0
Toyota Corolla
The Corolla is a series of compact/subcompact cars produced by the Japanese automaker Toyota Motor Corporation since 1966. In 2007, the Corolla became the world’s best-selling model, with more than 35 million cars sold.
4,409 Questions
What size Windshield Wipers for Toyota Corolla?
Correct wiper blade size depends on the year of the Toyota Corolla. Once you have the make, model and year then look-up the correct wiper sizes. See related links to lookup some options for any year corolla.
Where is the lighter and radio fuse located in a 2004 Toyota Corolla?
I have a 97 and just changed that fuse for the dome and interior lights, only it also has the tail lights, any way, it is located on driver side on left, fuse # 15 and it is a 10 amp, hope it is a help
Why wont Radio and dome light work in 99 Cherokee?
I fixed the no-headlight problem on my 1996 Jeep Cherokee (not a Grand) by replacing the headlight switch. As I recall, the black plastic knob is removed from the outside. Then, there is a button on the switch housing itself which is difficult to reach - you have to put your head on the floor and reach way up underneath. Pushing the button allows the stem to be pulled out from the front. My memory isn't clear. It is also hard to get the large connector loose because of the plastic clips holding it in.
I don't know why the old switch wouldn't work. I had no faith that replacing it would do any good. It did - the lights have worked without issues since.
Hope this helps.
How do you remove a starter from a '98 Toyota Corolla?
Are you sitting down? If the bottom bolt is not there then the bolt is coming into the starter from the inside of the transaxal housing whick means a it's a CVCC type engine. Not sure if you have to pull the engine my accord's starter just went out and this is what I found by feeling no bolt on the bottom mount and sticking a pensicle in there and finding something blocking. The Chilton book that I have shows a pic of the bolt inside the houseing. I'm gona get durnk good luck
The other bolt is behind the stabelizer bar. if your hands and arms are small enough you can get behind it with a rachet wrench and not have to remove the stabelizer bar. It's the upper bolt on the short end of the stabelizer.
there's a bolt on the right front side and one from behind on the left side. Get the new one, look at it, make sure it matches the one that's in there, the bolt from the back is a little tricky, but you can get to it. I had to remove a stabilizer bar thingy to get a wrench and my arm in there. Mine's an 82 Honda accord 3 door hatch back, just swapped it out a month ago.
while looking at ste starter motor from the side of the car stick your left hand around past the upper bolt of the stabalizer bar you willm find a bolt use a # 14 open end wrench it will take time but i did it cool
What steps do you take to replace a Radiator on a 1990 Toyota Corolla?
Hey Steve==If you have to ask, you must not be very familiar with mechanics. First drain the radiator. Take the fan shourd off then remove the hoses, and oil cooler lines. Then remoove the bolts and pull the radiator out. Reverse operations to install. GoodluckJoe
What kind of transmission fluid does 1999 Toyota Corolla take?
Dexron 3 automatic transmission fluid, same for transmission/differential
3 speed transaxle 2.6 qts
4 speed transaxle 3.3 qts
manual 2.7 qts
1999 1.8L Corolla
Haynes Repair manual.
Is there a diagram of a 1992 Toyota Corolla engine?
Yes, there is a diagram of a 1992 Toyota Corolla Engine. This diagram can be found in the cars specific maintenance manual, found in auto part stores.
It could be your catalytic converter... yes, catalytic converters clog on these often. its fairly easy to unbolt it from the exhaust manifold. if you take it off, shine a flashlight up from the bottom, you should be able to see light from the top.
Lug nut bolt broke while trying to get tire off how do you remove it?
You may have to get a nut splitter, a grinder, or a hammer and chisel to get nut off and then have stud replaced. Hopefully the splines in the drum haven't been torn out and a new stud can be pressed in. If not, you might be running a lug nut short (which is not at all wise) or you'll have to come up with a new drum. Auto recyclers live for challenges like this.
Is it easy for a beginner to change rear brake pads on a 2000 Nissan Maxima?
It is easy but everything has to go inorder. Get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM and it will help on the next repair and get you acquainted with your car also.
easy is relative. i don't alot of work on my cars but it's fairly straight forward. front discs are easier to change. i'd recommend changing with a friend. 1. loosen lug nuts 2. jack car up 3. take off wheel 4. make sure emergency brake is off, and remove it from brake assembly. it's a bolt on top w/a clamp and spring, and a bolt on the bottom of the arm. 5. remove 2 bolts holding caliper in place. pry caliper off rotor (i find using a big flathead screwdriver does best...wedge it between rotor and caliper) 6. remove 2 bolts holding caliper together and pull pads out of calipers...careful not to damage pins/shims 8. push piston back into boot so new pads will fit. this will require a tool. front brake piston can be pushed with a c-clamp, but rear requires a tool fitting the '+' shape. available in autoparts store...get a socket extension for your rachet too. (don't try to do with anything else, or you'll just get frustrated) turn clockwise and simultaneously push. 9. put new pads in, aligned same way as old ones 10. slide back on rotor and assemble everything in reverse order of disassembly
should take a couple hours.
Where can i find a 1994 Toyota Corolla fuse panel diagram?
I'm researching this at the moment as I just had mine in to fix the radio, apparently there's one easy to find one, I believe above the pedals (you need to move the drivers seat back to get to it) and apparently one between the glovebox and the dashboard.
Where is the starter relay located on a 1990 Toyota Corolla?
Hi, I just saw this and thought I could offer some help as I had removed my starter relay and made some repairs to it. It is fairly difficult to find: Push your driver side seat back and position yourself so your head is looking up underneath the stearing column (the top of your head should be pointing at the brake pedal). Look just to your right of the stearing column, its up a far way. For me it was a small grey box. If you've found it, now you need to remove it, which is just as difficult as finding it. I believe there is some sort of clip mechanism that holds it there, you need something to push that clip in and the cartridge should slide off (mine was stuck on there pretty good). Now that you have it off you probably want to fix it, I just cleaned it up and scratched off some of the corrosion on it and it worked fine from then on. Note: these directions took place on a 92 Honda Prelude SR so no guarantee they are the same for all models. Good luck. ~Morgan
How do you fix a radiator crack?
If its not too big and depends were its at you can use JB weld. its cheap and easy.
USUALLY,MOST CARS UNFORTUNATELY HAVE PLASTIC ENDS ON EACH SIDE OF RADIATOR ,OVER TIME THEY DECAY,A RADIATOR IS UNDER A LOT OF PRESSURE,AND THE TWO DON'T MIX,THIS COULD BE THE CASE.REPLACING THE RADIATOR IS THE ANSWER ,PATCHING IT ONLY BUYS YOU A LITTLE TIME .YOU MAYBE BROKE DOWN AGAIN SOONER THAN YOU THINK,LEAVING YOU STRANDED.NOT A GOOD IDEA TO PATCH IT.BUY A NEW ONE THAT'S CHEAPER THAN RUNNING IT HOT POSSIBLY CAUSING THE ENGINE TO OVERHEAT CRACKING A HEAD OR BLOWING A HEAD GASKET.THESE ARE VERY EXPENSIVE REPAIRS 10 TIMES WHAT A RADIATOR WOULD COST YOU.
What does it mean when my brake light stays on?
It probably means that there is a problem with the electrical connection between the brake ligts and the brake pad and so it does not light when one brakes. Another possibility is that there could be a real serious defect in the braking system e.g. the brake fluid tubes.
AnswerIt means a lot of things, but the most common and simplest is that one of the brake light bulbs burned out. Honda puts two in each brake light so you don't get rear-ended on the freeway or pulled over by the cops before you can get to the auto parts store, but check your brake lights by pulling each bulb, inspecting it and cleaning the socket.It could also mean the brake fluid is low. The most common reason for this is that the brake fluid in the reservoir goes down as your brake pads wear our. Warn pads often result in low fluid and a brake warning light. Check your fluid level. If its low don't fill it. First, check your brake pads front and rear to see if they are worn out. If you fill the reservoir and then replace the pads, you will spill fluid out of the reservoir when you push the pistons back in the calipers.
The other most common brake light indication is if the emergency (parking) brake is engaged. Check to make sure it is released.
I have to disagree with the second answer. Normal brake wear will NOT cause a lower fluid level. The brake indicator on usually always means low fluid in the brake system. Blown light bulbs in the brake circuit will NOT cause a brake light to come on. It is only something directly related to the brake system. Brake Fluid is the monitored component in the brake system. It also will give an ABS light with LOW FLUID,,,,possibly indicating a leak.
How do you remove the stereo in a 1988 Toyota Corolla?
It a simple task to remove and replace your car stereo in corolla, you start by gently pulling out the chromes which surround the tape and eventually u came find the screws that is used in holding the stereo to the dashboard
This will help remove and replace with an Android car play
You can watch this video for more understanding
@dekingsdesign493 in YouTube
What are the torque specification for Toyota 4A-GE 20 valves Silvertop Cylinder head bolts?
If you are planning on getting a hotel room as well check out priceline's combination deals where you can buy both for a discount. Check out Southwest Airlines as well because they almost always have the cheapest domestic flights and great customer service.
Toyota Corolla fuse box location 2006 radio fuse?
where is the fuse located for the 2006 Toyota corolla
Where is the oil cap on a 1996 Toyota Corolla?
Hey Jennifer==It would help if you included the engine you have but according to my information it parobablyis at the front of the engine in the valve cover. GoodluckJoe The oil cap is on the valve cover, might be tight and remember to give the threads a wipe before re-installing after oil addition.
It is located right at the front left side of your Toyota corolla car's bonnet, near to carburetor.
What do symbols in left hand corner of dashboard of 2005 Toyota corolla mean?
You are probably refering to warning lights for "low fuel" "ABS" "oil preasure" and "coolant temp", but for more specifics, they are listed in the owners manual under operation of the vehicle.
How do you install rear speakers in a 1997 Achieva?
Remove rear deck lid, use a 9/32 socket to remove screws, remove wires, reinstall them onto new speaker, reinstall the screws and the rear deck lid...
Where is the MAF sensor and ECM located on a 1993 Oldsmobile cutlass ciera 6-cylinder 204 3.3L?
The MAF sensor is always located in the air duct between the air filter and the throttle
body.
Rick
I'm a retired ASE Master/L-1 Technician. I still keep current with the latest automotive technology. Visit my blog for cool articles and TSB's:
http://free-auto-repair-advice.blogspot.com
