0
Ford Escape XLS
The Escape XLS is a compact crossover sport utility vehicle manufactured by the US-based carmaker Ford Motor Company. This vehicle is powered by a 2.5 L 4 cylinder engine and features traction control, stability control and curtain/side airbags.
873 Questions
what causes staring is when you're different. For example you are handicapped or are ugly etc etc.
Try when this happens to betend that you don't see the person staring and then they might not stare at you.
What size and type of tool is required to remove the bolts holding the 1995 ES300 calipers in place?
17 mm wrench or socket
It is an easy fix even for 1st timers. The biggest thing is the surfaces on the head and the valve cover must be clean. Be very careful when removing the covers they may be stuck and require a little jarring to loosen, but do not bend them. CLEAN CLEAN CLEAN. make sure all particles of old gasket are out of the head. When replacing the covers I use very little if any gasket sealer. I like to tighten the bolts just holding an extention and socket in my fingers. Then alernate top front, bottom back...... but not tight. I hold the rachet head, not the handle in the palm of my hand. I just did the valve covers on my 305 1889 chev, the correct torque settings or so i was told is hand tighten then torque to 40lbs if this is due to a leak i also would check the valve covers as well good luck
Where is the cabin filter located in 1999 Chevy Tahoe or isn't there one?
I havn't checked mine yet...but the guy at Jiffy Lube told me that it was up under the glovebox.
How can you tell when a PCV valve is bad?
I have read that a bad PCV Valve will contribute to gunking up your Throttle Body, which could lead to irregular acceleration issues. I am certain that there is more to a bad PCV Valve than that, as this is an Emission Control item, but hopefully someone who knows more will chime in.
SUBMITTED: Friday, 03JUN11
Whats is the fuse box layout or diagram for a ford escort se 1998 model?
I spent hours looking for this layout this morning as I was unsure of some of the pictures on the back of the fuse box cover. I had no luck. I own a 1998 Ford Escort Finesse 1.6. I eventually found my manual and decided there are some things you can't find on the net. I am therefore typing it up for the next person who is looking for it so they can find it on the net.
Jenny
Ford Escort Central fuse box.
Fuse number Rating Amp Circuits protected
1 30 Starter solenoid
2 25 Heater blower, air conditioning clutch solenoid
3 15 Headlamp switch
4 10 Side light right-hand side
5 15 Main beam left-hand side
6 15 Main beam right-hand side
7 10 Side light left-hand side, auxiliary driving light
8 7.5 EEC lV module
9 20 Anti lock braking system
10 30 Headlight washer system
11 7.5 Air bag
12 10 Control lights, main beam switch
13 15 Diesel fuel filter heater
14 15 Fuel pump
15 10 HEGO sensor (catalytic converter)
16 20 Cold start valve, engine management
17 15 Heated seats
18 15 Supplementary radio equipment
19 30 Electrically operated front windows and sliding roof
20 30 Cooling fan
21 7.5 ABS module
22 20 Ignition coil
23 25 Electrically operated rear windows
24 30 Anti-lock breaking
25 20 Wiper motor, screen washer
26 10 Direction indicators, reversing lights
27 25 Heated rear screen and exterior mirrors
28 15 Horn, hazard flasher
29 15 Interior lights, cigar lighter, radio, clock
30 10 Dipped beam left-hand side
31 10 Dipped beam right-hand side
32 15 Fog lamps
33 20 Electrically operated seats
34 15 Heated washer jets, brake lights
Auxiliary fuse on the rear of the fuse box (under bonnet)
35 20 Central locking
I spent hours looking for this layout this morning as I was unsure of some of the pictures on the back of the fuse box cover. I had no luck. I own a 1998 Ford Escort Finesse 1.6. I eventually found my manual and decided there are some things you can't find on the net. I am therefore typing it up for the next person who is looking for it so they can find it on the net.
Jenny
Ford Escort Central fuse box.
Fuse number Rating Amp Circuits protected
1 30 Starter solenoid
2 25 Heater blower, air conditioning clutch solenoid
3 15 Headlamp switch
4 10 Side light right-hand side
5 15 Main beam left-hand side
6 15 Main beam right-hand side
7 10 Side light left-hand side, auxiliary driving light
8 7.5 EEC lV module
9 20 Anti lock braking system
10 30 Headlight washer system
11 7.5 Air bag
12 10 Control lights, main beam switch
13 15 Diesel fuel filter heater
14 15 Fuel pump
15 10 HEGO sensor (catalytic converter)
16 20 Cold start valve, engine management
17 15 Heated seats
18 15 Supplementary radio equipment
19 30 Electrically operated front windows and sliding roof
20 30 Cooling fan
21 7.5 ABS module
22 20 Ignition coil
23 25 Electrically operated rear windows
24 30 Anti-lock breaking
25 20 Wiper motor, screen washer
26 10 Direction indicators, reversing lights
27 25 Heated rear screen and exterior mirrors
28 15 Horn, hazard flasher
29 15 Interior lights, cigar lighter, radio, clock
30 10 Dipped beam left-hand side
31 10 Dipped beam right-hand side
32 15 Fog lamps
33 20 Electrically operated seats
34 15 Heated washer jets, brake lights
Auxiliary fuse on the rear of the fuse box (under bonnet)
35 20 Central locking
----------------------------------------------------------------------------------------
You can view the 1998 Ford Escort owners manual ( for NORTH AMERICA ) online at :
www . motorcraft service . com ( no spaces )
Click on Owner Guides
( the fuses and relays section starts on page 106 )
Helpfull
What does Ford escape airbag code 46 mean?
It is a loose connection under the drivers seat toward the back of the seat. Disconnect it, make sure it is clean and reconnect. That should solve the problem.
Hey! This worked for my '99 Ford E250 van too! Thanks!
No, sorry. It means get ready to let her off at the next corner.
Mike McMac
Where is Location of cylinder number 6 on 2001 escape?
Looking from the rear(driver side)...#1 is on the right near passenger...#3 is closet,
then #4 is on left driver side...thus #6 is on left side(front of engine, driver side)
Hope this helps.
J
Where is the number 6 cylinder located ford f159 2001?
On a 2001 Ford F-150 :
4.2 liter V6 engine
firewall
3 - 6
2 - 5
1 - 4
front of vehicle
-----------------------------------------------
4.6 and 5.4 liter V8 engines
4 - 8
3 - 7
2 - 6
1 - 5
front
Does a 2003 ford escape have a timing belt or a chain?
The 2003 escape has a timing belt - but it is not the sort of belt that can cause havoc and internal damage to the engine if it breaks. If it breaks, the engine simply won't run until you replace the broken belt - but the engine won't slam into itself - as it were.
What is the oil capacity of a 2000 Ford Ranger 4 cylinder 2.5 liter engine?
According to the 2000 Ford Ranger Owner Guide :
With engine oil filter change :
The 2.5 liter four cylinder engine takes ( 4.3 liters / 4.5 U.S. quarts of 5W-30 )
What is the torque of the engine oil drain plug on a 2005 Honda Civic?
A little late to the party; however, I think I’m just in the nick of time to save someone time and $$. The CORRECT answer, per the manual is: 33lbs/ft for all trim levels (ex. DX, LX), with the exception of the EX that only gets 29lbs/ft.
How do you change the EGR valve on a 2002 Saturn SL1?
Quite easily take off the air breather tube then there is a cone shaped part with a connector on top at the back of the engine rightby the accelerator cable 2 10mm bolts hold it on take off the 2 bolts and the valve comes off
Why does my car shake while idoling?
Vacuum leak is one cause.
-----
Another possible cause may be a bad Idle Air Control Valve (IAC Valve).
Your car should Idle, once the engine is at operating temperature, between 680-750 RPM. If the engine idles below this range with no appliances on, i.e. Air Conditioning, Fan or Window Heat, then your IAC Valve may have gone bad.
SUBMITED: Friday, 03JUN11
How do you change the PCV on a 2002 Jeep Liberty 3.7 engine?
it is located on the left of the oil filler cap.Pull the vacumm hose of and turn counter clockwise,then pull out.
Hair clogs it up. Every 3 mos or so, pour draino or something like it down the drain. the debris is exactly that. its hair or other stuff that floated up when the trap backed up.
Would liquid glass work if you have water in my oil?
If the radiator is not being pressurized from exaust than it should. As long as the coolant is going out of the system either in the oil or out the exaust it has always worked for me. If exaust is getting into the coolant the liquid glass has no chance to plug the leak. With the engine cold, take the radiator cap off and crank the motor. You will know quickly if it will work. Water either shoots out the radiator or doesn't.
What is the definition of Trouble Code P2195?
A HEGO sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.
What is the cylinder location 3.0 ford?
"IF" this question is asking what are the cylinder numbers...
Front Wheel Drive:
________
1 2 3
4 5 6
-------
Front of Vehicle
Rear Wheel Drive:
________
3 6
2 5
1 4
-------
Front of Vehicle
Firing Order
1-4-2-5-3-6
On a 93 3.4 l v6 camaro what does the abs inop light mean on the dash?
ANSWER
Check to see if you have a rear brake light/taillight out. If so...replace the bulb. My 94 had this problem and the cruise went out and the light came on...replacing it fixed it
Answerantilock brake system inoperable. If your lucky, you just new brakes and/or rotors. Can also be deeper like speed sensors or electrical problems.Thanks, I also had the abs inop light and no cruise and ckecked spoiler brake light and both were out fixed 94 chev camero z28 350 Thanks Also had before no cruise and no a/c went to the dealer could not fix but said to try to replace the computer, I sanded the pins on the computer as a last resort with very fine 400 to 1000 grit ok everything worked perfect. If all fails sand pins on ecu
How do you replace the CV axle on a 97 elantra?
* Remove the wheel cover or hub cap.Remove the cotter pin * Break the hub nut loose with a socket and large breaker bar NOTE: If the socket will not fit through the opening in the center of the wheel install the spare * Loosen the lug nuts raise and support car securely on jackstands.Remove the wheel and drain the transaxle lubricant. * Detach the stabilizer bar link(s) from the control arm(s) * Separate the lower control arm from the steering knuckle.Now remove the driveaxle/hub nut * Swing the knuckle/hub assembly out (away from the car) until the end of the driveaxle is free of the hub.If the driveaxle splines stick in the hub tap on the end of the driveaxle with aplastic hammer.Carefully pry the inner CV joint from the transaxle using a large screwdriver or prybar positioned between the CV joint housing and the transaxle housing.Support the outer end of the driveaxle with a piece of wire to avoid unnecessary strain on the inner CV joint * Support the CV joints and carefully remove the driveaxle from the vehicle
