answersLogoWhite

0

Air Filters and Intake Manifolds

Air filters are devices that remove solid particles such as dust, mold, and bacteria from the air. Used in building ventilation systems and engines, they contain an intake manifold that is primarily tasked to optimize the system/engine’s performance and efficiency.

2,054 Questions

What gas stations have gasoline without ethanol?

Due to state and federal government tax breaks it is almost impossible to find gas with out ethanol added. Your best bet would be to call your local stations, ask for a manager and ask them what the ethanol percentage is in their fuel.

The best website that lists station by state then city that is user-maintained is in the link below.

Some stations can only get premium in ethanol-free, so, pay attention to the listings. Here in Saint George SC, two stations have zero Ethanol, the Citgo offers all grades, another station, Mystic, only offers zero Eth in 91 octane because the regular is pre-mixed (that's bad!) in Augusta and trucked 2 hours over to my little town.

most of the Phillips 66 stations do not use ethanol ,shell marathon conoco

Shell just started using it a yr. ago. Now there is no station that I know of where you can buy gas without ethanol.

Remove and reinstall intake manifold on Saturn 19 engine?

First remove serpentine belt, loosen power steering mount bolts and remove, leave lines hooked up. Remove hose clamp holding intake hose to intake manifold from air filter. Remove fuel line and any vaccum hoses that wont remain with the manifold when it is taken off. Remove the fuel rail gently from the injectors. Remove all the nuts from the intake manifold, there is one nut down low on the passenger side of the manifold that is hard to get at and even see, I had to use a mirror so I could see to get my tools in place. Good luck

Where is the air filter on a Murray 4.5HP 20-inch mower?

The air filter is located inside the canister that is attached to the top of the carburetor.

How does one clean a furnace air filter?

There are 5 main steps in cleaning a furnace air filter which you must follow. The first thing to do is turn off the power of the furnace. Next, you must locate the air filter as you may have to unscrew some panels. Thirdly, you must remove the dirtied air filter by sliding it out of the housing. After this, you have to wash the filter with a hose until the water going through it comes out clear and leave it to dry. Finally you must slide it back into the furnace and turn it on.

Where can one buy HVAC air filters online?

HVAC air filters can be purchased through many online sales channels. The best idea is to look for any HVAC equipment supplier, visit their website, get their contact details and place an order.

How do you change the cabin air filter on a 2008 Ford Fusion se 2.3LI4 or actually IS there a cabin air filter on the afore mentioned vehicle?

Go to Advance Auto Parts and ask for a Purolator cabin filter for your Ford. If it came equipped with one that will tell you. Purolator Cabin filters come with complete instructions on how to replace it.

Will the intake manifold from a 307 fit on a 350 engine?

yes it will fit, any smallblock Chevy intake from 86-55 are interchangeable, the 86 and newer have bolts that go staight down instead of on a angle

Why would your car act like it does not want to go when you push the gas pedal to the floor?

That sounds suspiciously like fuel starved. Make sure you're getting enough fuel to the injectors. Check for plugged injectors or dirty fuel filter.

Where is the intake manifold runner control on a 99 cougar?

It is the box with the four screws under the duratec labled black casing right in front of the intake manifold. There is a black cable comming from it.

Should thermostat be replaced at the same time as the intake manifold gasket is replaced?

Yes you should replace the thermostat now to insure trouble free operation afterwards, actually as long as the main bearings were not damaged from the intake leak, you should also replace the head gaskets at this time, use only felpro gaskets and you will have troublefree performance for years to come. These are good torquey engines, gm just went cheap on the gaskets when new

How do you install a gas filter in a 1989 corvette?

== == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == ==

How do you change the air filter on a 2002 Chrysler Sebring Convertible V6 27 liter?

I have a 2002 LXi convertible with a 2.7 liter engine I just changed the air filter on. It is a bit of a PITA to do, because there is not a lot of room in there, but overall not too bad. On my car there are no bolts or clamps to loosen to get to the a cover off the air filter housing to get to the filter. Instead, on the engine side of the housing where the air boot/hose goes into the filter housing there are two tabs on the boot/hose. You will need to press these in to pull the air filter out. On my 2.7 LXi, there isn't a lot of room, so using a screwdriver, I loosened the band on the air intake to the engine, took the boot/hose off the engine intake, CAREFULLY (the tabs tend to catch on things) moved it under wires hoses, etc, pushed the tabs in and with some CAREFUL maneuvering pulled the boot and air filter out. It does take some wiggling and a lot of double checking to make sure you aren't bumping into stuff. The air filter is a cylinder which plugs into the boot/hose. I found I had to partially insert the new filter into the filter housing to have room to be able to insert the new filter into the boot/hose. Then it is a matter of CAREFULLY maneuvering everything back in place, re-attaching the hose to the engine intake and tightening the band down. One last caution, make sure when you tighten the band you keep the screw accessible for the next time. My 2.4 Liter 2002 Sebring has essentially the same procedure, although there is more room.

How do you change engine air filter Mercedes Benz ML 350?

how to change airfilter for 2006 ml 350 merecedes Things You’ll Need: Oil drip pan Oil filter wrench Vehicle jack Vehicle jack stands Metric socket wrench set Standard open end wrenches Oil filter Oil Funnel Step 1 Locate oil filter on your Mercedes and place the oil drip pan underneath on the ground. The oil filter will be found under a black cover on the driver's side of the engine, between the valve covers and the firewall. Loosen the filter with an oil filter wrench, about one full turn, to allow oil to flow back into the engine. Step 2 Raise the front of the car with car jack and place it on jack stands. Remove the engine covers from the bottom of the engine by using an 8 mm socket wrench. Position the oil drip pan under the oil drain plug at the rear of the engine's oil pan. Step 3 Loosen the oil pan plug with a 1/2-inch open end wrench and allow the oil to drain into the drain pan. When the oil is completely drained, remove the oil filter from the engine. Step 4 Coat the new oil filter rubber o-ring with a thin layer of oil and screw the filter back onto the engine. Tighten until the filter is snug, but do not over-tighten. Replace the oil drain plug on the drain pan and tighten it with a 1/2-inch open end wrench. Step 5 Remove the oil cap from the valve cover and pour 5.25 quarts of oil into the engine. Replace the oil cap and turn the key in the ignition to the "on" position for about 10 seconds without starting the engine. This will prime the engine with the new oil. Turn engine on and run it for a couple minutes. Then turn it off. Step 6 Replace the engine covers on the bottom of the engine and remove the jack stands. Dispose of used oil at your local recycling center or automotive store.

Where can one find more information about air cleaner filters?

Information regarding air filters can be found on the manufacturers' websites. Alternatively, by going in store, stockists maybe able to provide all necessary information.

Where is the fuel filter located in Mercedes 430 clk?

under the car,just beside the fuel tank,it's located beside the exterior fuel pump,under a black plastic panel

How do you replace an air filter on a 2001 Toyota Celica?

You can find the flter box in front of the box that says "do not open" the top is held in place by three clips and you clip them off first, them prise the front parts slightly with a screwdeiver, undo the big jubilee clip first on the intake pipe, the filter is then accessable.

How do you change the air filter on 1986 Chevy astro van?

You will have to unbolt and remove the engine access cover inside the passenger compartment. Then you can easily get to the air cleaner.

How much torque should be aplied for the intake manifold?

Torque values are only listed in the vehicles repair manual or service manual and vary depending on year, make, and model.

Where is the Air Cond filter in a 2001 Toyota Estima?

It is called a Cabin Filter. Purchase a Purolator filter it comes with detailed instructions.

Where on a 1973 small block 400 does the intake manifold pressure lines behind the carb need to go Manual trans in it?

The Disney Cruise is one of the best family cruises available. The cruise is an all inclusive vacation that is filled with family fun. Although there are many different destinations on the Disney Cruise, you will need to pack basically the same items for all of their cruises.

You should think about what type of clothing you will need on the cruise. Casual t-shirts, shorts and jeans are fine for during the day, but you will need nicer clothing for dinner. Dinners are a little bit more formal, so ladies should bring a dress or long pants and men should bring a pair of dress pants and a nice shirt. There is only one dining room in which formal wear is required. If you plan to eat there, men will need a jacket and tie and women will need a more formal dress. You should also bring a swimsuit and comfortable shoes for walking around the ship. The Disney Cruise has a pirate themed party one night during the cruise, so you can bring some pirate themed clothing or a costume for the kids if you choose.

Some toiletries are provided on the ship, such as shampoo, soaps and body wash. You will need to bring everything else that you normally use on a daily basis. Be sure to pack sunscreen, as it is very expensive to purchase on the ship. You may want to pack a seasickness remedy, especially if it is your first cruise. The Disney Cruise does have a doctor and carries over-the-counter remedies, but you should bring your own to save on cost. Also, don't forget to pack any medications that you may need, as you will not be able to get a refill on the ship.

You will not need to bring toys or activities for the kids because the Disney Cruise will keep them occupied all day long. You will not need to bring beach towels, as they are provided for you. Surprisingly, you will not need any cash on the ship, as none of the stores accept it. Everything that you purchase that is not included in the cost of your cruise, such as alcoholic drinks or souvenirs, is paid for by using your room key and is charged to the credit card that you leave against the room.

You will have a great time on your Disney Cruise. Try not to over pack and just bring the items that you really need.