0
Turn Signals and Hazard Lights
Turn signals and hazard lights refer to the lights on an automobile designed to alert other drivers or pedestrians. Turn signals indicate where the vehicle intends to go, while hazard lights warn others of an emergency.
4,468 Questions
I have the same sound in my 2003, Pontiac Grand AM. I am unable to located were it is coming from?
Where is the turn signal relay in a 99 f550 located?
well first check the fuse if good the relay is behind the dash so climb under streering wheel and look up behind the dash to see the relays there.
How do you change the front turn signal on a 2006 Chevrolet Express?
The lense has a clip on the outer side that needs to be pushed in with a flat head screwdriver to release. The entire lense pulls out and the bulb socket is accesable from the back. To replace just hook the inside edge and clip it back in place.
How do emergency signal devices work?
Emergency signaling devices work differently depending on what type they are. There are hand-held devices that will signal location services to emergency vehicles like police and fire. There are transmitters for air services that broadcast a distress signal. There is a beacon that ships use that transmits on radios.
You would normally find it under the dash near the steering column. It is not in the fuse panel. It's left of the ashtray. Turn on the hazards and listen, the turn signal and 4 way flashers are side by side. You don't say what kind of vehicle you have, but if you are looking for a stand-alone flasher unit on late model Ford, Mercury, and Lincoln vehicles, you won't find it. It is incorporated within the hazard flasher swith, located on top of the steering column. This is a multi-function switch that controls turn signals, brake lights, and emergency flashers. If these lights are not working, a quick fix is to spray WD 40 around the switch. Then push it down with your thumb and let it pop up several times and also wiggle it around a bit.
How do you replace the front turn signal bulb on a 2002 suzuki XL7?
Your dealer should do it because the grill and radiator must be removed to get to the turn signals.
How far in advance should you signal before making a turn?
200 feet before the turn according the the IL driving school test answer (1 city block)
I hope someone answers your question because I have the same car with the same problem.
I already had a connector it the car for trailer lights. It used to work & seems to still be working. But when Haul plugged in trailer lights to it, our turn signals stopped working. The connectors from the trailer were real ratty; I wouldn't be surprised if they hooked up something backwards. They also had to run a separate ground wire to get the lights on the trailer working. I think they had the turn signals working at some point when they were hooking it up.
Symptoms (all started when trailer hooked up):
- Turn signals completely dead. No lights, no flashing, no turn indicator lights on dash board.
- 4-way flasher also completely dead.
- Alternator light on dash & brake warning light on dash both on.
- Problem same whether trailer hooked up or not.
Things that still work:
- Brake & parking lights work fine on car & trailer. I repaired the connections on the cable coming from the trailer and it seems to be wired correctly. I tested the trailer lights with a spare battery and they light when they should.
- All fuses visually look good (both the ones next to driver & the ones under hood).
- UHaul connector installed on car has built in indicator lights (wonderful feature!). Lights come on when they should for parking & brake. But they don't come on for turn signal, which is no surprise.
I can't find the flasher (if there is one). I can't find my owner's manual. I can't find any clues or fuse diagrams on the Web. (Google has a lot of strange Russian websites that don't have anything to do with the car-annoying.
Help!
============================
Richard, did you ever find out a reason for this? I have exactly the same problem.
rick
Possible solutionTry the hazard switchthis cuts out the supply to the indicators to prevent overloading the circuit
if the switch has gone faulty the indicators do not normally work.
Where is the flasher unit on a 80series landcruiser?
In an 80 Series Land Cruiser, the flasher unit is typically located under the dashboard, near the steering column. You may need to remove the lower dash panel to access it. Look for a small, rectangular relay that is usually plugged into the fuse box area. It can also be found in the vicinity of the turn signal switch.
Blinker light work but does not blink?
check your relay to the blinker. its wat makes it go on and off
Turn signal flasher 1995 grand am?
It is located behind the fuse block on the driver's side. When you open the drivers door you can plainly see the fuse block. (marked "FUSES") Flasher is behind that. You have to get to it from unde the dash. Take out panels under steering wheel. If you get your head down by the brake pedal you can see it. When I changed mine, I took out the little bracket that holds it in and relocated it to a lower place. I clipped the flasher bracket onto the little access door closest to the emergency brake (on the panel that you have to take out). Luckily the wires were long enough to enable this, so if you have to change it again, it's alot easier.
How do you replace multifunction switch on 2000 catera?
remove knee panel under steering column. remove cover above pedals. It is a black 2-3 inch box generic looking and it is mounted on a metal tab. just wiggle and it should release. this is a common cause for failure in radio, fuel door button, and truck button on dash.
Open trunk & pull away carpet from behind the lights.
How do you replace signal light flasher on 1999 blazer?
The signal and 4 way flashers are behind the plastic lower dash panel, aprox under the radio. The lower dash panel must be removed to gain access.
Will the flashers and turn signal work at the same time on a kenworth t800?
No. The four ways will take priorty over the turn signal.
Where is the flasher on a 1999 Pontiac Firebird?
on the drivers side nearest the console it is on a clip under the dash
How to get at flasher what needs to be removed
Change the blinker bulb for that side. It is a hit and miss though. If you change the front bulbs and it still doesn't blink you will also need to change the rear bulbs. The front bulbs are rather difficult to change from above the vehicle. You may want to get underneath and definitely during the day!!! THE REAL ANSWER!!!!!! This drove me crazy on my daughters car. It turned out to be the day time running light modual wich is located behind the radio. the conections were loose. when you turn on the right turn directional the front light would go out but the rear directional would work. listen closley behind the radio for a one click noise when you activate the right turn, and also a delay one click when you deactivate.
Where are the turn signal fuses on a '98 Intrigue?
The turn signal fuse in on the fuse panel located on the right (passenger) side of the dash. Open the passenger door and remove the panel on the side of the dash to expose the fuses. The turn signal fuse is on the left side of the fuse panel. The owner's manual has a map of fuses (pg 6-66).
How do you fix a stuck turn signal?
To fix a stuck turn signal, you may need to replace the whole switch. A switch can be purchased at any auto parts store.
E-flasher work turn signal doesn't 1996 Cherokee?
OK, it is not a flasher in the common sense, but rather a relay that plugs in just above the fuse box. You must remove the fuse box cover panel and then the kickpanel cover, which has two screws and all located behind the passenger side kick panel. I have ordered the relay from Jeep and the part number they provided is: 56007243, which is the flasher for both the turn signals and the emergency flasher. The part should be here in a couple of days and if any of this changes I will update this posting.
