0
Ford Escort LX
The Escort LX is a compact car produced by Ford Motor Company. Similar to other Escort models, this vehicle adopted the general design and badge of its European model counterpart.
3,056 Questions
Where can you find a parts diagram or parts breakdown for a Hopkins and Allen 22 bolt action?
Numerich has schematics for nearly every fire-arm that was produced in quantity. You can find them on a search engine.
Where is the ac control module on a 2000 Mazda Millenia?
it is connected to the back of the push button panel. you have to remove the portion of the dash that the push buttons are in to access the amp. there are 2 screws, one each on either side of the steering column. pop off the black plastic bezels, and pop off the dash lite rheostat. underneath are the screws. then, gently pry off the dash part. i start at the glovebox. you will then have to disconnect the wiring harness' to the a/c amplifier. all the controls/amp are then accessible from the back
What would cause a 2002 Focus Se to be idling rough and have power lost through all 5 gears?
I had a similar problem and it was my coil pack
Where are the cooling fan relays for a 1998 Jeep 5.9 limited?
I have just purchased a 1998 jeep 5.9 limited and had to replace the cooling fan motor. There is a 60 amp fuse in the fuse box under the hood on passenger side. My fan motor replacement cost only 150.00 dollars instead of 700.00 dealer cost. I found the directions on the Jeeps unlimited web page. If you are unable to find it email me at felinezoo777@verizon.net and I will try to give you the ins.
Location of fuse block ford explore 2002?
On the 2002 Explorer Sport ( 2 door) the fuse panel is on the driver's end of the dash - visible with the driver's door open and on the 2002 Ford Explorer (4 door) the fuse panel is under the dash on the driver's side On all Ford Explorers there is also a power distribution box in the engine compartment - THE PD BOX IS LIVE - DISCONNECT YOUR BATTERY CABLES
Where is the 95 Mercury Sable fan relay?
It's been a few years since I sold mine, but it should be under the glove behind the kick panel...
Where can you find a parts diagram for a 22 LR Winchester Model 190?
Exploded Firearms Books (soft cover) Editions 1 & 2 both have parts diagrams for this rifle and many other rifles,shotguns and pistols.
Will an ignition switch from a 1992 crown Victoria fit a 1992 ford escort?
No, they are a different part number and are different steering columns. Stick with the escort/tracer switch. No, they are a different part number and are different steering columns. Stick with the escort/tracer switch.
You shouldn't have to remove the airbag in order to replace the gas gauge light. The steering column is held up by a couple of retaining bolts. Remove these bolts and the steering column will lower enough that instrument panel will come out easier. The steering column won't drop to the floor when you do this but will hang in midair. If you have a tilt wheel, you might have to adjust the wheel tilt to allow the panel to come out easier. Don't forget to remove the steering column cover though.
1988 K2500 Chevy 4x4 5.7 misses under a load while driving but not while revving the engine?
Chances are you have a bad wire or plug causing it ; It is easy for a weak plug or wire to hit without a load ,so if it is time for a tune-up I would replace the wire set and plugs. Check your cap and rotor also. I hope this helps you. Mark Mark thanks for the help. New wires did the trick. Truck runs great. Thanks again!!!!
Location of the starter motor on a 1998 mk6 ford escort zetec - front or rear?
The 1998 Ford Escort starter motor is located on the rear of the engine. The starter motor will be on the right hand side, near the bottom of the motor.
Astros and Safaris often have a problem with plugged fuel jets. Once it's running the flow is better but the problem while idling is not solved. GM makes a fuel treatment product that works well to prevent the plugged fuel jet (recommended once a year)and it could help to use the treatment now. It could be your motor mounts and transmission mount are worn out. We had the same problem and we were told it could be the transmission, fuel system, etc. The dealer wanted over $500 to repair it. We got all three mounts at Auto Zone for $60 and my husband fixed it in an afternoon.
Why are your tach and speedometer needles jumping back and forth on a 96 cherekee?
Sounds like your speedometer cable is going out. If it's one of the ones that has the computer attached and does NOT have an actual cable.....it could be that computer. Some cases may cause to have to buy the whole instrument panel because it's all one piece. That's what happened to my ford explorer.
You may have one or more wiring connections that are bad. When the engine is running well, try carefully moving the wiring harnesses under the hood back and forth, particularly those in the taped bundles that run between the engine and the body. Also check ground connections, especially those between the engine and body. It is a 2001 Chevy Malibu, I do not know how to tell if it is fuel injected or Carb. It is an automatic trans, 6 cyl. Hope that makes it easier to hep me what kind of car? what year? IS it fuel injected or carburerated? Automatic? Need more info to answer this ...
Crawl through the window! Hahahahahahaaaaaa!
What would cause an intermittent short beep from the dashboard area while driving a Lexus RX 350?
If you tire pressure is on the low side, there is a sway indicator that will beep if you take a curve too fast. You may not think it is too fast, but the sensor will. Especially if the tires are low
Can steam coming from your car engine mean you are low on oil?
if it's coming from the tail pipe or an exhaust leak, it means you have a blown head gasket!
What would cause the speedometer to read 0 all the time and while driving?
The speedometer cable gear is broken inside the transmission. If the car is older, it is an easy fix. Follow the cable to the input on the tranny, unscrew the cable and the gear is right there. Pop it out and replace it with a new one from the auto parts store. They should be able to order it for you.
no. it happens all the time. you just reset the timing, install a new belt and youre done.
Often this type of behavior is caused by a bad ground for the lighting circuit. Check the ground circuit for the brake lights.
Why the stop lights on a Nissan altima 1993 stay on all the time?
There could be a few reasons why the stop lights on a Nissan Altima 1993 are staying on all the time. It could be due to a faulty brake light switch, a short circuit in the wiring, or a problem with the brake pedal sensor. It is recommended to have the vehicle inspected by a mechanic to diagnose and fix the issue.
needs either a new ignition switch or a new starter solenoid
What causes a 2000 mercury sable to skip in the motor when it gets hot?
I have a mercury villager that would run great until it got hot and the it would start skipping and backfireing. I tried everything, finally I took the distributor apart, and inside, under the rotor cap, was a metal plate, I took it off to find a Photo Censor inside, there is a round plate inside that goes thought the photo censor. I took some starting Fluid (ether) and cleaned all of it really good and wiped it off with a shop towel. put it all back together and it runs like new. Just remember to make sure you put your distributor back in just like it came out or it want be in time. DO NOT TURN THE MOTOR OVER WHILE YOU HAVE THE DISTRIBUTOR OUT!!!. Good Luck
