0
Chevy Impala
Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.
4,997 Questions
How do you remove a door panel on a 1997 Honda Accord?
FISRT START WITH THE DOOR HANDLE ( THERE SHOULD BE A METAL ROD WHICH OPENS THE SOOR AND A THE PLUG BEHIND THE HANDLE IF YOU GOT POWER WINDOWS) THE TAKE OFF THE PLASTIC PIECE COVERING THE OUTSIDE MIRROR(LETS SAY YOUR DOING THE DIVER SIDE IT WILL BE LOCATED ON THE TOP RIGHT OF THE DOOR IT JUST PULLS OFF) THEN FIND A SPOT WHERE YOU CAN FIT YOUR FINGERS ON THE BACK PART OF THE DOOR PANEL AND PULL. THE AREA YOU ARE PULLING SHOULD POP UP THEN RUN YOU FINGERS FURTHER DOWN UNTIL YOU GET ALL AROUND THE DOOR PANEL. JOSE
What is the difference between a 350 and a 327?
How can I identify if my engine is a 350 or 327?
Engine block casting # 3970010
Vin stamped code 18l611487
thnaks,
Julio Zamago
3970010 shows up on both 1968 327's and 1969-79 350's
could be either originally.
without disassembly no way to really know for sure.
There is actually no actual measurment you will have to measure it for yourself to fin out
fuel pump probably, common problem among later model impalas
How do you program a keyless remote for a 2007 Chevrolet impala?
on a 2006 impala it has step by step instruction, it all has to be done through your radio
On my 2008 LT the info is on page 3-48 of the "Owner's Manual" & is done thru
the Vehicle Information button...
engine has 2 bleeders intended for filling cooling system only! they are not to be opened while engine is running or hot. the best method I've found for filling the cooling system on these is as follows:
open the lowest bleeder first (the 1 near the throttle body).
remove the radiator cap, fill very slowly until coolant flows out of bleeder, close the bleeder and don't touch it again. next instead of opening the other bleeder (the one near the bypass hose at front right of engine), disconnect the bypass hose and insert a funnel into the hose, fill at hose until coolant comes out of the radiator fill and install the radiator cap and do not remove it again, next continue to fill at hose until coolant comes out of pipe which you disconnected hose from. at this point your cooling system is completely full. reconnect the bypass hose and don't touch anymore bleeders, you're done. make sure there is enough coolant in the overflow bottle. Again, this is all done with a cool non running engine. after cooling system is properly filled if you still have an overheating problem look somewhere else, it's not because there's air in the system. i have shown technicians this filling procedure it works well.
I am another reader who had this problem...greatest advise that i had read...and it worked....thank you for this.
What is the normal Oil Pressure Reading For 1963 Chevrolet Impala?
7-10 pounds at idle when at operating temperature. When at 2,000 RPM it will be 30-45 pounds.
What causes Rattle in steering column on rough areas slow speed.?
poor GM engineering! All these impalas do this at some point, most within a year! You can ignore it! The dealership has a lubrication bandaid but it is expensive and does not last long. It treats the symptom, it is not a cure to the root problem that has no real solution!!!
Where is the best place to purchase new clusters for a 2004 Chevrolet Impala for a reasonable price?
Not being a repair shop will make it very hard to purchase them. You can get remanfactured ones from the dealer.
How do you remove dash in 2003 suburban?
The dash board in any car is usually unscrewed. You will need a power tool.
How do you change the wipers on a 2007 Impala?
The 2007 Chevrolet Impala has hook-end wiper arms. See the Sources and Related Links section below for installation videos and correct attachment/length wiper blade sizes. Also, if you purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through. Very simple.
How do you take a driver seat out of an impala?
On newer models, you have to move the seat all the way forward, remove side trim cover, remove seat belt anchor bolt, remove seat rails retaining bolts, tilt seat upward, disconnect wires, remove seat...
What offset is needed to clear 18 and 20 inch wheels on a 1960 impala?
Zero offset. I have a 1960 impala with 20x8.5 on the rear with 245/35/20's and the front are 18x8 with 245/40/18
If the car is lowered you will need to drop the shock mount to let the diff drop down to be able to get the wheel under the arch if doing it on the ground.
"http://wiki.answers.com/Q/Service_Traction_System_light_comes_on_when_you_turn_the_wheel_to_the_right_is_there_a_wire_that_may_be_pinched_on_your_2002_buick_rendevous"
