, is a small block.