0
Grand Am SE
The Grand Am SE was a rebadged fifth-generation variant of the Pontiac Grand Am manufactured by General Motors from 1999 to 2005. The car featured a four-speed automatic transmission and a 3.4-liter 3400 V6 engine.
3,111 Questions
How do you replace a burned out third brake light on a '96 Grand Am SE?
from the trunk look up towards where the lamp is there you will see a two/three wire connection/socket at the lamp... turn the connection/socket about 1/4 to 1/2 turn to the left and pull down slightly you'll find a burnt out bulb...... replace and re-install connector/socket in the reverse of removal..... P.S. Dont get locked in the trunk..... lol
if your lamp is on the top of your rear window then either carefully snap off the cover from inside the vehicle that covers the lamp or remove 2-3 screws from the cover (if applicable) and there you will find the bulb.....
ya out!!!!
Pauly Pauly
Just found it myself. Short the top two on the right side. Have the ignition turned to "on" and then do it. You get X number of blinks, a pause, then more blinks.
Mine was 1 -pause- 2. 12 for me!
Where are the spark plugs in a 2004 grand am se?
Look in your manual. Or go to auto zone for them to help you locate them.
Do Pontiacs have heating problems?
not really but they go through cam bearings pretty bad best suggestion don't get one. I currently have a Pontiac and have been having problems with the transmission and now the engine caught on fire. Definatley do not get one
Disable the security system by unlocking the hatch or driver's side door with the key.
How do you remove the ignition switch from a 1997 Pontiac Sunfire SE with no tilt steering?
There is a recall on '97 sunfires ignition switches. My car wouldn't start and after trying it several times smoke started coming from the ignition column. they will install a relay switch w/ your ignition switch to convert high voltage away from it. If it doesn't start and you continually try it or hold it back too long it will start to burn as mine did A Pontiac dealership fixed it for free but I had to fight them on the towing costs. I would do a search on the recall or call a Pontiac/GM dealership and they can tell you if it goes towards yours... you!
Also check for other recalls such as the PCM recall.
How do you remove the seat covers on a Pontiac Grand Prix?
Check out the following website for a heated seat installation. In it they cover how to remove the seat covers.
http://www.scacgp.com/mods/heated_seat.htm
http://www.seatcoverset.com/seatcovers-car_seat_cover.htm
hope this helps.
"G"
Where is the starter located on a 2002 grand am v-6 and it simple to replace?
The starter can be seen from under the car and is located just in front of the oil pan and the nose of it more to the drivers side of the motor (edge of the motor and transmission). It has a round motor you will see and two wires will be bolted on to it. It is not hard to change just disconnect your battery fist, remove the nuts that hold the wires on and there are two bolt that hold the starter on to the engine. One is at the bottom of the starter and the other is up the side towards the front of the car (both on the nose of the starter)
How do you reset the oil change light on a 1994 Chevy Corvette?
To reset the oil light, put the key in the ignition and turn to accessory setting (but do not start the car) Push the English/Metric button twice and then push and hold the "Gauges" button. The "Change Oil" light will flash for about 15-20 seconds and then go out. Release the button and turn key off.
When you turn the key back on, the light should be out. If it is not, repeat the above steps.
I've found an easier way to remove the #4 plug and maybe all of them for that matter...
Do this:
Instead of all the small extensions and swivels... Use a 3/8's in. ratchet attached directly to a flexible 8" extension (and another 8" solid extension if needed) connected to a spark plug socket w/o a swivel. Use duct tape in the same manner... You can really feel the plug moving and reduce any problems with broken plugs or crossed threads. It worked like a charm... Surprised the hell out of me because the flexible extensions usually cannot take the torque, but the spark plug cavity keeps the extension from distorting. Less force needed on removal and I got an honest 18 ft lbs easily when tightening!!
What are the parts needed to do a full tune up on a 1989 camaro 2.8L?
Plugs, wires, distributor cap, rotor, PCV Valve, fuel filter,
Does anyone have the timing marks for a 68 lamans with the ohc engine in it?
its been awhile all i know it runs the same as a Oldsmobile same motor it run conter clock wise
How do you tilt the motor forward to reach back spark plugs on 2003 Aztec?
Remove the bolts in the U shaped connections in the front of the engine. Grab your wife, hubby, or friend, park on a flat surface, get behind the Tek and push forward. The engine will rotate have said helper hit the E-brake when the see the engine roll forward. You should have enough room to get behind and change the plugs
Why wood gas gauge indicator jump all over the place in a 2000 blazer?
COULD HAVE BAD FUEL LEVEL SENSOR OR IF IT DOSE NOT HAVE SENSOR THE SENDING UNIT ON THE MODUEL IS BAD AND THE WHOLE MODUEL NEEDS TO BE REPLACED.
The engine has not been properly refilled with anti-freeze. This air bubble blocks collant flow to the cabin heater.
Realignment means the switching of voter preference from one party to another
Save
What does check engine code on P0446 Chevy Prizm?
Just because you read a code does Not mean that is what is wrong. There are diagnostic steps to take so you do not replace unessary parts. The problem can be as simple as a cracked vacuum hose.jd
Ive had the same code and code PO441 both PO441 and PO446 are only regarding the emissions system not the fuel injectors! mine was the purge solinoid light went out then came back on 4wks later there are a number of things it could be but from things ive read about this is other Chevy prizm owners have had the same constant problems. take it in and have a smoke test done. good luck!!
Where is the water pump on a 95 Pontiac Grand Am?
it depends on what engine you have. it's either in the timing chain casing or it's in line with your drive belt. fallow the hoses coming out of the radiator. if they lead into a unit that is driven by the belt the that is you water pump and you are in luck.
if it is a 2.4L then it is driven by the timing chain... then you have to remove you motor mount on passengers side. then you have to remove the timing chain cover on the same side as the motor mount. you will then have to completely remove the timing chain. you will see a little gear, about 3" in diameter. this is the gear for the water pump. you can unbolt it from behind the casing. but either way you will have to reline your timing chain and have the cam gears and crank gear lined up right.
if it is a 2.4l the you HAVE TO get a manual. they are only $20 bucks. it will give you a step by step. it's not easy but it's no impossible. and if you do have a manual then any time you have a question the you can just refer to it. good luck and i really hope it's not a 2.4!!
the water pump is on the side of the motor
How do you turn off the security light on a 2003 town and country?
Take it to the dealer to replace the Skim module in the steering column and reprogram the key... You cant fix this on your own without a $5000 drb iii scan dealer tool.
Turned out to be a bad wiring harness and engine cpu...Its all good now.
When the linings are about 1/32" or so. The cost of replacing a part is a very general question that unless specified exactly is hard to answer. First, is who is replacing the part? Is the Dealer, an independent repair shop, a junkyard, the guy next door or you doing the replacement. These will all yield different prices. Not to mention that within all of these will be different labor rates and different part price mark ups. Second, what is the quality of the part? Is it a name brand, generic (white box, economy), OEM or used part? All of these will be different. Price will even differ between name brands, sometimes significantly. Thirdly, What is the warranty of the part and who is offering the warranty (the shop the parts house or the manufacturer). Limited Lifetime will have restrictions. Lifetime warranty isn
Were is the location of the crank sensor on a grand am?
depends on the motor mine is a 3.3 liter and is located behind the harmonicf balancer by the crankshaft
