0
Toyota RAV4
The RAV4 is a compact crossover sport utility vehicle (SUV) manufactured by the Japanese carmaker Toyota Motor Corporation from 1994 to the present. This vehicle features better fuel economy, excellent maneuverability, higher visibility and increased cargo room.
2,187 Questions
How to unlock ignition for 2000 Saturn SC1?
your question is not very clean on your exact problem. I do know that saturns do have the tendancy to "Lock" the steering wheel to the point you cannot turn the ignition key. to remedy this, move the wheel back and forth with force while turning the key, sometimes the lock pin can get bound up in the steering column and prevent the key from turning.
What is the factory setting security code for the radio in your 1996 Rav4?
ADDED 2nd January 2010
If you have disconnected the battery like me without supplying a backup to the battery don't worry it's an easy problem to fix. Lift the plastic panel off the chassis under the drivers seat and write down the last three numbers. Presumably SEC appears on your audio LCD screen like mine. Next step Press the number "1" button and the ">" tune button at the same time. Next step "---" will appear, Enter your pin numnber you wrote down. Next step press the scan button within 10 seconds of entering pin and BINGO one audio security system unlocked!
How do you know if your key is a transponder key?
the plastic cover on a key with an immobilizer is softer and larger than one without. if you have no key to compare, look on the dash with the key not in the ignition. if there is a red light in the shape of a car with a key shape on it that flashes every 2 seconds or so, it has a transponder. when you put the key in the ignition the light turns off.
How do you change the air filter on the 1998 RAV4?
I just did this on my '99 RAV4. Very simple. With the hood open, you'll see a large black plastic "box" on the mid-right hand side. There are two metal clips on the right hand side of it holding the lid closed. Pop them open and lift the top which bends back to the left. You'll have to use a little force and manouver since there is a hose attached on the left but it bends. Pull the old filter out, slip in the new one. Top down, clips back on. Done. Just be sure that you haven't dislodged the cap on something right in front of the air filter box. Not sure what it is - for coolant? It's a small cap I noticed popped off when I pulled the air filter lid back. Just put it back on if it comes off. Maybe mine wasn't securely tightened to begin with.
How do you shut off the 'low tire' pressure light on a 2000 Monte Carlo SS?
The settings and resest to those settings can be found on your factory radio. If you have an aftermarket radio, you'll have to see your dealer to reset it. Otherwise, press and hold the "tune" knob (under the volume knob). You'll notice on the radio display, it will indicate "Settings". Press the arrow keys, under the volume to toggle between settings. When you get to Tire Monitor, press the arrow keys to the right (1 and 2 of the radio presets) until you see (reset), then press the tune button again and you'll hear a beep to confirm. There might be a reset button in the glove box or fuse box. It should say in your owner's manual.
Go to this link to learn all about shocks and struts.
http://free-auto-repair-advice.blogspot.com/2007/05/shocks-and-struts-what-they-do-when-to.html
Rick
I'm a retired ASE Master/L-1 Technician. I still keep current with the latest automotive technology. Visit my blog for cool articles and TSB's: http://free-auto-repair-advice.blogspot.com
How do you turn off seat belt alarm on a 2009 Toyota tacoma?
1) Turn the ignition to 'ON', but do not start the engine. Cycle your trip reset knob until it reads ODO. Turn the ignition back off. Wait a couple of seconds. 2) Make sure seat belt is not fastened 3) Turn the ignition back on, do not start the truck. As soon as you see everything light up, press and hold the trip reset knob for 12 seconds. 4) Keep your finger on the trip reset knob. Fasten your seat belt you should see the ODO display go from XXXX miles to "b-on". Take your finger off the trip reset knob and press it again. It should cycle to "b-off". Turn the ignition off and unfasten your seat belt
How do you changes front brakes on a 1998 Chevy s10?
Remove wheels
Re-install 2 lug nuts to hold rotor in place
Remove caliper mounting bolts
Slide caliper off rotor
Use a "C" clamp to fully retract piston into caliper body
Replace pads inner and outer
Re-Install caliper
PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
What ground clearance does the 2004 Toyota RAV4 have?
The ground clearance of the 2004 Toyota RAV4 is 0 ft. 6.3 in. (6.3 in.).
Can you turn off the audible seat belt alarm on a 2004 Pontiac Grand Am?
Under the seat is where the seat belt sensors are located. By disconnecting these it should stop the noise.
How do you reset the check engine light on a 2007 Chrysler PT Cruiser?
You use a scan tool after repairing the cause of the code.
How wide is the 2013 Toyota RAV4?
The 2013 Toyota RAV4 is 6 ft. 0.6 in. (72.6 in.)1 one-touch power windows wide.
Where is the oil filter located on a 318i BMW 1998?
Let me 1st say that I have a 318IS, not a 1998 318I. With that said, the oil filter is on top of the engine driver side, a little more toward the center of the engine, under a 2-1/2" to 3-1/2" hard plastic or metal cannister(black). The cannister has a dome shaped top. Must use oil filter wrench to remove/install.
I just had this problem last night and I ended up having to take it to the dealership because the key just would not move at all. They had to replace the ignition in my car which ran about $300.
Where is the oil filter on Toyota trundra 2007 with 5.7 engine?
Believe me it not as easy as you think. The oil filter is up under the skid plate on the 5.7L engine and it's NOT a traditional spin-on filter. I went looking for it, finally I went on the Toyota owners web page to find out how to change the oil filter. After reading that it's a paper filter and requires dropping the skid plate and removing 4 screws to change the filter (If you don't get it sealed right it will leak.) I decided to let Toyota change it and avoid the hassle. ALSO the engine requires 0-20 viscosity oil or in a pinch 5-20 for a short term fix.
I used to do all my own maintenance on my vehicles. Today it's imposable I think I still know how to check the air in the tires and Toyota already has an on-board gauge for that.
My local Toyota dealer charges $29 to change the oil in my 2008 5.7L Tundra. It's not worth my time to do it myself. If you decide to do it yourself then you will need a special tool that you get from "Snap-on" tools. It is a MUST to have the tool. If you go looking for the Transmission dip stick. (there is none) the transmission is rated to go 100,000 miles before you change the tranny oil. I suggest you go talk to a "Toyota Service Manager" if you don't believe me.
While the Rav4 is turned off, pull the emergency brake up one click and then start it up. This will leave the running lights off and the emergency brake will not be engaged when it is pulled up only one click.
What is the EPA-assessed interior volume of the 2012 Toyota RAV4-EV?
According to the EPA, the interior volume of the 2012 Toyota RAV4-EV is 144.6 cu.ft..
What is the base engine size of the 2014 Toyota RAV4?
The 2014 Toyota RAV4 has a 2.5 L base engine size.
Code for PO137 Bank 1 sensor 2 Where is this sensor located?
The sensor is left bank 1/1 is ft and 1/2 is the rear
NEW ANSWER: Bank 1 is the drivers side of the engine. Sensor 2 will be the second sensor in the exhaust pipe on that side of the engine. Start were the exhaust pipe bolts to the engine and work your way down the pipe until you see the second sensor and that will be the 1 you need.
Where is the oil filter on Toyota 2.2 diesel RAV4?
The oil filter for RAV 4 is located just at the front of oil pan up high. One needs an extension from the ratchet to get to the oil filter. ItÕs contained within the metallic shell screw and aligned vertically.
Is th 1995 Mazda Protege an OBD-II?
Look for the OBD II connector under the driver's side dash. It was required 1996 and up but some models had the connector before it was necessary.
Answer96 and upAccording to the Chilton's manual, the 1995 Protege and Millenia are OBD-II, also 1994-1995 Mazda 626 with ATX transmissions are OBD-II, and then all models 96 and up...
I have a 95 buick with OBD II, however it requires a different plug to work with a scanner. If you take the car to Autozone or Advance Auto Parts to have them scan it and it won't scan it could be the same reason mine won't. In 95 they were transitioning to the (then new) OBD II system, and some of the first OBD II harnesses only had 5 pins rather than the full (I believe 10 pins) found on the 96 and later OBD II harnesses.
