0
Ford Windstar LX
Introduced in 1995, the Windstar LX was a first generation Windstar model powered by a 155 hp 3.8 L V6 engine, which can generate up to 220 lb ft of torque.
1,653 Questions
Where is your actuator located on 96 ford windstar?
Given that this question is posed in December (Winter), I'll assume the referenced actuator is the one that controls the temperature blend door...
That actuator is almost directly behind the radio. It can be accessed easiest by removing the radio (not hard to do), and/or up from underneath down by the gas pedal.
See "Related Questions" below for lots more
How many miles did you operate the vehicle between the STOP LEAK instalation and and the stalling problem? Where was the bad leak?
How do you find a vacuum diagram for a 1988 corvette?
Also most good aftermarket or GM manuals for the particular model have them printed in the rear of the book.
AnswerGo right to a GM dealer and usally the mechanic can look in some of their old fish or repair mauals and make a copy of them.What is the spark plug gap for a 1996 Pontiac Sunfire?
my manual shows the correct spark gap as 2.2 ohv 0.060" for 1998 and earlier. 1999-2000 ----0.050" 2001----------0.040" 2.3L & 2.4L OHC 1995-97 -----0.060" 1998-2000 -----0.050" 2001-2002 -----0.050 2.2L OHC ----0.042 firing order 1-3-4-2
How do you replace the evaporator in a 99 Ford Windstar 3.8L?
I don't know how to do it, but the dealer is charging me $2075.00 to replace it on my 2000 Windstar!
check your points to see if they are correctly gapped
What is the wiring schematic of a Ford 38 engine?
A wiring schematic for a ford 38 engine can be found through Ford related service manuals. The manuals depict the original factory placements of the harness and parts of the engine.
Were can you get a cooling system diagram for 85 Toyota 22R truck?
You can go to autozone.com and click on the "free manual". From there you can select a wide variety of things to help you fix your yoda, and it is free.
How do you replace a heater blend door actuator switch on a ford windstar?
The dashboard *switch* - slide control itself??
Never heard of one of those going bad, but... Start with the dash trim piece - 2 7mm screws at the bottom - alongside the ashtray/cup-holder pull out. The trim piece then unsnaps from the dash.
Expect a couple more screws holding the heater controls and wire connection or 2.
Pretty straight-forward.
If by chance you really are looking how to replace the temperature blend door actuator, that is well covered by numerous contributors in the "Related Questions" below.
Who can program transponder keys?
This is not for the rule abiding, uptight individual, so as far as the rest of the world goes.. if you have one key to your transponder key vehicle. Simply take the key hide it under your dash on the driver side in any fashion you feel comfortable with, but, of course, have a key cut that matches it(regular key) your computer will pick up the transponder under the dash and the $3 key will start it. Your other question will be "can people still my car now" yes, they can... will they.. NO, probably not. The reason for that is, that thieves know what they are stealing. they know your car has a transponder on it and won't even try.. they will move on to the next car. Can you bypass the transponder? NO. once again.. a thief knows this...
Where are the pcm bat and pcm ign fuses in a 2002 maxima?
in fuse box under dash at drs left knee and or in fuse box in engine compartment...
note:danger, do not test these with basic test lights, may damage pcm/ecu
take to Nissan or exp import tech.....good luck
maybe windshield wiper fluid??????????? DA
odveosly u have a phone or computer with internet so contact your locile towtruck driver and have him take u to a grauge
What does an exclamation mark with a half circle around it on the dash of my 2006 impala mean?
This is the Brake System Warning Light. For info see page 3-30 of your "Owner's Manual, under Section 3: Instrument Panel - Warning Lights, Gages and Indicators...
The reason why it won't start is because its your alternator...... My uncles chev truck made the same kinda sound when his alternator went....
95 Ford Taurus gl with rough idle as well as when you drive exhaust smells too please help?
Clogged or dirty fuel filter; Restricted or clogged air filter; Plugged or damaged pcv valve; Stuck or improperly functioning choke thermostat; Deteriorated, or faulty carburetor/throttle valve mounting gasket; Clogged, dirty or improperly functioning or defective egr valve; Improperly functioning fuel pump or circuits; Damaged, loose, or faulty idle air control valve; Damaged, loose, or faulty idle speed actuator; Improperly connected or faulty m.a.p. sensor; Faulty throttle position sensor or throttle position sensor circuit; Slipped timing chain or worn timing gear(s); Plugged, dirty or poorly connected fuel injector; Worn or scored camshaft lobes may affect proper fuel intake, compression, combustion and exhaust; Burned, worn or incorrectly set ignition points; Damaged or restricted exhaust system components; Restricted, loose or burned out muffler.
What is the spark plug gap in a 2002 Dodge Neon ES?
there is a sticker under your hood it has the correct info. i think it is on the hood but it may be near or on firewall. i have a 2001 and it may not be the same gap as yours.
What is the proper spark plug gap for a 1998 Mitsubishi mirage 1.5 liter coupe DE?
The proper gap specification for the spark plugs are ( .039 - .043)
How can you tell when 2002 Altima Mass Air Flow MAF sensor is bad or going bad?
I've read some forums and it looks like it might be when the engine goes into "safe mode" and won't let you rev over 2500 RPM. I have a 2002 Nissan Altima that started having this problem that would not allow me to rev past 2500 RPM's and it got worse. I tore the engine down after the dealer informed me that the pre-cat was coming apart and was going to suck particles back into the motor and destroy it. People this is a bunch of crap.......The truth is the pre-cat is coming apart and everything in the pre-cat will be stuck in the second cat causing the engine to overheat because the exhaust gases cannot get out and the engine will not rev due to the fact that it cannot breathe.
What if your 98 windstar dies when you come to a stop but not all the time any ideal's?
It could be a faulty Intake Air Control valve, a vacumm leak, or a faulty transmission torque converter lock up slenoid. The most likely are the first two I listed.
Differnct Respondent: I'm a 1998 Windstar owner and had a similar problem. Van would stall out occasionally following stop. Took it to dealer and they did some sort of clean out of the air intake cavity and fuel injectors. I don't recall exactly but cost was prbably less than $200 and Van no longer stalls out
Where can you find a wiring diagram for a 2003 ford windstar rear electronic module?
Possibly here http://www.alldatadiy.com/
Where does the freon go in a 1992 Mustang?
