0
Honda Rancher
The Honda Rancher is a four-wheel ATV that is used for off-roading and other recreational activities. Ask and answer questions about the Honda Rancher here.
567 Questions
How do you adjust valve intake on 1992 trx 250x?
Adjusting the valves isn't hard but it does take some knowledge of the subject. Check out my bio page for help.
Why does a Honda Rancher 350 ATV stall when it gets wet?
This is a tough question to answer considering you didn't give any more information than "wet". Wet could mean driving through a sprinkler or it could mean driving through a river. If you are simply riding through small mud puddles and water no higher than say 8"-10" then perhaps you could be getting water in your electrical connections. Try unpluging the 5 or 6 plugs in between the front suspension and putting some dielectric grease in the connectors then plug them back in. There are several more plugs in front of the right rear tire. Do the same with them. However, if you are riding in very deep water then perhaps you have bigger problems. If you take an air-cooled engine from 350-400 degrees and shock cool it to 100 degrees in several seconds time then you are stressing that engine to a point that you could do catastrophic damage to the engine. Metal greatly expands and contracts with heat and can warp or crack with sudden temperature changes. With shock cooling it is common that an engine will momentarily stall then recover in time. If you get too deep in the water and get water in the airbox and into the cylinder it will stall and quit. DO NOT try starting the engine as water will not burn, will not pass and is not compressable. You will simply have bent valves, cracked head and need a top end overhaul at the very least. To avoid this remove spark plug, turn off fuel, turn engine over until all water is removed, re-install plug, turn on fuel and re-start.
What is causing the loud screeching noise on the front wheels of your 2003 Honda Rancher?
The bearings in your front wheel. I've just changed mine as it sounded like I'd run over a dog
Where is the CVT intake located at on a 2008 Honda rancher 420?
the rancher 420 does not have a cvt so there will be no cvt intake
How do you change rear diff pinion seal on 2007 honda rancher?
Well. First you have to suck my fat dïck. Then whatsever the fu*k else to fix your piece of sh*t fourwheeler
What could make Fuse 17 blow when you shift from reverse to neutral?
Short circuit somewhere in the reverse-light or even the reverse switch itself. Other causes are also possible.
Check your thermostat switch.
FDR was an investor in a cattle ranch in Nebraska for a short time. He only stayed there one day because while he was there his wife and mother died. He never went back. Today it is a national park with tours of the ranch house, a museum of FDR items, and camping grounds.
yea not axtremely high though probabaly about 3 ft. if u hit a good jump
How do you replace starter on a Honda Element?
First of all, make sure that the problem is actually with the starter. If your warning lights and radio work, it's not the battery. Does your car run a bit and then die? That could be the alternator. If you have a friend with you have them listen to see if they hear the clicking of the starter as you try to turn the engine over. This is the starter solenoid. If there is no clicking, change the $10.00 solenoid. If all of this is not the issue you may have a bad starter.
1. Find the battery.
2. Disconnect the battery.
3. Follow the large wire down the back of the battery to the starter.
4. Disconnect the positive wire from the starter.
5. Disconnect the negative wire from the starter.
6. You may want to mark the wires to keep them straight.
7. Un-bolt the starter. KEEP A MENTAL NOTE OF THE ORIENTATION OF THE STARTER.
8. Place the new starter in place.
9. Lightly bolt it just enough to keep it from falling out.
10. Re-connect the wires from the battery.
11. Don't forget to ground the starter.
12. Bolt it back in place.
Good job.
This answer is totally wrong. Before you can remove the starter you must remove about 28 other things first. Like the intake manifold and a nest of wires tubing and cables and such. The solenoid is internal in the starter and cannot be fixed without rebuilding the starter. It's not a $10 add on part. A new Honda starter is about $389.
*Very true. You must first remove the intake manifold which is an involved process. But, it is not hard at all if you just look for instructions online. Also, a new starter at your local parts store will run you between $120 and $170. Do not try to get one through your local Honda dealer. That is where you will pay close to $400.
If the fwd light blinks on a Montero Sport what does this mean?
Pretty sure that means that the 4WD is in the process of engaging. Blinks for a few seconds then stays on.
Mine sometimes blinks while in 2WD whether I'm using 4WD or not. Research on internet suggests it's fairly common problem and probably due to misaligned sensor. Since I've tested my 4WD/2WD (on ice) to see whether it was going in and out of 4WD correctly I placed window tint plastic over light so it would stop buggin' me...;)
Sometimes may take a few miles of driving for it to go out. Usually after some starts and stops. Sometimes shifting into and driving in reverse a little bit does it too.
What does the 420 mean with the 2007 Honda Rancher ES 420?
It is a 420cc motor. Such as a Honda Fourtrax "400" is a 400cc.
Can you replace your Honda rancher ATV spark plug with a lawn and garden spark plug?
Would you use lawn mower plugs in your car?? NO!!!!
What causes timing chain ticking on Honda rancher 350 four wheeeler?
too much slak. chain could have kinks from being strectched too far .sliders could be worn out .sproket could have groves in it
Where would you find a diagram of a motor so you can find all the parts?
What motor? The term motor usually refers to an electric motor. The term engine usually refers to an internal compustion engine. Please restate your question with the model and size motor or engine you are referring to.
Where is the battery located on a 1991 Honda fourtraks rancher?
Try checking behind the seat (pull it off) and it's under a panel right in front of the rear rack.
What is the horsepower of the 2009 Honda Rancher AT 420?
what is the housepower of the 2009 handa rancher at 420 It has around 26 or 27. But a lot of low end torque for MUDDING!
Your manual 1996 Ford Aspire starts but you can't get it into gear what causes this?
It may be in gear but you have a broken CV joint. Check the boot on the joint to see if it's torn or cut. If it is then jack up the front end and hold the big part of the joint right by the wheel and turn the small shaft if they turn seperatly then the joint is broken and your car will not move.
How do you tighten rear axle nuts the right way?
All nuts and bolts for any vehicle has a torque spec( for a racher I think it's 47 ft-lbs.). from the manufacturer a torque wrench is the suggested way, but everyone I know just uses a 1/2 cordless impact gun.
What is the oil change capacity of 1989 GMC Vandura 5.7 V8 if your dipstick is missing?
Don't be so frugal a Dipstick to fit can be purchased at a number of different places. Examples [http://buy.autopartsreplacement.com/brand.php?make_text=gmc&model_text=van_full_size&ml=g250-vandura-004&year=1989&part_name=engine_dip_stick&my=1 Buy Me] An open or ill fitting Dipstick in the tube is an invite to suck dust & water into your engine oil. I looked in the Haynes manual... lists oil & filter change capacity as 5 qts. I will change the oil & filter, add 5 qts on level ground and insert a long rod or wire into the dipstick tube til it bottoms. Then remove it carefully and check the oil level on it. Cut it shorter so only about an inch dips into the oil, make a top cap somehow (or just hook the wire) and scribe my normal oil level onto the wire. Sounds pretty good...
How do you make a Honda rancher es go faster?
Put two moth balls inside a FULL tank of gas. Also helps to clean out carb and injectors.
