Chrysler

There are two bolts at the bottom of the back seat by the floor.......then you remove seat and take out the two bolts for the upper back seat and then you remove the back dash to get to the speakers! hope this helps

Kick it or change the buttons in the back of the clock

usually if you sit on it for an hour it will reset

i believe not 100% but sounds like a jeep 4.0 liter throttle body and probably 1992 or around there.

Low fluid, internal failure.

Put your keys in it.

If those were lost along with your FOB, contact a Chrysler dealership. They might be able to help you if you can prove ownership.

You have to jack car up on right side, take right front wheel off, take black plastic panel off that catches the dirt and pull battery out. The battery is located on the right hand side in the bumper, so that's how you get it out.

Rick - ATL - rwilson0476@yahoo.com

Could possibly be a bad lifter.

April 23, 1987

5*114.3

You more than likely have a loose ground wire, but it can also be a hot wire that is loose. Also check the fuse panel to see if the fuse is tight.

The steering gear is a rack and pinion type unit. To replace it:

1) Tie the steering wheel in place so that it cannot turn, then disconnect the steering column from the rack.

2) Disconnect the two hoses from the rack. Be sure to catch the power steering fluid and dispose of it in accordance with local regulations.

3) Remove the front wheels and the outer tie rod ends.

4) Lower the back half of the front subframe about 4 inches.

5) Unbolt the steering rack

6) Mounting hardware, then remove the rack.

7) Reverse this process to install the new unit.

8) Fill and bleed the powersteering fluid using the correct (+3 or +4) type of power steering fluid as specified in the owner's manual.

9) Set the toe-in.

Note that when starting the engine for the first time with the new rack it is critical to keep your body clear of the steering wheel. If you have accidentally reversed the fluid lines to the rack, the steering wheel may gyrate back and forth at high speed and with great force posing a risk of injury, or it can cause a hose to burst.

Evap Leak Monitor Pinched Hose on 2001 jeep wrangler 6cyl- where do I look to start troubleshooting or looking for pinched line? Evap Leak Monitor Pinched Hose on 2001 jeep wrangler 6cyl- where do I look to start troubleshooting or looking for pinched line? Check all the lines/hoses from the fuel tank to the engine.

Usually left side of steering column either in or near fuse box

Trouble code p1784 means: Pressure switch circuit: LR

When it has been pressed and the light is on, the transmission is limited to 3rd gear.

Chime

It should last the life of the engine. Which should be over 300,000 miles.

It should last the life of the engine. Which should be over 300,000 miles.

No. The Chrysler PT Cruiser was stopped in 2010.

Duff coil..?? Duff Engine Control Unit (ECU)

Have the abs computer checked for codes. There should be a code stored to indicate the problem.

Go to you local library and get the repair book, its free to use or a few cents to copy.

Here is a car code for Sunset Racer 2. Enter best-car ever to get the best car in Sunset Racer 2.

Ellis Kansas

If you are aking about the timing marks on the belt/chain. Then yes.

If you are aking about the timing marks on the belt/chain. Then yes.

It should have an tensioner pulley on it. A spring loaded arm that puts pressure against the belt as it travels. You may need to replace the pulley and spring if it is failing and allowing the belt to slip off.