0
Turn Signals and Hazard Lights
Turn signals and hazard lights refer to the lights on an automobile designed to alert other drivers or pedestrians. Turn signals indicate where the vehicle intends to go, while hazard lights warn others of an emergency.
4,468 Questions
What would cause my brake lights not to work if not the switch or fuse?
- Damaged or burnt wiring
- Bad or corroded earth connection in the brake lamp cluster
- Failed bulbs. (although it's unlikely that all your brake lights have blown)
You can use a meter and a volunteer to check that power is reaching the bulb holder. If power is reaching the bulbs and they are working, then a bad earth connection may be the cause. Corrosion around the lamp cluster is a common cause of this. There may be problems with the other lights if the vehicle has a shared lamp cluster
At any rate, it wouldn't do any harm to let a vehicle electrician take a look
How do you replace the front turn signal bulb located on a 1999 Honda Civic?
Turn the wheel to the left if changing the passinger side bulb and to the right if changing the drivers side bulb. Remove the pop out plug holding on the plastic wheelwell cover, reach in and turn the bulb holder a quarter turn, replace the bulb and re-assemble.
What would cause your left turn signal and right running lights to not work on a 2004 GMC Jimmy?
Our 04 Envoy had a recall on turn signals and tail-lights, they just had to replace a relay. I would check with your dealer to see if your vehicle has been recalled.
How do you change right signal bulb on a 1988 Chevy blazer?
I haven't done this on my Blazer yet but my manual says to reach up behind the bumper to the light socket, twist it and it will come out of the housing with the bulb so you can change it.
Instructions on how to replace right rear turn signal light bulb?
Inside the trunk of your car there will be approx. 4-6 plastic screws
located on the wall of the trunk that's holding the trunk panel in
place. undo those screws and you will find access to the tail light
assembly. turn the plastic cap that connected to the bulb counter
clock wise, it then will give you access to the tail light bulb.
Where is the turn signal relay in a 93 subaru legacy located?
The turn signal relay for the 1993 Subaru Legacy is located behind the left hand instrument panel. Look on the left hand side of the steering column.
How do you replace the front turn signal bulb located on a 1986 Honda Accord LX?
open your hood and there should be a screw in the corner of the turn signal and it should slid right out
Here is what I had to do on my 1988 Accord1. Open the retractable headlights.2. Remove the plastic shroud around the headlight: two screws in front and one on each side.3. Look to the outside of the headlight and you will see a single screw in a small plastic cover on the front inside edge of the signal light assembly. The headlight prevents you from getting at the screw straight-on. I broke it loose with an offset Phillips screwdriver, and then backed it out with a regular Phillips.4. Remove the plastic cover, and you will see two screws. Remove them.5. Now you can pull the turn signal assembly forward and out.6. To remove the bulb holders from the assembly, twist counterclockwise and pull out.7. Pull straight outward to remove the bulbs.To assemble, follow the steps in reverse. Note that there are two plastic rods on the back end of the turn signal assembly that you will insert into two holes in the channel of the fender.Where is the turn signal flasher relay and emergency hazard relay located on a 2000 Ford explorer?
Go to www.autozone.com and click on repair information, and then component location. They will have the location listed.
Where is the blinker relay on a 2004 Chevy Impala?
It is integrated into the hazard switch on the dashboard
How do you replace turn signals in 2009 dodge 1500 external rear view mirror?
2009 Dodge Ram 1500 turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Where is the turn signal flasher on a 1995 Crown Victoria?
How do you replace a turning signal light switch and cruise control and hazard flashing light?
replacing the multi function switch is not hard. just replaced mine last week in 0 degree temps. disconnect batt. (UNDER BACK SEAT) take out fuse for airbag,take shroud around steering column off,along with the kick paneland metal panel under that off, dimmer light switch and truck release pull these straight out they just pop out.there are 2 screws that hold turn signal switch and wiper switch on.(wiper switch must come off in order to get turn switch off) follow wiring harness down to tie in box 1 screw holds this to fire wall take this off the 2 outside wiring plugs come off by prying bottom of plugs up they slide right out.theyre 2 wires thatgo up to the ignition that need to be put in the new harness on new switch. these come out by sliding flat piece of metal in back of plug and pulling wire out at same time. there is a locking tab so they cant be pulled out this must be pushed in in order for the wires to come.make sure wires go intosame spot they came out of.put new harness in the block and bolt back to plug in box.bolt switch back on steering column put everything back togehter make sure horn pin on new switch is pushed in and making contact on metal ring or horn wont work hope this helps replacing the multi function switch is not hard. just replaced mine last week in 0 degree temps. disconnect batt. (UNDER BACK SEAT) take out fuse for airbag,take shroud around steering column off,along with the kick paneland metal panel under that off, dimmer light switch and truck release pull these straight out they just pop out.there are 2 screws that hold turn signal switch and wiper switch on.(wiper switch must come off in order to get turn switch off) follow wiring harness down to tie in box 1 screw holds this to fire wall take this off the 2 outside wiring plugs come off by prying bottom of plugs up they slide right out.theyre 2 wires thatgo up to the ignition that need to be put in the new harness on new switch. these come out by sliding flat piece of metal in back of plug and pulling wire out at same time. there is a locking tab so they cant be pulled out this must be pushed in in order for the wires to come.make sure wires go intosame spot they came out of.put new harness in the block and bolt back to plug in box.bolt switch back on steering column put everything back togehter make sure horn pin on new switch is pushed in and making contact on metal ring or horn wont work hope this helps
Where's the flasher on a 1996 Ford Contour?
The flasher is located on the back side of the fuse box uder the dash on the dirivers side. The flasher is in the steering colum.
My flasher was in the upper left hand side under the dash. Over the steering column. The four way flasher is the lower and the turn signals is the upper flasher.
Where is the fuse box on 97 cougar xr7?
On a 1997 Mercury Cougar :
The fuse panel is under the dash , on the drivers side
Also , the power distribution box ( which is " live " ) is located in the engine
compartment near the battery
How do you replace a signal switch on a 92 Chevy silverado?
Pull the steering wheel. This requires a puller and a lockplate compressor.
Once the wheel and the lockplate are off , there will be three screws holding in the switch. The cable is threaded down the steering column and the connector is about halfway down the column just beyond the edge of the dash.
Where is the turn signal flasher relay and emergency hazard relay located on a Chevy Colorado 2006?
According to my local chevy dealer, it is the emergency flasher relay button and flasher assembly all combined. $75.24.
Where is the turn signal flasher on a 1996 Honda Accord?
its right above the kick panel the first black relay if you pull it out it says turn signal on the panel
change the turnsignal switch i have done this several times, my tracker has 335,000 original miles
How do you change the front turn signal on a 2002 VW Beetle?
The front turn signals on my 2002 Beetle Turbo S can be popped out by carefully inserting a flat screw driver on inside the lower edge and pressing down on the metal spring clip that holds the signal lamp assembly in. It will then pivit up and out. It's pretty simple, but be careful not to scratch your paint.
