How do you remove and replace the radiator in a 1994 ford F-150?
Answering "How do you remove and replace the radiator in a 1994 ford F-150?"
Why won't the damper switch from hot to cold on my 2000 Ford Windstar it just clicks?
This is a fairly common Ford problem. What happens here, is that the blend door actuator moves normally, but the blend door is cracked where the actuator drive fits into it. You're going to need to replace the entire HVAC case. Contact your Ford dealer parts dept. and have your VIN handy. Keep some lube handy before making that phone call.
Car engines get hot to run generally but if you mean over heated it means that your coolant level is low and you could go buy coolant or you could just fill it with water
What year is air cooled vw engine number AS41?
AS41 is the metal the crankcase is made from. It was used in engines up to 1975--when they changed to fuel injection.
Where is the fuel filter located on a 1986 Mercedes 300E?
The fuel filter is located on the right rear underside of the car, just ahead of the rear axel area. You need to remove the cover to find it. It is the large canister next to the electric fuel pump.
Where is the coolant temperature sensor in a 1994 Cadillac Sedan Deville 4.9?
ITS THE PLUG WITH TWO WIRES GOING UP JUST TO THE LEFT OF WHERE THE THERMOSTAT IS.
Where is the fuse for the rear window?
With the rest of the fuses, in the FUSE box under the hood.
Not under the dash.
1996 vw jetta leaking antifreeze through air vents?
You probably have a heater hose that has deteriorated right near the connection onto the heater core, or the heater core itself has sprung a leak. You'll need to look first in the engine compartment to make sure it's not near the firewall, then if not, it has to be under the dash. Your next step is to look in your manual for the location of the heater core. Good luck !
What kind of coolant goes in 1996 GMC Yukon?
50% mixture of Dex-Cool and water.
Other 'universal' extended-life ethylene-glycol based coolants are also acceptable but do not use 'green' coolant with silicate based corrosion inhibitors.
Hey there, I had an 88 f150 4.9, with the same problem,, you need to replace the whole distributor, there are points inside for timing. or even a used one,, but may run into same problem. hope this helps
In a 1987 Ford Taurus 3.0 Liter V6 4-Door how is the engine cooling fan controlled?
there is a fan controller underneath a plastic cover on top of the radiator
Why does your 89 grand marquis blow cold air only after installing a new radiator and heater coil?
air in the cooling system. some are hard to bleed. I've had to jack the car up sometimes to get the radiator fill at the highest level possible. you have to get the air out of the heater core and this problem will be fixed. you might try loosening the uppermost hose at the heater core until coolant comes out. there might be a special proceedure for bleeding this system also.
Where is the cooling sensor located on 2000 impala 3800 V6 engine?
It is located on the radiator. Go to the link on the right there is a procedure posted there with pictures that will walk you through the process
What could cause your AC in your car to not to be cold and just blow air?
When you turn on the AC, check to see if the compressor is running. If the compressor clutch is not engaging, it might be as simple as low refrigerant level. Automobile AC is not like a home AC. Since the compressor cannot be sealed, the seal always leaks a little and you need to occasionally add a little refrigerant.
How do you change a cabin filter on a 2005 Honda Civic?
It's behind the glovebox. open the glovebox and remove the retaining clips that prevent it from opening all the way. You can then see the filter housing behind the glovebox.
Check to see if fan is getting power: Turn A/C or defroster on If getting power fan motor is defective If not getting power check fuse and/or relay If operates this way temperature sensor may be defective
Engine cooling fan won't turn on in my 2004 Chevy trailblazer?
Bad fan motor? See if you are getting power to it Bad sensor? Bad fuse?
Why might your car not have enough heat?
If the fan isn't blowing, check the fuse. Consult your owners manual for its location. If its not the fuse, its probably the switch or a relay. Take it to a mechanic.
If the fan goes like crazy, but very little or no air comes out. It may be the air filter is clogged. Consult your owners manual for its location or if you like, those Jiffy lube guys can usually replace it for you.
If the fan blows fine but its not blowing hot air....
Check your coolant!
Nine times out of ten, when someones heat stops blowing hot air, it is because they have neglected their cooling system and there is not enough coolant flowing through the system for it to fill the heater core. Driving the car in this condition can damage the engine. Check your antifreeze and fill it up.
SAFETY TIP: NEVER open a radiator cap when the engine is hot! Wait until the cars cools before you check your coolant level.
Is cabin air filter a HEPA filter?
All I can tell you is it's a very fine filter. And There are two different types that you can buy one is finer than the usual one that comes with the car. Check with a local auto store.
Coolant is leaking out under your Ford Fiesta engine what could be wrong?
Could have a hole in one of the pipes worst case scenario could be a blown head gasket.
Depends entirely on problem: Simple recharge approx. $75-10 Complete replacement of compressor, evaporator, condensor, drier approx. $1,200-1,600
How do you replace a Ford headgasket?
Remove intake & exhaust manifold, then remove head. Requires knowledge and skill.
Where is the cabin filter located for a 2004 Honda Civic?
its located at passenger side windsheald cover take that offf and you can see it....
Why does heater blows luke warm air even after thermostat change on 2002 Honda odyssey?
May have air in the system. You will have to bleed all the air from the vehicle. Sometimes jacking up and supporting the front end while rev'ing the engine at about 2000 rpm and adding coolant till it's full will work. Be sure to install the rad cap while engine rpm is still high.
Do this with the engine at normal operating temp.