How do you know your 2000 vw beetle is over heating?
the red warning light will come on. this is the same light that comes on in blue when engine is started.
What would cause a 2000 VW Beetle to not start after a fuse was replaced?
im not totaly familiar with this particular car but you may have inadvertently tripped the security ignition cut-out,if in fact they have one,hope it helps ,can you specify which circuit the fuse protects?
The Beetle doe not have a security cut out. Is the car cranking over? If not check your fuses on top of battery if it is cranking then check your fuel pump relay if that is not the problem it is probably the fuel pump they go just like that. Turn the car off and it will not start fuel pump is bad
Why would only the high beams work on a 1996 Dodge Intrepid?
Try checking the fuses (#15 and 16 in the fuse block) and if they are intact try changing the bulbs (be extremely careful doing this so as not to break anything); the low beam filament might have gone bad on both bulbs. If not there might be a problem with the metallic contact within the plastic connectors (very unlike that both would simultaneously fail but check any way) or a component (wire, and/or switch etc) in that particular circuit for the low beam.
If you want to reset the light just remove the positive cable from battery for 5 min and reinstal this puts puter in reset mode.
How do you reset the computer on a 1998 Volkswagen Beetle?
disconnect the positive battery cable and leave it off for about 10 mins before reconnecting it, and that should clear things like engine lights
Would be looking at the cause of the plugs going! They should last a LOT longer than 4-6 months, 4-6 years maybe!
How do you change a low beam passenger's side headlight on a 1987 Buick Electra Park Avenue?
There is a screw on the front support holding the coolant reservoir in place. Remove the screw, and use pliers to remove the return hose from the radiator cap. Take the coolant return reservoir out (may be tight due to the battery location, if you cannot remove it, removal of the battery will be necessary) and set it aside. Reach inside the hole, remove the plug from the back of the 9004 bulb, and there will be a plastic ring around the bulb housing, twist it counterclockwise and remove it. Pull the burned out bulb, and replace it with the new bulb. Repeat the steps to reassemble.
Why aren't the brake lights not turning off on my Vw beetle?
Shorted wire to ground or failed brake switch.
How do you remove exterior door handle 1961 VW Beetle?
There are 2 screws on the inside of the door under the door seal, remove and slide the door handle off.
What size engine is in a 1974 super beetle?
Infact in super beetles the company were offering 3 types of engines.
Single manifold 1200
Twin port 1300
Twin port 1600
http://1.bp.blogspot.com/-cLzBUiSf-oA/Te_E-EJywPI/AAAAAAAABT0/Lr6Z8jqIrmY/s1600/VW_1966.jpg
http://photos2.donedeal.ie/View2-9708681.jpeg
http://api.vwheritage.com/_img/large/166287_01_large.jpg
If you are still unsure of your engine type then here is something else you can do.
VW stamped all type 1's and pre '72 type 2's on the right case half just below the generator pedestal.
The first and sometimes the second digit/letter denotes the basic engine group.
So the best you can do is narrow down the engine to a group.
Here are the groups
Type 1 -Beetle
Code Year Engine Remarks
4 - 60 - 1200 - 40 HP
5 - 61 - 1200 - 40 HP
6 - 62 - 1200 - 40 HP
7 - 63 - 1200 - 40 HP
8 - 64 - 1200 - 40 HP
9 - 65 - 1200 - 40 HP
FO - 66 - 1300 - 8mm oil pump studs
HO/TO- 67 - 1500 - 8mm oil pump studs
H5 - 68-69 - 1500 - 8mm oil pump studs
B6 - 70 - 1600 - Dual Relief - single port
AE - 71-72 - 1600 - Dual Relief - Dual Port
AH - 73-74 - 1600 - 8mm Head studs w/case savers
AJ - 75 - 1600 - Fuel injected, no fuel pump mount.
Type 2 - Bus
Code Year Engine Remarks
Numerals 61-63 - 1200 - See type 1 40 HP
O - 64 - 1500 - No Cam bearings
H - 65 - 1500
HO - 66-67 - 1500 - No Cross member holes
B5 - 68-69 - 1600 - 8mm oil pump studs, single port
B5 - 70 - 1600 - Dual Relief
AE - 71 - 1600 - W/cross member holes
Late Bus
CB - 72-73 - 1700 - Dual carb, manual trans
CD - 73 - 1700 - Dual carb, auto trans
AW - 73-74 - 1800 - Dual carb, manual or auto
AW - 75 - 1800 - Fuel injected
ED - 75 - 2000
GD - 76-79 - 2000 - 79 had Vanagon heads
GE - 79 - 2000 - Cal only, Vanagon heads
Type 3 Notchback - Fastback - Standard
Code Year Engine Remarks
O - 63-65 - 1500 - No Cam Bearings
TO - 66-67 - 1500 - 6mm oil pump studs
UO - 68-69 - 1600 - Fuel injected '69 w/xmember holes
UO - 70 - 1600 - xmember holes, dual relief
U5 - 71-73 - 1600 - like UO w/xmember holes 7.3:1 compresion
X - 72 - 1600 - 7.3:1 compresion
After Market Cases
Code Year Engine Remarks
F1 - 13/1600
F2 - 13/1600
DO - 40-HP part when last digit is "X"
D1 - Some times a 40-HP part
AB - 66-79 - 1600 - Built since '73 in Mexico, Brazil and Germany
AK - 67-74 - 15/1600
AM - 1600
AS - sometimes listed as a Super Beetle original case '73 and on
Type 4 Late Bus
Code Year Engine Remarks
W - 71 - 1700
EA - 72-74 - 1700
EB - 73 - 1700 - Calif only
EC - 74 - 1700
Hope this will help
Wanted to add: in the US only the 1600 cc engine was offered for the 74 Super Beetle.
Where is the VIN located on a Honda 400ex?
The location of a VIN on a 1999 through 2007 Honda 400EX is on the front frame. It is located just behind the front bumper.
What is the standard tire size of 2003 Volkswagen jetta?
195/60/r15, 205/55/r15, 205/50/r16, 225/45/r17..... this information is also located inside the gas filler door
The correct tire size for this car is 195 65 R15.
carb needs cleaning and check vauum lines for cracks and such....
Where do you put the brake fluid ina 1974 VW Beetle?
Well, the engine in a 1974 vw Beetle is in the back of the car. So the brake fluid in front or the back to the left of the right.
How do you replace the fog lamp bulbs on s 2004 Hyundai Santa Fe?
Look under the bumper and you will see two large Phillips head screws right in front of the wheels. Take these two screws out and bend/move the plastice piece out of the way. Now you can easily get to the bulb. There is a cap that twists off that protects the wires and back of the bulb. Twist this off and then remove the plug portion from the back of the bulb. The bulb then turns 1/4 to 1/2 revolution to loosen and remove. Reverse steps for installation.
The ac-heater blower motor stopped working on your 1998 Pontiac Bonneville SE - What could be wrong?
check for voltage at the blower motor on all settings. if no voltage check the blower motor resistor or relay. if it has a resistor it will be right beside the blower motor, if it has a relay it will be the relay on the firewall under the hood.it will probably have a purple,orange,blue,and black wires.
What factory size tires and rims come standard on a 1991 Nissan Stanza?
Your local Nissan dealer should be able to look this up and tell you. Give them a call, shouldn't be a fee for it...it's just information. That's all I did for my pontiac, except i called my GM dealer..lol.
Where is the diagnostic port on a 1995 Honda Prelude?
Right side of the hump behind the carpet underneath the dash Right side of the hump behind the carpet underneath the dash
How do you take the door off on a 1974 VW bug?
If you open the door wide you will see that it only has a pin sitting in the hinge , just knock it and it should come out with ease.
Can 2002 S-10 blazer 4x4 be towed behind motor home?
yes it can and if its for a long distance consider removing your drive shaft