0
Oldsmobile Cutlass Supreme
Manufactured by General Motors from 1966 to 1997, the Oldsmobile Cutlass Supreme was a mid-size car produced in five generations. Its fifth generation model was available in three body styles: 2-door convertible, 2-door coupe and 4-door sedan.
2,211 Questions
How do you install headlight warning 86 olds cutlass?
remove steering column and check this link. the buzzer is the red box on back of instrument panel.
http://www.oldspower.com/vb/showthread.php?t=47536&highlight=chime+module
Where is the fuel pump on a 1992 cutlass ciera?
in the gas tank . or if it has a carberater on the front of the engine.or like my 86 celeberity both.
Try some shopping bag brown paper, or cotton fabric. Apply the material to the pitch and put an iron, or hair dryer to it. Keep the heat low and slowly increase it until the pitch melts, but before the furniture is damaged. You could also dab (just a little bit) Stripeze to the pitch, but be VERY CAREFUL as it will remove the finish also.
There is a short in the wiring block behind the driver's side front headlight.
Why would a 1997 Oldsmobile Cutlass Supreme idle high?
1-Cold weather - normal operation.
2-Computer reset, especially after battery replacement.
3-Low coolant (antifreeze) level.
4-Stuck IAC.
5-Air conditioner turned on. Defroster included.
How do you locate fuel pump for 1986 cutlass supreme?
it is located behind the power steering pump on the engine block
How do you open the hood of a 1991 Plymouth Voyager once the hood release cable has broken?
ok where did it break off at ? off the handle inside or out side under hood? if u can get a hold of any piece of the cable take a pair of pliers it screw driver and like spaghetti on fork triwil it up or roll it wind whaqtever lol and give it a pulll or that vise scripts and pinch it land give a tug either one of those ways should pop your hood
Where is the thermostat for a 1999 mercury cougar 2.5L V6?
Normall follow the top radiator hose to housing "T" should be in housing
What size tires are for 1983 Oldsmobile cutlass supreme?
The standard sized tires for a 1983 Olds Cutlass Supreme are 195/75/14. However, the car can also handle 215/65/15, 205/65/15, 205/75/14.
How do you pry open driver door on 89 olds cutlass supreme handles no work?
Go to fire station and ask to use slim-jim. When you feel contact, push down on slim-jim handle. Door should open. If not, ask fireman for help.
Why would a car's steering start vibrating at speeds over 70 MPH?
Have the tires checked for being round. You can balance a square block but it won't roll smoothly.
It should be 3/8" if it's a hex, or T-50 if it's a star (Torx).
Will 403 olds engine mounts fit a 350 olds?
The blocks were physically the same size so I don't see why not.
What is the firing order for 1994 3.1L Oldsmobile?
firing order is 1-2-3-4-5-6 coil packs should be numbered in the order they fire. from front of engine left side is 1 3 5 right side 2 4 6
Will a 1969 cutlass dashbord fit in a 1968 cutlass?
it will fit but you will need to drill out an ignition switch hole unless you also transfer over the 69 steering column.
Where is the Location of the temperature sensor for the Olds Aurora 97?
I was told that is on the engine block but I don't know the exact location. i have 98 4.0. i found the sensor on the lower front of the radiator. face your aurora kneel right in front of car and look on lower area of radiator.
Many places do not want to put an OBD reader on if the check engine soon light is not on. However, the codes ARE stored in memory. Get yourself a Haynes Repair Manual for your vehicle (or check at your local library to see if there is one available), go to Chapter 6 and read how you can retrieve the codes yourself - also listed are all the codes and what each one means. Good luck.
In 1996, computers changed to save codes. ( OBD II) .
Many parts houses can read the codes.
Synthetic oil in a goldwing interstate 1100?
Yes,keep in mind that you should have a watchfull eye for any oil leaks at first.if engine has over 20% of normal life used already. sinthetic is much better friction protection,but can seap or leak easier. I changed to Mobile-one v-twin at 16000 miles with no problems. I love the stuff. Mobile one v-twin is for aircooled engines,in your water cooled eng. just use the regualer mobile one. I use 20/50 Viscosity.
How do I remove the center console on 89 Nissan 240SX?
First pop off the bezzel that goes around the shift knob, then there are a few Phillips head screws on the front, and sides of the actual console, disconnect the cig lighter, and e-brake sensor, and you should be good to go.
How do you change the AC compressor on a Cutlass Supreme?
I have a 95 3.4 and it's on the passenger side of the engine, first you have to remove the belt, best to also remove the radiator fan, disconnect the negative side battery cable, remove the connection to the a/c hose, remove the wire plug attached to the condenser, then remove the 3 bolts on the flywheel side of the compressor. you should also replace the accumulator, all the o-rings and add 4 oz. of pag 150 a/c oil, 4 oz. in the accumulator and 4oz in the compressor, turn the compressor 10 times. Change the orifice which is right after the high side service plug. reconnect everything while changing the o-rings and adding oil to them. Vacuum pump the system for about 45 minutes, reconnect the battery terminal. then add freon at the service plug while the ac is set high and car is running. 37 lbs for my car. Hope this helps you and check your service manual for your particular cutless supreme
have your drl (day time running light mogule) checked...it can be unplugged, but then you may not have any lights at all on some vehicles.
Will a Chevy 350 motor and tranny bolt to a Oldsmobile driveshaft?
It might. You'd need to check the diamter of the output shaft of the trans.
Where are the camshaft and crankshaft sensor located in a 1996 Yukon?
depends on the engine but it is usually on the top of the bellhousing of the tranny. the crank sensor gets a pickup signal from the flywheel.
