0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
Replace thermostat on 1988 Corvette?
Drain the water from your 1988 Chevy Corvette cooling system. Remove the water supply hose from the top of your thermostat housing. Remove the thermostat housing bolts. Remove the thermostat. Reverse the process to install the new thermostat.
How do you adjust the emergency or parking break on a 2006 Kia Spectra?
You can adjust your parking brake by turning the parking brake adjustment bolt. The parking brake adjustment bolt is located on the parking brake pad assembly.
How do you remove the front license plate cover on a 2001 Aurora?
== == == == you don't it's molded int to the bumper.
What is the 1963 Corvette top speed?
The 1963 Corvette has a top speed of 229 miles per hour. This model car has a 360-hp fuel-injected 327 V engine.
IN what year was the first Corvette made?
The first corvette was made by Harley Earl in 1927
The first production year was 1953
How many Corvettes have been made since it started in 1953?
According to a National Geographic show I watched on September 24 2009, there has been about 1.4 million made. A 2003 blog reported aver a million. It doesn't seem like a lot.
Where is the oil filter located on a 1994 Corvette?
The Oil filter on a 1994 Corvette 350 LT1 is right under the Drivers sitting area almost. It is hidden between the driveshaft and the Catalytic Converter. It is hard to find, unless you are under the Vette. >^..^
Where is the map sensor on a 92 Corvette?
On top of the intake manifold, front RH side just behind the throttle body. Small thin black rectangle that attaches with 2 bolts from the top. Has a green connector that plugs in the bottom from the side of the intake.
How do you remove a dash from a 1976 Corvette?
The dash is held together by screws. Just take out all the screws in the dash, and also the ones in the pads on the window pillars on the side of the dash. You'll need to remove these to get the dash out. You can still get the dash out without removing the pillars, but you may damage your dash trying to squeeze it out.
Because of the one eyed one horned smilin purple people eater BARNEY =((( Because of the one eyed one horned smilin purple people eater BARNEY =(((
How Dim lights on 1994 Corvette?
PULL THE TURN SIGNAL LEVER TOWARD THE DRIVER. THAT CHANGES FROM LOW TO HIGH BEAM
What temperature should your 1985 corvette run at?
the cooling fan comes on at 230 and normal engine temperature is usually around 218 depending on the outside temp.
Where is the fuse panel on a 1994 corvette?
you have a main fuse panel on the right side of the dash,passenger side.Open the passenger side door and you can see it,there are also fuses located under the hood behind the battery
How do you remove the window crank in a 1979 corvette?
They sell a window crank removal tool to open the cotter in and slide off the winow crank handle. Slide the tool under the window handle and push the cotter pin back, off comes the handle
How do you replace Corvette c5 battery?
just like any other battery nothing special disconnect the terminals, remove the battery and put new one in
2 solutions; quickest and easiest is to pull the fuse; the more complicated is removing the side panel or the panel that covers the antenna and disconnecting the power source that connects to the antenna motor. This worked for an Oldsmobile Delta 88. I would think it should work for most cars.
How to change drivers window motor on 1995 corvette?
The motor is attached to the window actuator and must be installed as a unit. there are several parts houses that carry the part. It seems that you are a bit of a back yard mechanic who hasn't really had an opportunity to get to really know your car. With the door panels costing over $400.00 dollars to replace if you mess one up, I suggest you take your vette to a trusted mechanic to do the work.
How do you remove a front door speaker grill on a 1998 Chevy Corvette?
First remove the trim from around the handle. Use a flat blade screwdriver for this. The pop the small plastic peice from behind the grab handle. There are two Torx screws there. Then you will need to POP the plastic retainers loose that hold the panel to the door itself. They make a loud snap noise but don't be scared they usually don't break. Then once the panel is loose disconnect the wire for your switches from the back side of the panel. The speaker itself has about six 7mm head screws holding it in place. Dave
What could cause the dash cluster not to work except for the gas gauge in a 87 corvette?
led lights inside cluster
92 Mercedes 190E Heater blows hot all the time help?
Its your heater valve, its not closing therefore its letting coolant go Thur the heater core. Good news cheap fix,1 hour of labor and 20 bucks for the part. If your going to do it s easy located between the 2 firewalls ,!st remove mesh , 2nd windshield wiper then wiper motor ,3rd blower motor casing then motor. You'll see the valve. sound like alot of work but its not. The only thing that's not simply skews and bolts is the blower mount there clips.
