0
Electric Windows
The first electric windows were introduced in 1940 as an alternative to the hand-turned windows. These car windows can be lowered and raised by pressing a switch or button. Electric windows are designed for convenience and safety.
2,720 Questions
Where can you get a diagram for the power window assembly on a 2002 Chevy Trailblazer?
You can get a diagram for the power window assembly on a 2002 Chevy Trailblazer in the owner's manual. You can also find it at select auto part stores.
How much to replace a BMW 325 driver's side window?
Depends on your location and whether you want new or used glass... the year of the vehicle etc... I've seen door glass used and installed as cheap as $80.00
Manually raise Monte Carlo power windows?
Take the switch out of the door and you can jump it just like you jump start a car.
Where is the power window relay switch located for a 1996 Ford Explorer?
According to the owners manual , there is an INSTRUMENT PANEL RELAY MODULE # 4 , that contains a large relay for Accy. Delay System Power windows , and 6 smaller relays for dimmer / battery saver system / one touch down / anti - theft system (2) / head lamp delay system The diagram arrow just points at the instrument panel , no specific location in the dash area of your 1996 Ford Explorer (Helpfull)
Your Toyota tacoma driver side window stopped working?
There are several possible issues when the window on just one side stops working. The most likely is a bad switch. Other possibilities are that the window motor has gone out or that there is a problem with the wiring.
Can you raise the window in my 1998 Pontiac transport van?
Yes, I can. Remove the plastic housing from the door with a screwdriver - it pops off/out. release the button/control housing allowing you to clearly see and work with the wiring harness. The button itself easily is removed from the harness connector [well it's not physically easy - you have to pull and rock it and watch the clasps meant to keep it in place.
When you have fully removed the 'button' you will have a connector with 7 wires - a clip - w 7 connecting points for the switch to slide in. Both ends are ground but connect a small piece of wire to Terminal 1 or the small black wire. Jump or connect the other end to terminal 3 [assuming skinny black wire on end is 1] Now with 1 + 3 connected or shorted - also connect with a separate jumber to terminals 3 + 4 - remember there are seven looking like this _ _ _ _ _ _ _. Short 1 and 3 and then short 3 to 4 giving power to motor with voltage polarity set for 'up'. IT's that simple. For Down - short same 1 +3 and then 4 + 5 as 'switch' giving power to lower window. Good Luck.
How do you roll up the window if the power window motor is not working on a '92 Honda Accord?
Remove the switch for the window, being smart about electricity, follow these instructions. power the motor by unplugging the switch, and using a 12 volt battery and some wire, touch posotive and negative tooposite sides of the plug. If there is no response you will have to disconnect the window from the regulator push the window up and support it with something sturdy until you can replace the motor. If the motor works. simply go to the nearest junk yard and get 2-3 window switches. keep changing them till one works. than put the switch back in the door. Good luck, don't melt anything. note: the ignition does not have to be on?
Replace the window regulator, it may come with the motor.
How do you test and replace the passenger side power window motor on a 1995 Mitsubishi Eclipse?
Before you try anything else,make sure the window lock switch on the driver side control is not turned off !
How do you remove the door panel to get to the driver side window on a 1995 Monte Carlo?
Remove all screws around the outer edge of the door panel. Carefully pry off the decorative cover behind the door handle and remove the torix screw. Lift up firmly on the door panel to remove. To reinstall, line up molded plastic hooks on back of door panel with notches in the door, push down to secure, reinstall torix screw, decorative cover and screws. Also before you lift away the panel, you'll need to undo the electrical connectors for the power window and door locks
check the circuit braeker
How to repair Power window off its track in a 2001 Pontiac Grand Am?
I have the SAME PROBLEM and it has taken us a week just to get the panel off you should email me at nfjgiuliano@yahoo.com when you figure that one out.
What is the switch for down the side of passenger seat on a daewoo matiz?
Maybe a security switch...inside you find a thermo reset...like that you find in hidraulics...
there's no note in the manual of Matiz....
this device swith off the 12 Volt of Fuel pump alimentation maybe when the car crash and the temperature rise , to avoid fire .
I had some problem with this because the car did't wont start alternatively and random..
I find this swith following the cables that are under the back seat of the car and go to the fuel pump.
The yellow cable is 12 volt from battery thru the fuel pump relay.
Aerosmith
Where is the power window relay switch in a 1991 Lincoln continental?
well, if my calculations r correct, behind the dashboard
Passenger window does not go back up it is a power window 2002 Chevy Venture?
Hi,
If the window goes down, but will not go back up, there are only a few possibilities of what could go wrong. These are:
1) Wiring between the driver & passenger side of the van.
2) One of the switches is going bad (driver or passenger side possible).
In order to find the problem, a little troubleshooting will have to be done. A simple multimeter would probably do the job. I have found a description of the system and a wiring diagram that should help figure this out, and I have provided a link to that below.
What you are looking for is power and ground at the passenger side connector wires when the switch is used. The ground signals actually have to travel from the driver side switch all the way over to the passenger side for the system to work, so I would start looking there.
Good Luck, Greg
Which fuse is for the power windows in a 1990 Camry?
it actually has breakers...where the drivers side kick panel is you will see a fuse box, just above that is another fuse box covered by a panel. it comes of by 2 screws. you will see that the breakers are round with a small hole. use something small(i used a dart) to push the button in the hole, thats it
Where are fuses for electric windows on a 1996 Isuzu Rodeo?
in the fuse box ,on the drivers side of the dash.it is a 30 amp circuit breaker.
How do you replace electric window switch in the drivers door on a 2003 crown Victoria?
If it's anything like my 2007 Crown Vic, which it probably is, the trim piece the window switch is attached to just pops right out in a upward motion. You might be able to grab a hold of it and yank it up, or at least start prying it up with a screwdriver first. From there it just unclips from behind. I just replaced my switch, took a whole 2 minutes.
1994 dodge dakota fuse diagram?
The fuse diagram on a 1994 Dodge Dakota is located on the inside cover of the fuse panel. It details the location and function of each fuse.
Where is a thermostat located on a 1999 GMC jimmy?
Follow the upper radiator hose all the way to the block. It is under the cast nipple mounted to the engine.
How do you repair the drivers window of a Crown Victoria that won't go down?
this works for all windows with the power up/down option
1. open up the door and verify that the window sissors is somehow broken. it can also be the cable to the up/down motor. (the cable has always been the problem for me)
2. go to ford and buy the sissors assembly (it includes the lifting mechanism and the cable to the up/down motor. costs around $50-$60. (you can buy replacement rivets for around 1.00 each, but you need an extra large riveter. these rivets are LARGE! (i didnt buy these)
3. remove several rivets holding the sissors in place. i used a grinder and a dremmel tool. and remove the sissors from the car.
4. paint the grinding marks that you made so they wont rust.
5. insert the sissors reverse of how you took it out.
l6. secure the sissors back to the door. you can use the factory rivets or do what i did (since i didnt have an extra large riveter). go to home depot and buy some nuts and bolts and secure with lock tite meduim. i feel this is a better solution to the rivets as no more grinding will be needed to perform future repairs. also clearance is not a problem so the nuts & bolts just made sense for me.
7. test your window and close up the door.
.
Dave
:
There are no scissors, there is a window regulator that has a pulley with cables and the window attaches to the regulator with rivets. You will need a drill to remove the rivets, two for the window and two for the lower part of the regulator. First, remove the window motor, shiny brass screws that are torx bit mainly and there should be three. Now, you will be able to maneuver the window and it has to be positioned in the openings where the rivets are accessible. On the drill, you use a drill bit that is larger than the head of the rivet and drill off the head only and the rivet will fall out. Caution I have seen people drill through the rivet and shatter the window, so be CAREFUL. Now you maneuver the window out of the door, then you drill rivets out of the lower reg. There are also two nuts that hold the regulator as well. I would not bother doing rivets during installation, I just use screws, nuts and washers. Remember to save the white plastic window protectors when installing back together.
How do you replace the front seat drivers side in a 2000 Grand Am?
there are 2 14-15 mm bolts on the back floor then the seat slides out towards the back seat and then unplug the power plug on the bottom
Where can you find the relay for power windows on 95 Chevy Astro?
These relays (For factory installed power windows) Should be located with the power door lock relays, just under the dash on the passenger side of the vehicle, part way behind the kick panel. These relays will be mounted to a bracket.
How do you fix power window on a 1993 olds cutlass supreme?
maybe you can look in the fuse box located under the glovebox and replace the electrical fuse.
