Chevy Tracker

crank sencer

When I had the same problem it was the starter solenoid. It is built on the starter so you have to replace both. After the starter/solenoid was replaced I had no more problems.

P.S. If you take it to most major auto parts places they can check the starter but not the solenoid mine showed good but after I replaced it I never had that problem again.

inside of the door of the Monte Carlo there are two tan wires, a larger one, a smaller one, a blue wire, and a black, try to get some shrink rubber for wires or electrical tape either one, I prefer the rubber all you need to do is put it on one end before tieing the two wires each together and then take a lighter and heat the rubber and it will shrink around the exposed wires. When you put the door trim back on the locks will work I recently worked on a 1992 Monte Carlo with the exact problem.

you probably have a button or switch to turn overdrive on and off, it may be on the end of your shift lever, you probably want to keep the overdrive on, save you some gas, hope i helped

you say you replaced the pump, did you replace the filter? a dirty filter could cause the pump to shut off, also could be that they did not hook up the pump right, or could have put the wrong part on. some parts look the same but they are not all the same. the filter is above the gas tank in the rear on my tracker. check there you may need to start there first, but i would seriously be asking questions to who put the part on your car or who sold you the part. if your problem is not solved soon.

There are a couple of different times when you'd turn off your headlights. You'd turn off your headlights when the car is off for example.

In the fuel tank

a bad fuse

wires bad

connector to same in dash bad

someone installed an alarm incorrectly damaging these wires, or useless remote start.

No the valve seals are between the cam and the head, under the valve spring

This is very simple and take 5 minutes. First draw on a piece of paper, the way it's install on your truck than take your ratchet with the 14mm box.

Look at the wheel at the right of the alternator and the power steering, turn the center bolt of that wheel clockwise and it's going to depress the belt. Take it off and pass by the back of the radiator fan and up it's off. To put the new one($18.00) pass the belt the same way following the shema you draw on the paper and when it's o.k. turn the pressure wheel unclockwise to put pressure on the belt. That's it!

Check your sway bar links. I just had to have these replaced on my 2004 Tracker.

It usually pops off but if it's frozen, look for two extra threaded holes on the rotor. Get two high grade bolts that fit the holes (8mm fine?) and use them like a gear puller. You can get the bolts at any Sears Hardware store.

on level ground

remove the center plug on the 3rd member rear side.

if fluid is level with bottom edge, then is it full

if fluld is not amber and clear, but cloudy , then it is water logged.

I suppose you are asking about where to get the trim pieces

You can write to this address: nopeqw@yahoo.com

This guy Rod used to sell on EBAY

Good luck!

Well, the rear is easy, jack it way up, remove rear tires, put jack stands under frame, disconnect the shock, and let the sling push the axel down, remove the spring and add the spacer and replace the spring, making sure it is seated well in both top and bottom spring cups. The front is more difficult, need to remove sway bar link, ball joint, and disconnect the strut. Then push the control arm down, remove spring, add spacer, replace spring and I suggest placing a jack under the control arm to push it up back into place and put it all back together. Hope this helped.

I just changed the fuel filter on my 2000 tracker 4x4 4 door SUV this evening, it's behind the rear passenger side wheel well right in front of the fuel tank. You'll have to put it on a jack stand or ramp to get to it but it's not hard to do.

I am having the same problem, so far, I have found the code refers the the EGR System. I will post more about what I find out.

they weigh less than 3000lbs

your sensers for your air bag detected a impact but only one senser detected this so the air bag did not go off its around 400 dollars to fix

Usually it means that the oil needs to be changed, or that a belt of oxygen pump needs to be replaced. If it's letting you know it's detecting something, that means that it's not that bad, but needs to get fixed.

Threre is a button just a little below the 'shift' button on the gearshift. Pushing this button in will turn off o/d. Threre is a button just a little below the 'shift' button on the gearshift. Pushing this button in will turn off o/d.

WHICH ONE'S? THE CORNER OR THE BRACKET ON THE BACK? THE CORNERS USE A PHILLIPS SCREW DRIVER

It is rubber, just changed mine on my redhawk!

i have a 2001 Chevy tracker and i just replaced the crank sensor. i have been having a problem with mine not cranking. i would drive it and cut it off. it would not crank up until after it sat for a while. the crank sensor has not fixed the problem though. you have to take the tranmission out and take the flywheel off. the sensor is behind it. hopes this helps. i got a sensor at napa for about $100. advance auto parts wanted about $174 for it i think