0
Car Stereos and Speakers
Car stereos and speakers are audio and video system designed for automobiles. They are commonly composed of two speakers and a stereo system but are also expandable depending on the user’s preference or needs.
3,598 Questions
How do you remove the rear speakers from a 2002 Toyota Celica?
you have to take off all the trim starting from the piece in the boot against the rear of the car. For each piece, take out all the screws and then pull (there will be some force required because there are also plastic clips holding these in that pull out). If the piece isn't budging, you're probably missing a screw.
Once the trim is gone, I think you have to drill out the places where the speaker is held into the frame. Either that or they screw out...
Can a ssl ae130d push a kicker l7 15?
An SSL AE130D can push a Kicker L7 15 if sufficient power is provided. Typically this will require the wiring to be upgraded to an 8 gauge while the fuse rating is increased to 30 amps.
How do you get to the rear deck speakers to change them in a 1995 cadillac concourse?
Remove the cover in the rear window.
Can you hook up 4 speakers to a 2 channel amp?
take the positive from speaker A and twist the copper wire together with the positive wire from speaker B. then take those two (positive) wires from A and B and put it in Channel 1 positive terminal. then take the negative from speaker A and twist the copper wire together with the negative wire from speaker B. take those two (negative) wires and put them in the negative terminal under channel 1. then do the same for your other 2 speakers, except in channel 2
What signal wire from ecm do you use to hook up a tach 99 eclipse?
you dont use the ecm, you use one of the wires from the second injector, i think its blue
Is Alpine MRD-M1005 a good amp to power 2 Alpine Type R 12?
Perfect as long as your running them at 2 ohms to get the full 1000 watts RMS output from the amp as each sub is rated at 500 w rms.
I have the same amp with 2 10" alpine type r subs. Model SWR-1023d, 2010 model and they bump hard as hell!
How do you set time in my pioneer deh2850?
turn the key on but have the CD player off. push and hold the audio button until the clock setting displays
How does a stereo speaker use an electromagnet to produce sound?
An electromagnet drives the stereo speaker to provide the sound.
What is a Volkswagen beetle car stereo wiring color code?
1999 Volkswagen Beetle Stereo Wiring
Constant 12V+ Red/White
Switched 12V+ yellow/Red
Ground Brown
Illumination Gray/Blue
Dimmer bgcolor
Antenna Trigger Red/White
Antenna n/a
Rear Roof, Amplified na
Front Speakers 6 1/2" Doors:
Left Front (+) | Blue/White Left Front Brown/White Right Front Red Right Front (-) Brown/Red
Rear Speakers 6 1/2" Rear Sides
Left Rear (+) Red/Green Left Rear (-) Brown/Green
Right Rear (+) Light Blue Right Rear (-) Brown/Light Blue
Any decent car stereo installer will have them, or can order one or can custom wire one for you if needed.
Why doesn't your remote wire turn on your amp anymore?
Easy way to check were the problem is take a 6" piece of wire. Unhook the remote wire from your amp. Then hookup your 6" piece of wire to amp remote terminal then take other end and connect to the 12+ terminal. If amp powers up the its in the headunit. If amp does not powerup or goes into protect mode the amp is problem.
How do you connect two amps to four subs?
Run a 2 sub per amp set-up. Get a distribution block for you power wire to split the power wire. You can run the remote wire from your stereo to one amp and then from the amp to the other amp. you will also need 2 sets of RCA's
Easy way is too get a 4 channel amp to power 4 subs.
How do you remove rear speakers for Toyota solara 2006 se?
Begin by removing the speaker covers in your 2006 Toyota. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
If installing new stereo what do you hook up the positive and negative dash illumination wires too?
Usually the "illumination" wires are yellow in the car and the stereo, and the negative should go to ground. I think that's how I hooked mine up. I can check it and get back to you later.
How do you replace the speakers in a 2003 impala?
well, you need to specify if you are going to replace the speakers with stock speakers or with aftermarket speakers.-Shocker
I don't know how much relevance the previous answer has, but you need to remove the bottom of the seat by pulling up to get the tabs to release. The seat then un-bolts with two 10 mm nuts. The seat back can be removed. The inside quarter panels can be removed by pulling and sliding the header channel out of the front. There are three shield clips that then must be removed from the bottom of the rear deck/upholstery assembly. This allows the rear deck to be removed but the sound-proofing/padding is glued to the trunk lid so the whole assembly must be lowered into the car unless you want rip it where it is glued.
Once the rear-deck lid is removed, the speaker assembly can be removed. First un-hook the two clips on the right side of the assembly and slide the tab out of the slot on the left. There is a gasket that is applied to the bottom of the speaker assembly, presumably to prevent rattling that holds the assembly to the body. This gasket is quite strong, so you will need to apply some pressure. Finally, before removing the assembly from the car, separate the pigtail by depressing clip and slide it out.
From there, 4 T-10 Torx screws hold the speaker to the assembly with another gasket that is again makes it difficult to separate. Gently pry apart with a screw driver if necessary.
I do not believe that the mounting bracket from which you separate the speaker is designed for a standard 6x9" and thus there are two tabs that must be removed. Heat a razor blade up and slice them off with the hot knife. Finally if you want to re-use the pigtail ends on the speaker, they can be removed.
The wiring information from http://www.modifiedlife.com/2003-chevrolet-impala-car-stereo-radio-wiring-diagram/ indicates that:
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue Iconoclast Hero
Can you run two 15 audiopipe subwoofers off a 550 RMS monoblock amp?
You can but it probably won't hit that hard. I don't know the subs rms but if there 15s should be atleast 800 to 1000 rms . Get 1 Audiopipe 1500 monoblock . That will push them
How do you remove the speakers from a 2000 Tahoe?
on the front doors, start by removing the (2) 7mm screws, one located under the armrest and the other located behing the door lock. you'll have to pop that off to get to it. then remove the triangular piece towards the front of the panel. then you'll have to remove the plastic piece around the door handle. remove the switch panel and unplug the harnesses. then lift up on the door panel and unplug the door light from the backside. with a flathead screwdriver press down on the tab at the top of the speaker and pull out towards you and your done. the rear doors are done pretty much the same. remove the 7mm screws, one located on the bottom of the panel and the other located under the armrest. pull up on the panel and unplug the window switch. remove the (4) 5mm screws from the speaker and pry it off the door.
How do you bypass the e break for the dual dvd710?
Easy, Ground it with your stereo ground wire.... (make the pink wire and black wire connect to the Main Ground wire which is also Black)
What size are the front door speakers on a 1997 eclipse?
1997 and 1998 are likely the same. check crutchfields website for more details. 1998 Mitsubishi Eclipse Spyder Convertible== ; In-dash stereo : 8-11/16" depth; Size code E,S,U ; Front speakers : Dash: 4" : Front Door: 6-3/4" ; Far rear speakers : Rear Seat Side Panels: 6x9"
The solution is hear :
http://car-radio-unlock.blogspot.com