The 1988 Honda Accord coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
How do you install a new antenna on a 1988 cabrio?
1) Pull the driver's side front wheel off. 2) Remove the wheelwell liner (may need to remove the fender flare to do this). 3) Remove antenna retaining hardware. 4) Remove radio head unit from dash to remove the antenna plug. 5) Pull antenna wire through firewall and dash and remove from car. Installation of new antenna is basically the reverse of removal.
Where can you find the fuse diagram for a 1986 Mercedes 420 sel?
if you still need the fuse diagram, you can contact me through email...nlp (at sign) vitiligocover (dot) com
How do you open fuel door on a 1999 vw cabrio?
I have a 2000 Cabrio and you push on the side of the fuel door that is closest to the front of the car and it will pop open. I am not sure it they are the same but I would give it a try.
How do you replace front wheel bearing on 2000 VW Cabrio?
you take it to a place that does that kind of stuff.
If you don't have the manual (which will have the code in the section for the stereo) call the Delaership with the car's VIN and they can look up the safe code
How do you turn of the running day light in 2002 cabrio?
the running lights can not be turned off. they are safety features and cannot be by-passed
Where does the antifreeze go in a 1996 VW Cabrio?
In the engine compartment on the drivers side towards the back of the car there is an overflow reservoir. The reservoir is a sphere, off-white in color and has a 3" diameter black cap that screws on. The cap made to loosen by hand, but usually takes a lot of strength and grunting to remove.
WARNING! Do not remove the cap if the engine is warm, hot coolant may spray out and cause severe burns!
There are coolant level marks printed on the side of the reservoir. Because of the age of the plastic reservoir, it is no longer transparent. This means the coolant level cannot be checked without removing the cap an looking inside.
Where is the crank sensor located on a 1999 Saturn SL2 and how do you change it?
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor
Does anyone know where the backup light switch is on a 1968 Mustang with a 289 and C4 transmission?
It should be on the left side of trans where the shift levers are. It is called the neutral safety switch and the backup light switch is built into the same switch. So, this switch allows your car to only be started in park or neutral and when in reverse, it will turn on the backup lights. There are four wires on the neutral safety switch with a square connector on the end.
How do you change the daylight running lights on a 2001 Chevy Suburban?
Lift the hood and behind the headlamps there are two L shaped rods that insert into the harness of the head lamps. Rotate the rods toward the grill, this unlocks the rods. Next remove the rods and this frees up the head lamps. Remove the headlamps from the grill allowing for access to the daytime running lamps. I left the headlamp wiring harnesses intact. The daytime running lamps have a lever that you push to unlock and then rotate to release and then you can change out the bulb easily. Reverse steps to replace lamp assemblies. This was a difficult find until I caught on to the above and then took less than five minutes. Have fun.
Where is the plug to get code for check engine light 1998 vw cabrio?
To the right of the rear window defroster button, behind a plastic cover. Just pop it off with a flat head screw driver.
On my 1998 Cabrio, I found it to the right of the ash tray. Remove ash tray then slide the cover to the immediate right of the ash tray to the left to reveal the OBDII connector.
Air filter removal in vw golf 1.6 xreg?
Removing an air filter from a 1.6 liter VW Golf requires access to the engine compartment. First lift the hood and locate the air box. Remove the screws and air tubes and lift the cover up. The air filter will be inside.
Where do you hook up an OBD code reader on a 1999 Volkswagen Cabrio?
The 1999 Volkswagon Cabrio OBD 2 port is under dash at left side
Where do you hook up an OBD code reader on a 1997 Nissan Maxima?
There should be a plug adapter spot right under the steering wheel and dash assembly, should just plug right in... i have a 96 and i work at O'Reillys auto parts, we have a code reader that reads all nissans from 88 to current....so if is the right code reader it should just install as i said above hope that helps a little
How do you change air filter on 2001 volkswagen cabrio?
the air filter is in a black box with a big hose on it, going to the engine...and a couple of clips holding it on...unclip the box lid, and lift gently so as not to damage any hoses....wiggle out the filter and slide in the new one....re-clip...and be happy:) also, you should be able to find a shop manual at the library, you'll have to make copies of the sections you want as they are reference only, but everyone should have a regualar manual for their vehicle, available at an auto parts store....may the force be with you :)
P0171 is system too lean, P1476 and P0440 are related to an evaporative system leak, and P1582 is idle adaptation at limit. You either have a leak in a vacuum hose or evaporative hose or a bad leak detection pump.
Where can you get a fuse box diagram for an 1998 volkswagen cabriolet?
I went to the public library and found the maintenance book will all the diagrams needed. I went to the public library and found the maintenance book will all the diagrams needed.
Were do you add transmission fluid in a 98 Cabrio?
On the VW automatic transmission of this generation vehicle, the transmission is supposed to be serviced only by VW, so there is not the typical dip stick tube that comes up into the engine compartment. You can check the fluid and add if needed through the fill spout, under the car, located directly on the transmission pan. There is a short 2" tube with a red cap, unscrew the cap which also has a fluid level indicator attached, similar to a power steering dipstick. To add fluid you will need to pump it in with a hose attached to your container. Regards. BDBENZ
Why won't the passenger side power window go up evenly?
There are a few things that could cause this problem. The motor is wearing out, the wiring is not connected correctly, the window is off track, or there is an obstruction.
Where is the IAT or coolant temperature sensor located on your 1996 Jeep Cherokee?
If it is any help, on my 1995 (4.0 HO ) it is on the intake manifold. If you are standing on the dirvers side of the vehicle looking in the engine compartment, look to the right of the TB carburator. There are two vacume ports with vacume tubing and one port with a two wire harness going to the sensor. This is you IAT sensor.( It is commomnly unpluged and after market diodes are attached for better performance or mileage)
How do you manually work the top of a 1991 LeBaron convertible?
1-Go behind rear seat and remove vinyle and cardboard covering.2-Locate the motor/hydrolic fluid reservoir (if on knees in rear seat facing rear window will be on right side).3-On right side of motor unit will be a rubber stopper, remove this and with a large plastic syringe, remove hydrolic fluid.4-Replace rubber stopper and the convertible top can then be operated manually.Remember, if you want to operate top electrically again, fluid must be replaced.
How much should it cost to change the clutch in a 1999 Toyota 4-Runner?
The cost to replace a 1999 Toyota 4Runner clutch runs between $145 and $300. This depends on if bought in a kit, part brand and any labor costs.