0
Chevy Blazer
The Chevy Blazer may refer to any of the sport utility vehicles manufactured by the Detroit-based automaker General Motors Company. Some of the popular Blazer models produced by the company are the TrailBlazer, the S-10 Blazer and the K5 Blazer.
5,824 Questions
Would a 1989 Chevy Blazer front clip fit on a 1982 Chevy Blazer?
yes, 82-93 are the same besides grill design
What is the Fuel tank capacity of a 1977 blazer?
pretty sure its the same as mine which is an 88' and so it would be either 26 or 28 gallons...
How do you set the clock on a 02 Chevrolet Cavalier without the marks on the buttons?
The hour and minute button in mine are the tiny buttons under the volume knob. The one on the left is the hour and the one on the right is the minute. Just hold it down for a second and it will change.
Your 04 Chevy trail blazer almost stalls when you turn on ac?
This is a dirty throttle body. Very common on our trucks.
Why would a 96 S10 Blazer have intermittant starting problems?
: If anything, try replacing the fuel pump relay (about $17.00 part) before you do anything too expensive. I spent about $1200 replacing the computer and the pump and finally replacing the relay worked. It almost looks like a fuse and should be possibly located under the glove box (at least it was on my 95). Good luck.
from the vacuum source in the intake manifold,to various vacuum operated components
What is the stock gear ratio for a 1995 Chevy Blazer?
The stock gear ratio for a 1995 Chevy Blazer is 3.73. This provides a good balance of fuel economy and power to the rear wheels.
How do you replace a rear window on a 1984 K5 blazer?
To replace your window, you need to have the window rolled up. On the regulator(that is the little arm that connects to the metal peice on the bottom of the window) is 11mm bolts. If you take those four bolts out, the metal sleeve on the bottom will come off. Clean out the old silicon. Put in new. Replace bolts.
Why would a 1994 Ford Probe drive fine in reverse but barely move in drive?
One possibility is brake(s) locking up.
What would cause the power seats not to work on a 1999 GMC Jimmy?
check for power i had a problem with one in my shop i had no power to the unit i belive it should be the larger orange wire from connector back probe it mine was broken under drivers feet cheers man good luck
How do you replace the drivers side mirror on a 2004 Mitsubishi Endeavor?
Very easily. Open the door, find two rubber circular boots right behind the mirror. Take them off to expose the 2 bolts that hold the mirror on. Take the bolts out and unplug the wire. Reverse these steps to install, hole this helps...
Very easily. Open the door, find two rubber circular boots right behind the mirror. Take them off to expose the 2 bolts that hold the mirror on. Take the bolts out and unplug the wire. Reverse these steps to install, hole this helps...
There are three small bolts holding the driver's side mirror on. Two can be accessed by opening door and removing the two circular rubber boots seen on the upper end of the door . To access the third bolt you will need to remove the door panel. you will need a forked driver to help remove the door panel. It can be bought at any auto parts store. It has a flat Y shaped head that can be inserted along the lateral and bottom edge of the door panel to pop it way from the door frame. There are three screws holding the door panel on. Two under the door handle and one behind the door latch. Then the door lifts up and off. Make sure you have the window down before you take the panel off because you cannot access the third bolt unless it is. You will have to unplug the electrical connects that power the controls on the door handle to completely remove the door panel. After you remove the panel there will be a hole in the upper right hand door frame, possibly covered by a black patch. Beneath this is the third bolt. you will also need to disconnect the light from inside the door frame before you will be able pull the mirror off. There is a large rubber boot oval shaped that you can pull out and you will see the electrical connection for the mirror inside the hole on the right.
What to do when keys are stuck in ignition of manual transmission neon?
Make sure the shift is in reverse. If that doesn't work, look under the hood, there's a cable that comes from the tranny through the firewall, you have to replace the cable but you can get the key out by pushing the arm that the cable connects to on the tranny forward.
Where is the fuel pump located on a 94 Chevy Blazer?
It is located in the gas tank. The tank will have to be dropped in order to replace it.
How do you remove the instrument panel from a 1994 Chevy s10 blazer Tahoe lx?
If your looking to remove the entire dash assembly I would recommend purchasing a shop manual to guide you thru it.
If you stick your arm out a airplane will it brake?
Because to break an arm requires either a considerable amount of force or asharp impact. A typical airliner cruising at altitude is doing 400kts. You would not be able to hold your arm perpendicular to the airstream but it would not break. After a short period your arm would become frozen and your skin would start to break off.
What type of oil and how much oil is need for the 89 Toyota Camery?
approxiately 4 1/2 to 5 quarts of 10w30 oil. Highly recommend Castrol synthetic 10w30 on older Toyota engines.
AnswerThe 4 cylinder takes 4 Qts with filter and the V 6 takes 5 qts with filter.On the oil filler cap,it reads 5-30 W for the type of oil. .................
Where is the turn signal flasher on a '96 Chevy Blazer?
I believe it is in your glove compartment there is an access to your flasher.
What size engine in a 98 Chevy Blazer?
It's a 4.3 litre V6 (262 cubid inch) Most had engine code W but some had code x. It's the 8th digit of the vin number.
Why is your 2000 Chevy blazer leaking transmission fluid?
Automatic transmissions are sealed components that should not require replacement fluid, except during service changes and flushes. The 2000 Chevrolet Blazer with the 4L60E Hydramatic if leaking is indicative of a hard and or soft part failures. These could sources as simple as a hose to a major failure of the 4L60E case itself.
How do you reset the air bag sensor in an Acura 32 tl?
I just had this happen to me on a 96 Pathfinder. Here is the solution which i found on another site:
"corrected response: Pressing the door knob sensor 5-7 times within 5 seconds DOES WORK!!! The door knob sensor can be found on the frame where the (driver) door closes. It is a black coloured rubber button. Turn the ignition on (do not turn on the car though) and press the door knob sensor once almost every second for 5-7 times - Do not go too fast. And it should work. Do not give up if it does not work at the first attempt. It required five times for me... Once the flashing airbag light is gone, turn off the ignition. Wait for about 10 seconds. Then turn on the car and the airbag light should go off after a few seconds. Good luck!! Thanks a lot to the person who posted this first time... and also to people who subsequently confirmed the sucess of the trick. This saved about a hundred bucks!! Cheers!!! "
