0
Toyota 4Runner
The 4Runner is a mid-size sport utility vehicle (SUV) produced by Toyota Motor Corporation since 1984. This SUV is offered in four-wheel drive (4WD) and rear-wheel drive (RWD) layouts.
3,192 Questions
How do you access the power antenna motor on a 95 Toyota 4Runner?
remove 7 of the 11 screws retaining the wheel well plastic in place (from the left side looking at the wheel) under the fender and push back a little bit the plastic and you will see the power antenna held in place by one screw to the body, don't pull out to far the antenna cable is still hooked to the radio. i know it can be done because I've done it, no problem.
3.4 ltr V6 Toyota cylinder placement?
Not sure what you are asking so I will speculate. If I miss it you will need to reform the question.
Some vehicles have a separate cylinder that bolts to the engine. This isn't so in the Toyota's. If you have something wrong in the cylinder you need to remove the whole engine from the vehicle and get it to a machine shop. They can check it and see if it needs a simple sanding of the interior, called honing, or if it needs to be completely re bored and the pistons re-sized for the new bore.
Unless you have a huge crack, the original can most often be reused cheaper than getting a new assembly.
If you are asking about which cylinder is the number 1 cylinder and which is the number 2. Then stand in the front of the car with the hood up. looking at the motor you see 3 on the left and 3 on the right. Counting front to back to your left its 1 3 5. To your right its 2 4 and 6.
Where is the low tire pressure reset button on a 2004 Toyota 4runner?
The low tire pressure indication may be coming from the spare tire.
Added: Don't know if this will help or not - on the Highlander the tire pressure re-set button is located on the very bottom edge of the dashboard just to the left of where the steering column is. Depress and hold for approx 5-10 seconds.
What is wrong when the sable starts making a chain rattling noise?
Could be the timing chain. Its at the front of the engine where the belt is. Almost dead center. But check the water pump also. I had a bearing go out in one and it also made a similar noise. Its lower and toward the front of the car . Still on the engine.
Which fuse do you change in a 1988 Toyota 4Runner if the rear window will not roll down or up?
first thing to see if its a fuse is push the button and if you hear a click on the driver side right behind the drivers seat, if you hear them click then its something to do with the motor or harness.
Also a problem i had when i first picked up my 88 4runner was i guess it would be the coil, the thing with the black cover on the window motor assembly, the cover had come loose and was stuck to the coil so i just replaced the cover and everything was cool, most recently a problem that i still haven't fixed is the harness is caught somewhere so it will get stretched out causes a break somewhere along the line when i move the window up or down, so to get that to go up and down i have to pull on the harness, which is on the driver side right up in the rear corner, which gets it back to the right place and sometimes i need somebody else to push the button inside while i move it around to the right place, i love toyotas.
The fuse box is labeled what each one is for. Look for windows or doors. If you find it and change the fuse but the window still doesn't work then you probably need to change the power window motor inside the door panel. There is also a fuse box under the hood that you can check but more than likely it will be the fuse box inside the car. Good luck, Jean
First make sure that the "child lock" safety button is not depressed on the drivers armrest. This locks the window in the rear doors and the tailgate window. I thought my tailgate window was stuck untuil I found that the rear windows were also not working.
It might not be a fuse at all. if the top is removed make sure to replace all the bolts, or at least look on the drivers side behind the side panels where the top bolts secure it. there is a pin switch which needs to be tripped by securing the top bolts when replacing the top. if the correct bolt is not replaced the window will not operate in any direction. I bought my '88 4runner being told the motor was bad and all it was was the top replaced with onlt a few bolts and this one was missed. It is the bolt right next to the roll bar on the driverside
more infothe rear window control panel is inside the tailgate just behind the left-rear quarter panel, remove the various bits of trim including i think the overhead rear light console and the leftrear tool pocket, in fact the control unit is just rearward of this tool pocket. Anyway there are two relays in there which are big culprits in the misfiring of the rear window. They can be sourced but that takes hours of googling. Also a help is to lubricate the window runners by dropping the tailgate and removing the trim panel. To get at the runners you need to lift the window which is something you cant normally do with the door down. Fool the system by clicking the 2 latches manually and then have someone support the glass as it comes out when the button is pressed to close the window. now clean and then lube (using PTFE grease ideally if poss) the window runners and also the various moving parts of the window regulator. The poor rear window problem is never only down to one reason, its either stripped teeth in the motor, dirt and dust in the runners, dirty glass, badly seated/sealing rubbers, generally old and failing wiring, failing contact points, failing relays in the control unit and one which is the cheapest fix of all - the window lock button beside the gearstick may have been pressed by your kids! HeadlineI recently had the same problem. After checking all of the above, I took the car to the dealer who found that the switch in the tailgate was bad. Fortunately this is a relatively cheap part, but difficult to get to if the window in broken in the down position. Also, if you have a rear wiper, there is an interface built in to the circuit that tells the wiper that the window is up and allows the wiper to work and window NOT to go down. Shake the wiper and force it to the home position (rest) while some one is actuating the switch.How do you fix the lift wire for the power window on a 1993 Ford E150?
I believe that your model has a lifting lever, and not a lift wire. You have to replace the regulator assembly to fix this system. There is a possibility that a nylon slide may have become disconnected. When you replace the regulator assembly, be advised that you will have to drill out some rivets and replace them with bolts when you re-assemble the system. This will be a big project, if you decide to do it yourself. Contact us for more information on the full procedure befory attempting it yourself.
How do you adjust the idle on a 2001 Toyota Camry?
The idle on the early "2000's" (up to 2006) is controlled by the Engine Control Computer / Engine Control Unit (ECC/ECU) and is not adjustable. If you are experiencing what appears to be an unusually low idle: # Have you recently disconnected the battery (or had it discharge), or did you recently re-set the "Check Engine" light with an OBD-II scan tool?
# A lower-than-normal idle is expected when you reset the ECU as it needs to re-learn the settings for your engine again. # The idle should improve after the first 10-15 miles of driving and the re-learning process will be finished after about 50 miles. # If your idle is REALLY low - to the point of stalling - you may need to go to the dealer and get a firmware update. Cost: About $100. # Does your car experience a period of poor idle - every once in a while for no apparent reason?
# If this happens infrequently - depending on the mileage driven - this is normal since the ECU periodically re-calibrates itself. # If your idle is exceptionally low during these periods, you may need to check for a firmware update. # Is your car idling poorly almost all the time?
# If your car is idling/performing poorly pretty much all the time, you should arrange to have it examined by a competent technician trained in the peculiarities of the Toyota systems.
Your car smells like gasoline inside and out?
I wouldn't even drive it another foot, if I could avoid it. Get it to a mechanic. It's clear that gasoline is leaking somewhere.
Where is the fuse panel in 86 4Runner?
If your sitting in the drivers seat the fuse panel would be up underneath the dash on the left kick panel near the top.
How much will it cost to replace a drive shaft for a Toyota 4runner?
The front drive shaft or 'prop shaft' costs around 400.00 and a 50.00 core charge. That is the part itself, add a good 70 to 100 for service charge if you take it to a mechanic.
The main shaft is probably a few hundred but that's a guess.
What is the city and highway range of the 2003 Toyota 4Runner in miles?
The EPA range estimate for the 2003 Toyota 4Runner is 368.0 mi. in the city, 460.0 mi. on the highway.
How do you adjust the idle on a 1992 Toyota Paseo?
I wrote the company regarding this and they advised there were no campaigns involving the bumpers and that I was on my own.
How do let down the spare tire Toyota 4runner?
Locate your tire changing tools...there should be a rod with a rounded hook on the end, and a turning handle to attach to the other end.
Now, go to the back of the truck. In the center (either in the bumper itself or in the body), there is a slotted-shaped hole. Attach the turning handle to the end of the rod, and insert the rod, hook-end first. The curve of the hook needs to mate up with the winch inside the hole (you may need to look in the hole with a flashlight first to see what you're aiming at). Once you've got the hook locked into the winch, just start cranking down and the spare tire will lower to the ground. Once you have it on the ground, you can take the chain out of the middle of the wheel.
You can put the other wheel back on the chain and wind it back up again if needed.
How do you install tune-up parts on a 95 900s Saab?
Its hard to answer if you dont meantion which parts
Where is the headlight relay on a 87 Trans Am?
It is on the firewall with the word Guide printed on it. Located right behind the master cylinder on Drivers side.
How do you change cabin filter on 2004 4runner?
I own a 2003 4Runner and the cabin air filter is directly behind the "Glove Box." It's in the exact same place on my 2008 Tundra. So I must assume your is in the same place.
Open and clean out your glove box. Remove the piston on the right side of the glove box, let the box drop forward. Squeeze in the sides of the glove box to bypass the stops in the back of the box. Let it drop forward.
Behind the glove box you will find a long door with the air filter inside. It's that simple.
How do you replace heater core in toyota 4 runner?
Drain the cooling system. Remove the water hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
Where can you buy Toyota rear wiper arms?
From a Toyota dealer. Not available from auto parts stores.
1996 Toyota 4runner ignition lock key gets stuck?
I just fixed mine! Remove the panel over pedals by removing 4 screws with a 10mm socket wrench. Unplug the white plastic plug that has two blue wires that attach to the ignition assembly. This also disables the chime that rings when you have the door open with the key in the ignition. You can test it before you put the panel back. This job took 10 minutes. I had already replaced the entire ignition assembly, which did not fix the problem.
How do you reset a maintenance light on a 1995 Acura Integra?
The maintenance light can be reset by pressing the red reset button on the right side below the ignition area, pass the panel.
If you don't mind looking under the steering column, you should be able to see it.
there is a little switch under the dashboard on the drivers side under the steering wheel just flip it and it should go off
You will find a switch under the steering wheel area. It may be a black retangular plastic unit, with a blue push switch. In order to turn off the Maintenance Required signal, you must first, start your car on, then click the switch a couple of times until the Maintenance Required signal turns off. If you can't find it by touch, find it using a flashlight.
Why does your 1989 Chevrolet caprice start up but stalls when it is put in gear?
check your fuel filter and also your spark plugs.
How do you replace 2000 Maxima headlight?
How to remove the headlight assembly # Disconnect negative battery cable # Remove the headlight bulb # Remove the radiator grille # Remove the parklight housing # Remove the retaining nuts and bolts and detach the housing and withdraw it from the vehicle
