answersLogoWhite

0

Locks and Latches

Locks and latches are parts of a door. While the latch ensures that the door stays in a closed position to prevent it from opening, lock prevents the door from being opened without a matching key.

2,075 Questions

How do you fix a door lock in a 1995 VW Cabrio?

I believe you have to take it a vw dealer, an auto lock specialist. or you take the door apart, replace parts if necessary or repair the track if that is possible. Also check fuses.

How do you fix a lock on a 1985 Toyota Corolla that will open from the outside even when locked?

you will have to take the door panel off and see what is causing it. it might be a rusted c clip holdin from locking

How do you unlock the ignition when the key don't turn and the steering wheel is lock?

It depends on the type of vehicle. Need to know the make and model and year. Different vehicles have different problems with ignitions.

How do you remove a jammed tailgate from an 89 Chevy Blazer S-10 where the glass opens ok and the lock is stuck?

I had this issue on my '87. I pried the plastic panel out of the channel enough to work the prybar into the latch and work it open.

Should you put a lock on a child's bedroom door?

You should use a privacy lock, one which can be opened by you from the outside if need be in case of emergency, etc. but never a padlock.

How do you open a 1990 Chevy hood if the hood release cable is broken?

Climb under the front of the engine compartment with a coat hanger and a flashlight, reach up and grab the latch and pull it down.

How do you get the trunk open after the car has been hit from the rear and the lock is stuck?

Hi there depending on what car you have,,, you can get thru the truck arear by folding down a rear sear,, or removing the seat,, then when you can get in the trunk area, you can unbolt the latch on the truck lid and it will open.

1987 Mercedes 190e drivers door lock does not openclose all other locks but passengertrunk lock open all?

The problem is with the lock segment itself. The unit is made with some cheap type of alloy and the tip that goes into the bracket that locks the door is 99% of the time broken. I got a replacement lock from the junk yard and jury-rigged mine. You may have to do the same. Good luck!!

Where to find replacement lock and window controls for passenger 2004 Dodge 1500?

Auto salvage yard would be your cheapest place. Other than that it would be online, a body shop, or a Dodge dealer which would be the most expensive.

What dissolves superglue out of car locks?

Acetone will dissolve Super Glue. You will find acetone in nail polish remover. Read the ingredients, some nail polish removers are acetone free.

'''OFF insect repellent will also dissolve Super Glue.

Dissolving Super Glue is one thing but getting it out of the lock could be a challenge.

'''

How to change the battery in a key fob?

It's a two part sliding mechanism. Hold the key in your hand with the key bit pointing forward and the larger part of hosing to the right. Now with your thumb on the back of the fob supporting the thinner section and your other two fingers on the larger section, on the front of the fob. Push backwards with your two fingers supporting with your thumb. It is quit stiff so a fair bit of pressure is required.

AnswerOn a Hyundai factory-supplied key fob such as that used on the 2002 Sonata or XG350 there is a riveted leather strap connecting the key to the fob. Slide this strap to the side and you will see an opening between the halves of the fob. Stick a slim screwdriver into this opening and twist it until the two halves separate. This will expose the circuit board and the battery (usually a CR2032 3V lithium battery). Pop the battery out of its holder being careful not to lose the metal conductor/tab that connects the positive side of the battery to the circuit board. Make a note of how this metal conductor/tab sits within the battery "pocket" in case it falls out. Replace the battery making sure the conductor/tab is in place. Once the battery is popped into place it holds the confuter/tab in place as well. Make sure the dust/water o-ring surrounding the fob is intact and carefully press the two halves back together until they "snap" closed. Test that the fob works correctly by unlocking and locking the car doors. You should not need to program the fob if you are just replacing the battery.

Hope this helps those who were going as crazy as I was when all they wanted to do was replace a simple battery.

1977 Corvette and the hood release won't work is there another way to open the hood?

== == there is a tool i saw in a catalog trying to find which one. that tool was for 1984-1996.but they do have emergency hood release cable that can be installed in 68-82 part #604-801 for $19.99

Location of door lock relay 1987 thunderbird?

There are two relays. One is Lock Relay and the other is Unlock Relay. They are located under the passenger seat

How do you unlock the door of a 1996 gmc jimmy without the key?

peel top of door back slightly and put in a wood wedge then use a long stiff rod(like radio ant) to activate lock switch or lock slide.

How do you change battery in a volvo v70 key fob?

The battery in the key fob of a Volvo v70 is changed by opening the case with a penny or nickel. The battery can then be taken out and a new battery slid into position.

Car doors keeps unlocking?

most 1995 jettas had that problem, the lock will eventually fall through the door and you will have to get it replaced.

If the hood release cable broke on your 1990 Cadillac Sedan DeVille how can you open the hood?

This is very very complicated but, it is very possible to open this hood. You could get under the hood (if possible loosen the panel) and physically make the latch operate, if that is not possible you could take off the bumper, then take off, thenn take off the grill and use a flathead screwdriver to wedge it off. The second method takes more work but very possible, good luck with this.

Get a piece of thick welding rod appo. 30in. to bend and make a tool .1st, bend 90d @1 inch. 2sec. bend 45d@ 4inch. 3rd. bend @ end 90d appo. the last 3in of the rod. now you nedd to slip this in behind the latch and hook the release .this is between the hood and the radiator core support. you are fishing for the release you will pull it to the drivers side of the car. it really helps if you can find a cadillac deville 1985 fwd to 1993 fwd look at the latch and you will see how this tool will work.GOOD LUCK!