VW New Beetle

What kind of question is this? If you have a drivers license you can drive any vehicle other than semi n big things like that u need a CDL 4 that

205/55/16 Michelin tires

For as long as they want to.

Dont know about the 98's but if its anything like the mk4's it would be located in the fuse box that sits on top of the battery.

1)With hood raised properly you should always disconnect the battery, but it isn't absolutely nec.

2)Remove the 2 bolts that hold the ignition coil down above the spark plugs on top of the cylinder head. Note (there are 2 coils and 2 plug wires) ((Tools you will need: 10mm socket, 3" extension (1/4" drive), 1/4" ratchet)

3)Once the bolts are removed, disconnect the wiring connectors (not the spark plug wires) from the coils.

4) Twist the 2 spark plug wires and 2 coils slightly about 1/4" turn to keep them from sticking while you try to remove them.

5) Pull gently, at first, upwards to remove (ONE AT A TIME) the 2 spark plug wires and 2 coils from the cylinder head. Note:(they may stick so you may have to pull slightly harder to remove them than your original effort) (Repeat this step for each of the 4 cylinders)

6) Once the spark plug wire or coil with boot is removed you need to remove the plugs. Insert the ratchet, extension, and socket assembly down into the cylinder head until the socket fits snugly unto the spark plug. Turn counter-clockwise unti lthe plug loosens. Once the plug is entirely loose remove it from the cylinder head. ((Tools you will need: 5/8" spark plug socket w/boot, 10" extension (3/8" drive), 3/8" ratchet)

7) Remove old plug from the spark plug socket and replace with the new plug.

8) Reverse and repeat the steps to reinstall each plug. Of course make sure you torque the plugs to spec and gap your plugs!!!

.

Look behind your headlights and you will see wires leading up to a plastic connector, turn this counter clockwise and gently pull to remove the headlight from the headlight assembly. After you have removed the light disconnect it from the wiring harness by pulling out the tabs on both sides. When you remove the bulb take note that the high beam will be a clear bulb and the low beam will have an opaque center. When you install your new bulbs be sure not to touch the glass as this can severely shorten its lifespan.

the bulbs are held by a round carrier inside that comes out when you twist it about 90 degrees ccw. The lenses are bolted in from behind. You should be able to reach back on either side of the car in the rearmost areas such as where the jack is held on the left and where the rear A/C is on the right side on late models at least. How do you remove front headlight on a 2000 series T4 shortnose

Did you ever find an answer? My 99 just did the same thing this week. My husband found fuses on top of the battery and they were all good. So, yes there are fuses. But, that wasn't the problem with my car. If you find out more information please share it. I'm concerned it could be very time consuming and expensive to get this repaired. Thanks. My wife has a 1999 VW Beetle with the 2.0 4cyl. The cooling fans won't come on. I've replaced the Thermostat Radiator Fluid, Temp Sensor, Fan Control Module and pulled the fans and connected them directly to 12V (the fans are good) and NOTHING has fixed it yet. I've checked all fuses I could find and all are good, fans are still INOP. I finally bought a book for the thing and read about some relays that are behind a kick panel on the bottom of the left drivers side floor. I'm going to test those this weekend and see what happens.

The Rodeo is a rear wheel drive vevicle

ahhhh the evil fuse box took me 2 days to find it anyways to where it is
on the driver side open the door look where the dashboard and door meet you will see there is a place where you can stick a screw driver and it looks as if it is part of the dashboard but its the cover for the fuse box this is for the left side driver cars as for the right side driver cars i don't know you have to look on both side and have fun fixing your car

Refer to your owners manual. Don't think this requires additional trans fuild. The transmission is designed that way.

Not really! Have you tried unhooking the negative battery cable? If it then works for a few minutes, it is a sensor inside the door! I am working on a bypass for this common problem! A toggle switch for the window RELAY.

Broken water pump, or stuffed cooling system, or some valve not opening for heater. If its done around 100k i would go for cambelt and water pump change. It s a common fault on year 2000+ VW. Waterpump blades made of plastic and after around 80k usually it falling aparts.

The gas tank on the 2014 Volkswagen Jetta-Hybrid holds 11.9 gal..

2005 Volkswagen Beetle bulb replacement procedure: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Consider replacing both left and right at the same time in order to keep brightness and color equal (optional). Then consult your owner's manual for the replacement procedure. The owner's manual is the best place to start for bulb replacement.

Sounds like you simply have A burned out bulb, Turn the signal on and look at all the lights to see if any are burned out. Could be A marker light if its in the turn signal circuit.

open front trunk. wire two post on solonoid. touch 3 rd post to wired two. should start, remove 3rd contact. if still running ok if stops , wrong 2 post are wired together. try different combo. do not wire the three together, orstarter will not disengage, and burn up.

where is the pressure control solenoid located on a 2002 vw beetle

165R15

Pull the spark plug wires off the spark plugs. Remove the spark plugs with a spark plug socket. Install the new spark plugs and put the spark plug wires back on. I recomend replacing the spark plug wires as well. If replacing them, just remember that the new wires are hooked up the same ways that the old ones came off.

The GLX is the fully loaded V6 model with 4motion. The GLS comes with a variety of add on options, but still not as equiped as the GLX. And the GL is just very basic... No leather, no power, no toys at all.

There are three T-25 head screws along the bottom of the inside door panel. Remove them. The face of the inside door handle is removable--just pry it off, probably don't even need a screwdriver to get it off. Underneath, you'll find two #1 Phillips head screws. Remove them. Finally, grasp the door panel from the bottom and pull up. It hangs over a little lip against the window. Watch the door lock, make sure the panel clears that. You should have access to all the wiring harnesses that keep the panel attached

The light cluster must be removed from the body. First, untuck and pull back the carpet on the inside of the boot where the broken light is. Carefully unplug the four-way connector from the light cluster. (If there is a safety catch on the connector, the connector can be gently removed by using a plain flat head screwdriver to slide the built-in switch on the connector all the way to OPEN, and then with your other hand gently unplugging the wired connector.) There are two plastic studs (or two metal nuts) securing the light cluster to the car which must be removed. (A nut remover in the form of a screwdriver will make your task a lot easier.) Once they are off, the light cluster can be easily removed from the rear of the vehicle. There are three plastic clips on the light cluster which must be carefully slipped off the bulb holder moulding to avoid breaking them off the light cluster. Once the bulb holder moulding is dismantled, you can see there are three bulbs in the bulb holder moulding. The rear light bulb and brake light bulb are both standard and are each rated at 12 V and 21 W. The third bulb in the centre is the indicator bulb and appears to be a quartz halogen lamp. To refit: Replace the broken light bulb. (It may appear burned out, or the filament in the bulb may be visibly broken.) Ensure the wired connector is pulled back into the boot so that it does not get caught under the light cluster. Refit the bulb holder moulding back onto the light cluster, ensuring that the plastic clips are engaged. Once the light cluster is in position, the two plastic studs (or two metal nuts) can be refitted. Plug back in the four-way connector and test the lights. Go and make a cup of tea, you deserve it.

replace o2 sensor behind cat.converter first, you probably do need a catalyst, the emission warranty for that is 8 years or 80,000 miles minimum and may be longer on some models so if you have less than 80,000 miles and the date car was originally purchased on is less than 8 years ago the dealer will replace it at no cost to you.

yes, u need to get a tow kit that will turn off yer spedo or just unhook the cables yourself (if a older beetle)