0
Ford Escape XLT
The Ford Escape XLT is an all wheel drive, compact crossover sport utility vehicle (SUV) produced by the American automaker Ford Motor Company. This vehicle may be powered by a 3.0 L V6 flex-fuel or 2.5 L 4-cylinder engines.
2,580 Questions
How do you replace LH headlight whole assembly not a bulb on 2003 Ford Escape XLT?
If it is anything like my 2001 Ford Escape XLT you have to remove the bumper. or at least loosen enough to get to the headlight straps. My husband and I just changed the bumper, grille, and drivers fog and headlight assemblies (we hit a deer and deductible was to high). Our headlight had four bolts holding it in and 2 electrical plugs. Simple job when the bumper is off. The bumper has two bolts right under the hood, seven underneath, two snaps under the license plate, three in each wheel well and one where the bumper meets the fender (kind of a bugger to get at this one but we did it). It took us about 4 hours. We aren't mechanics but have done a few small projects before.
Why is my interior light not work on your 2002 f-150 you change the fuse bulb and relay?
could be the door switches...or bad connections behind the light socket etc... ...everyone should have a manual for their vehicle(parts store or dealer), and a local library should have professional shop manuals available in the REFERENCE section for free...make copies of the appropriate sections...read up and good luck :)
How much would it cost to replace abs sensor on a ford puma?
£99.50 FROM FORD HAVING ONE FITTED TUESDAY
What is oil scraper rings in any engine?
oil scraper rings are the rings on the pistons that scrape the excess oil off the cylander walls on the down stroke of each piston. this is done to remove excess oil from the combustion chamber in normal operation of an engine if this was not done you would always burn oil and forever be topping up oil in engine
Torque specs for 1999 expedition tie rod ends?
Tie rod jam nut & Tie-rod end-to-steering knuckle nuts Engine 57-76 ft. lbs. -------------------------------------------------- Metric 77-103 Nm
How to replace shift lever Ford Escape 2001?
First loosen and lower the tilt thing for the steering wheel column so the column is down as far down as you can get it. Then, lower the shift lever to...?...runs out to cold garage to check...1...the lowest range. Remove the two screws in the dark panel or cowl above the cluster, then remove that finish panel. Now, there are 4 screws to remove the cluster (!) itself. Two are at the outside top corners (yeah, I know it's round there, but look...you'll find them. The other two are below the cluster (imagine!) with one just to the right edge of the speedo (no, not your speedo underwear...the trucks speedometer!) and the other to the left edge of the tach. Again, you'll see if you look that these are mounting screws.
WARNING DO NOT DISCONNECT THE ELECTRICAL STUFF BEHIND THE CLUSTER !!!! WARNING...BLINKING TEXT HERE....
It requires special equipment to reconfigure it to match the vehicle. It's electronic...like everything else these days, eh?
Ok...find the right (correct) bulb and replace it...I have no idea what the bulb type or brand is...hopefully you'll find one at your local independent parts store that is the same. Ford wants you to have the dealer replace it and that would be pretty expesive for a silly light bulb...I'd guess you could buy the bulb there if you couldn't find it else where.
Ok...then put it back together....after you check to see the darn thing works...eh?
Good writeup - but have no fear unplugging the panel, it is not affected at all by removal as inputs come from elsewhere - save your knuckles this way
What is the maximum towing capacity of the 2012 Ford Escape?
The maximum tosing capacity of the 2012 Ford Escape is 1500 lbs..
What is the maximum cargo capacity of the 2011 Ford Escape?
The maximum cargo capacity of the 2011 Ford Escape is 67.1 cu.ft..
What year is the gtp, if 95 or newer yes, if gtp is in the 80's then no due to pollution restrictions today, and may have to change the computers from each vehicle. Each computer is set to specs for the engine it controls.
On 1998 GMC 350 Sierra K1500 Idles rough but runs great otherwise Any suggestions?
I'd start with a basic tuneup if it has not been done in awhile. Then I'd clean the fuel injectors.
That depends on your level of competence. It's not difficult, in fact it's one of he most simple jobs. You do, however, need to really look closley at the routing of the serpentine belt and make sure you make a drawing. That's the most common problem. To replace the serp belt, just back off the tensioner, pull the old belt off then put the new one back in it's place.
What are signs of oil sluge in a car engine?
one sing can says a lot: check in your oil cap, if you find some oil sludge, its a big revelation that you have oil sludge problem in the engine
Is there a sensor in the 2002 Ford Escape that has to be reset when the oil is changed?
Yes - there is a reset for the oil change. The and "INFO" button and a "SET" button. I can't remember the exact sequence right now. I think you keep pushing the Info button until it says something about oil change reset, then push the Set button. It always takes me a couple of minutes to find the combination:-)
Will tire chain size 235 60R16 work on 235 65r16 tire?
I had a tough time finding chains to fit 23565r16 tires on my Honda minivan. I found that peerless 0155505 auto-trac self tightening passenger chains worked and were very easy to put on. The self tightening chains did not require me to pull up onto the chains. Just three simple connections and your done.
Replacing fog light bulb on a Lexus IS300?
Bulbs can be replaced you have to get bulbs type 9006 (hb4)
How do you get the 4 wheel drive working on 325 polaris magnum?
21 seconds is my band.please support.we cant have a band if we dont ngot no fans! :]
What is the rear leg room of the 2010 Ford Escape?
The 2010 Ford Escape has 35.6 in. of rear leg room.
Is the 2005 Toyota Tacoma front wheel drive rear wheel drive or four wheel drive?
The 2005 Toyota Tacoma has rear wheel drive.
Why does my car shake trying to accelerate pass 50 mph and from a stop?
I would check your tires they could be out of balance. or a tire could be bad .
What is the proper spark plug gap for a 2002 Yamaha YZ 250?
The proper spark plug gap for a 2002 Yamaha YZ250 is .024 inches. New spark plugs usually come pre-gapped, however.
Ford escape 2003 bad o2 sensors?
Oxygen Sensor
Some vehicles have (2) and some have (4) O2 sensors.
When you start looking at the O2 sensors, they are normally numbered something like "Bank 1 Sensor 1" Bank 1 is on the passenger side; Bank 2 is on the driver's side. Sensor 1 is the upstream sensor (near the frame, between the block and the cat) and Sensor 2 is near the Y-pipe (downstream of the cat).
Normally it is the upstream sensors (sensor 1) that go first. They see the harshest conditions.
You will need;
Oxygen Sensor Socket
Anti-Seized
Penetrating Oil
I have even used a small plumbers propane tank and heat it up and it help get them free.
Sometimes it will take 15 minutes or take a few hours it depends on your luck...
What is the correct battery size for a 2006 Ford Escape 4 cylinder?
The 2006 Ford Escape Owner Guide shows :
The Motorcraft BXT-40R battery ( 590 cold cranking amps according to fordparts.com )
How do you access rear shocks on ford escape 2005?
The upper nut for the shock is behind the quarter panels at the very rear or the vehicle. There is an online guide on how to remove the panels.
How do you change the license plate bulbs on a 2001 ford escape?
The proper way is right under the outside plastic handle - there are the two lights, they need to be "pressed" toward the front of the car to release the tab, comes right out. Snaps right back into place... remove the interior tail gate pannel. Replace bulbs from the inside.
How wide is the 2003 Ford Escape?
The 2003 Ford Escape is 5 ft. 10.1 in. (70.1 in.)1 one-touch power windows wide.
