0
Chevy Blazer
The Chevy Blazer may refer to any of the sport utility vehicles manufactured by the Detroit-based automaker General Motors Company. Some of the popular Blazer models produced by the company are the TrailBlazer, the S-10 Blazer and the K5 Blazer.
5,824 Questions
In past experience I either took the shifter out of park put it in drive, then firmly put it back in park then try and turn off and remove key. The other is possibly your ignition tumbler is loose like our 1998 in that case you have to be gentle and try to slide the key while giving it a little jingle. I'm not kidding, we really have to do that! Good Luck!
How much is a 350 4 bolt main motor block worth?
If it's not cracked and is still stock bore, About $ 125.00
Where is egr solenoid on 3800 SERIES II?
The EGR (Exhaust Gas Recirculation) solenoid on a 3800 Series II engine is typically located near the front of the engine, mounted on or near the intake manifold. It is connected to the EGR valve and is usually positioned on the driver's side. To access it, you may need to remove some components for better visibility, depending on the specific vehicle model. Always refer to the vehicle's service manual for precise location and removal instructions.
You might try to jiggle the steering wheel a little, press the brakes while you try to start, and make sure your car is in park.
Where is the oil filter located on a 1995 Chevy Blazer S-10?
It will be on the lower left rear side of the engine next to the oil pan. You will have to crawl under to see it.
AnswerI found out the oil filter is located under a splash cover right behind the bumper,It says "oil filter access panel!Yes, its located under a cover behind the front bumper, and it does say "oil filter access"
i had the same problem with my 97, ended up being the negative battery cable was loose. tightened it up and it worked fine afterwards
Answer yes it did work removing the cap and using screwdriver what i did was extened the legs on the cay reenserting cap so the button stays in and i can now freely remove the keySame thing happens to my 97 I fould out there is a "plunger" as part if the ignition. Under the steering wheel there is a small removable cap that you can take off and put a small screw driverf up into and press the plunger in and it will release the key. I think there is some electrical connection between the shift lever and the ignition. Mine has a floor shifter I am not shure if it is the same for a steering col set up good luck hope this helpsDW
AnswerI also have the same problem with my 97 Blazer with floor shift. I found the plug and inserted the small screwdriver and my key comes right out :-). Thanks...Now I just have to firgue out how to fix it so I do not have to do this all the time.ANSWER
Small hose clamp around bottom of the plunger housing just under the plunger. Adjust as necessary. Key will come out no problem. Fixed my 97 Jimmy this way. Found the info on a Pontiac Grand Am site. I believe this problem really stems from the switch on the shifter though. I am now unable to get my key to turn away from the run position. Have to remove fuses to shut down vehicle.
Why does your 1989 s-10 blazer hiss when you let off the gas?
I Hope I Don`t Mess You Up. But This Sounds As Though You Have A Vacuum Leak. GOOD LUCK
Those are two different problems...
If it's smoking in traffic, it could be from many things...
If the smoke is coming from under the hood, you might have an oil leak that is dripping onto the exhaust.
If it's smoking from the tailpipe, odds are, your rings / compression is gone and the oil is blowing by the rings and getting burned.
Cubic centimeter as related to engine horsepower?
Generally speaking the larger number of CC's you have in an engine , the greater the horsepower will be. Most North American Engines used to all be rated in Cubic inches now we rate them in Cubic Centimeters.
What would cause a car to stall out on the highway?
fuel pump or fuel pump relay...ignition module...crank sensor...most likely fuel pump though. take small rubber hammer along with you and beat the hell out of gas tank while your buddy tries to start car. if car wont start until you wake up pump(which is inside tank) by striking tank, then it is the problem.
A very dirty fuel filter is another possibility.
How much does an engine for a 1996 Chevy blazer cost?
It depends on where you get it. You can often get an engine for anywhere from $1,000.00 U.S. to $2,000.000 U.S. or as little as $500.00 if you buy a used engine at a wrecking yard, plus labor to replace and peripherals such as water pump, thermostat, hoses, plugs, wires, oil filter and anything else that you might want to replace at the time. However, a replacement engine gives you a vehicle that will be quite reliable for years to come.
How do you shut off the service engine soon light on 1999 blazer?
It will do no good to turn it off, It will just come right back on if you didn't fix the reason and problem that made it come on.
There is a problem with the emission system or Transmission. You need to have the engine scaned with a OBD2 enginer scanner to see what is wrong. Some parts stores will scan it for free just call some and ask them if thay can scan it for you. You will need a scanner to turn it off.
What would cause the enginge to run rich and studder?
You may want to check the MAP (Manifold Air Pressure) located on the fire wall. There should be two rubber lines coming from it. Located just on the passenger side of the center. the temp sensor could also be the problem. its located near the thermostat. when the sensor is bad the computer is reading the temp as negative 40 degrees. its a little cheaper than a map sensor.
Where are the fuses for power seats on olds 1998?
On the GM's that I am familiar with the fuse box is underneath the dashboard to the left of the brake pedal. It usually has a black cover with 2 finger-sized tabs. gently squeeze these toward each other (unless the cover says otherwise) and it should pull right off. If you have the owners manual it will also give you this information plus exactly here the fuse you are look for is, how many amps it is and what size it is. If you don't have the manual, some GM's abbreviate what the various fuses are for and what amps they are right on the fuse block.
How do you open the hood on a 1998 blazer when the hood release below the dash is broken?
Very simple, have somebody pull on the release from inside either with the plastic lever or with a pair of pliers while you push up and down on the hood. It will jiggle loose. also pound on it with your fist
What do you do if a 1998 Chevy Blazer will turn over but will not start?
fuel problem. make sure you have gas of course, check out your fuel pump, injectors, fuel lines etc.
Is there a way to manually lift the driver side window on a 1995 Chevy Blazer?
TAKE OFF THE DOOR PANEL STICK A A SCREW DRIVER IN ONE OF THE HOLES TO GET UP UNDER THE GLASS PUSH THE GLASS UP SLIGHTLY UNTILL YOU GET AHOLD OF THE GLASS THROUGH THE TOP OF YOUR DOOR U CAN THEN PULL UP ON THE GLASS TILLL YOU GET IT WHER U WANT IT U MAY HAVE TO DRILL A HOLE IN THE TRACK SO THAT THE WINDOW DOES NOT FALL BACK DOWN I DONT REMEMBER EXACTLY HOW IT LOOKS
How do you change the bcm on a 2004 trail blazer 4.2?
To change the bcm in a 04 Chevy Trailblazer you have to flip up the back drivers side seat cushion and it's under there. First you take off the black plastic cover then you will see the bcm on the fron side of the fuse box, more near the drivers seat. It has a lock bar that must be pushed towards the passenger side of the car, it has a green electrical connector that pops out and 2 connectors that pop out so a total of 3 electrical connectors have to pop out to remove the bcm.
Hope this helps.
How do you remove the dashboard on a 1993 Geo Storm 1.6?
The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
