0
Chevy Prizm
Chevy Prizm is an entry-level compact car manufactured by New United Motor Manufacturing, Inc., a joint venture plant between General Motors and Toyota in Fremont, California. It replaced Chevrolet Nova and was a rebadged model of Toyota Corolla.
641 Questions
How do you fix an oxygen sensor?
Unfortunately there is no fixing an O2 sensor. If the "check engine" light is on due to an O2 sensor, it can only be remedied by replacing the bad sensor.
What is the spark plug gap for a 2000 Chevy Prizm?
Normally 0.044" - make sure it's not the type of plug you can't gap
You need instructions on how to replace the headlight bulb on a 1994 F150 pickup year 1994?
Check out the enclosed instruction book.
Can you tell the year an engine came out of from the engne block casting number for a geo?
Yes, you can. count to the 10th digit. If it's a number than that the year of the car. For example 10th digit is 1, then it's a 2001 and so on. If it's a letter like T then it's a 1996. Call the any salvage yards and give them the letter of 10 th digit. They will tell you what year is it.
Whats the value and year made of a Revelation 16 gauge Model 350A?
Your model 350A was made by Mossberg for Montgomery Wards.The Mossberg model 350A was made from 1960-1968.The value will range between 40-160 dollars depending on overall condition and a good bore.
How do you change the oxygen sensor on a 2001 Chevy Prizm?
Depending on which one you are trying to replace it is pretty simple. There are two O2 sensoners loctaed on the exhast. One is right at the manifold and the other is behnd the CAT. Disconnect the battery for the car and unplug the O2 sensor. I believe the wrench size is a 20mm or maybe a 20mm just make sure it fits right you don't wnt to strip the nut.. It may need to be heated up with a propane torch to make it easy to take of. For the one behind the CAT you have to cut the wires and splice the new O2 sensor wires together or take out the center consol of the inside the conector for the rear o2 sensor is locatedd here. You will need to fish the wire out from the bottom... Same process though to take it off too.
There is a special slotted socket for oxygen sensors. It is not recommended to cut any wires as moisture can get in and cause corrision.jd
How do you replace a blower motor resistor pack on a 1999 prizm?
easy fix. 2 screws 1 wire connector. passanger side look straight up from floor unscrew it remove wire connector pull out and replace it took me about 5 minuits easy access
What is the engine oil capacity for a 2000 Chevrolet Prism?
Oil capacity with oil and filter change is 3.7 liters (3.9 quarts). Oil capacity with oil change only is 3.5 liters (3.7 quarts) Recheck oil level after filling. A little over or a little under is okay. Specification 2000 Chevrolet Prizm 4-door sedan Wheelbase, in. 97.1 Overall Length, in. 174.2 Overall Width, in. 66.7 Overall Height, in. 53.7 Curb Weight, lbs. 2403 Cargo Volume, cu. ft. 12.1 Standard Payload, lbs. -- Fuel Capacity, gals. 13.2 Seating Capacity 5 Front Head Room, in. 39.3 Max. Front Leg Room, in. 42.5 Rear Head Room, in. 36.9 Max. Rear Leg Room, in. 33.2 Specifications Key: NA = not available; "--" = measurement does not exist.
Enginesdohc I4 Size, liters/cu. in. 1.8 /110 Horsepower @ rpm. 125 @ 5600 Torque (lb-ft) @ rpm. 125 @ 4000 Availability Standard EPA City / highway mpg 5-speed manual 31/37 3-speed automatic 28/33
I have a very similar problem. The latch the holds the hood closed sticks and actually the lever inside the car sticks in the open position as well.. To fix it, i just take a screw driver and pop the lever near the hood back into place. Up to this point any lubrication has not worked to have the lever run smoothly without getting stuck.
Where is the low side port on 2000 Chevy Prizm?
open the hood stand beside the passenger wheel look down to the left at the firewall there ar two metal tubes with brass nuts coming out from the wall the one on the left is the low side line if you follow it you will find the port it has a black cap on it
How many quarts of oil does a 1999 Chevy Prizm hold?
Park on level surface. Drain oil and change filter. Add 4 quarts of the correct weight oil and then start engine and let run for 1 minute. Shut off and wait 30 minutes. Check oil level and add as necessary to reach the full mark. You now know the capacity.
How do you replace the cigarette lighter in a 1998 Chevy Prizm?
Remove the retaining ring at the top of your 1998 Chevy cigarette lighter. Slide the cigarette lighter out and remove the wiring harness. Reverse the process to install the new cigarette lighter.
Its the lifters one of them are collasped its an easy fix if you know engines otherwise it will cost about 400 dollars from a mechanic A lifter makes a tick. If it is knocking loudly, then my money is on a spun rod bearing, also known as rod knock. I would also be willing to bet your oil is way too low, since oil starvation is the quickest way to ruin your engine bearings. The motor will probably be quicker and cheaper to replace with a good used one than to rebuild. If you keep driving the car, it will "sling the rod" through the aluminum engine block, sieze up, and leave you stranded somewhere.
How do you change air filter in a 2003 Chevrolet trailblazer?
Pop the hood. your airbox is on the passenger side. it is the big black box in the front. there should be 3 Philips head screws on it. one at the top in the middle, one on the right towards the bottom, and one on the left towards the bottom. loosen all of those and then pull up and kind of to the right on the top of the box. it should come off and your air filter is the round thing in there. pull it off the hose and push your new one on.. make sure the intake hose snaps back down into the box when you put the new one in. then push the top of the box back onto the bottom half. make sure all of the screws line up with the tabs before trying to screw them in!.. if you don't, you will have twice the work on your hands!
Can you disable front passenger airbag in 1998 Chevy Prism for a booster seat?
It is illegal to do so. Put the child in the back seat where they are much safer.
How do you adjust the clutch on a 1995 Geo Prizm?
Just find the cable on the transmission and look at it. The adjusting nut is where it connects to the tranny. You'll have to figure out which way to turn it for yourself.
How do you adjust a parking brake on a 2002 Chevrolet trailblazer?
gm sais to pull up the hand brake cover next to the seat, pull up on the hand brake, finger the micro adjuster trigger...HOWEVER. i don't think that does squat.
you'll need to pull the rear wheel, remove 4 bolts to remove the calipers, pull off the rotor, and you'll now see the drum contraption.
use a tooth brush to brush away the rust powder, just for the fun of it...and turn the 1/2" dial until the shoe ring begins to spread.
the reason for the problem is that the steel cable stretches. bicycles have the same problem with the brakes and gears. at least they have an expanstion adjuster that is easy to access.
GM doesn't build for the DIY. they build to getitout and provide for their dealer who make big bucks on stupid fixes that DIY should be doing.
CAN ANYONE SAY....foriegn ownership of this country ??? a few execs will make money, but every one else will be exporting American labor to foreign cartels; because the local philosophy is getitout and provide a racket for our partners.
When was the Lester Piano last made?
the lester piano was first made when the democratic bethovan came back to write a sonatas and he had Bac and everybody.
Why does your 1998 Chevrolet prizm sputterhesitate when you push the gas?
I would start with the spark plugs. If they've never been replaced, they're over due.
