What is the average frequency of a microwave?
"Microwave" radiation is any radio wave at frequencies between 3 GHz and 300 GHz.
Microwave cooking ovens are licensed to operate at a certain definite frequency, just like
any other radio transmitter is. For microwave ovens in the US, the frequency is 2.450 GHz.
What to do when you lose your VW Jetta key?
1999.5 and newer Volkswagens: you will need proof of vehicle ownership (registration card with vin) to the VW dealer and have them cut you a key. If the key works but the engine will not run, you will have to get it towed to the dealer to have the key activated. It has an immobilizer system (antitheft)
1999 and older Volkswagens do not, you will need to remove the door handle to obtain the lock 4 digit code to have a key made.
See www.veedubkey.com for lost key services through the internet for all keys up to 2005.
How do you find and enter security code for radio in 2000 new beetle?
I own a v.w. beetle. Had to have the radio replaced in it. Brought it to the v.w. dealership. They had to call Germany to get the code for the radio. Sometimes it is written down in your owner's manuel. That's where my old one was before I put the new radio in. Did you know you can't even change the battery in the car without plugging it up to keep and electrical charge are you will not be able to start your car. There has to be a 12 volt going through it at all times. There is also a code for that to. that's v.w.'s for ya. We have to pay for all these problems.
How do you wire a radio into a 1973 super beetle?
First, you'll need a radio. If there isn't a hole in the dash the right size for the radio you'll need to cut one or mount it underneath the dash or in the glovebox. There is a spare fuse location in the standard fuse box (furthest to the right on the Australian model, if I remember right) which is provided by the factory for an optional radio. Wire power to that, earth to any metal part of the body behind the dash. Depending on the radio, you'll probably need both a switched and unswitched power input, check different fuses with a multimeter and turn the key on and off to find what you need. If you don't understand so far, pay a professional to do it.
If you don't have any speakers yet, there are holes in the metal behind the door trims for a shallow round speaker of about 5" diameter, and you can cut holes in the door trims and stick them in there. Most modern speakers are too deep and you'll need to buy or build some spacers or door pods for the speakers, or put them somewhere else, like in a wooden parcel shelf behind the back seat. There would be room behind the back seat for plenty of audio gear, and the rear side panels might be an option as well.
I've seen speakers in front kick panels and underneath the dash as well but don't like them in that location. Of course, there's always the standard position of a single speaker behind the dash next to the speedometer!
How do you remove the steering wheel on a 74 VW standard Beetle?
Remove the plastic horn section of the steering wheel by gently put firmly pulling each 'spoke' of the plastic about 1 inch in from the edge of the wheel. Lift each spoke only slightly, then move to the next spoke to release them all, don't try to pull on just one or two. Disconnect the push on connector(the horn) and put the plastic horn piece aside. You should see a nut in the center, about 4 inches down. As I recall, this is 23mm, but not sure. Remove it. Place the steering wheel so that front wheels are straight and spokes of wheel are pointed horizontally (to line it back up when reinstalling). Now alternately bump each side of the steering wheel from the bottom of the wheel with the palms of your hand. The wheel will slowly ride up the splines of the shaft and come off.
it may be your alternator going bad that is what happened to mine, and i just changed the alternator, and it fires right up, to check your alternator start your car if it will start, and while its running take off your positive battery cable, if it dies your alternator is bad if it stays runnign your alternator is good, then it could just be your compression, or something in your gas.
Does a car with front wheel drive need front end alignment?
There is no reason you should have to. If the tie rod was knocked out of the spindle it goes back in the same place. Nothing else has any effect on the alignment.
If the tire locks up when you apply the brakes and you have drum brakes then you may have brake fluid leaking onto the brake shoes.
If you have ABS then you may have a bad wheel sensor.
The adjusters on the brake shoes are out of adjustment or broken.
Springs or hold down hardware may be broken.
Cracked brake linings.
Backing plates are worn out.
How do you change the fog lamp bulbs on a 2001 Ford Escape?
pretty simple...reach directly behind the fog light and feel the 2 wires- they are in a plastick casing. grab the casing between thumb and forefinger, push in slightly and turn approximately 1cm. the bulb housing releases, pull the housing straight backwards until you have the entire assembly removed. unplug the bad bulb by pulling it straight out. push in the new bulb, push the assembly back inside the hole, aligning the three tabs in their slots, then turn 1 cm or so th lock back in place.
should take 3 minutes.
bulb# 880
Where is the starter located on a 1971 VW Beetle?
On the transmission's bell housing, passenger side.
Why would a key not come out of the ignition of a 1991 Acura Integra?
This is the little box located behind the radio if you enter your hand where your radio would be you could see what iam talking about, also if you press the button on the shifter and don't let it go and play with it while in park the light would come on i hope this works for you.
ANSWER
start your car(or at least put kjey in second position) put it into gear(or if still off just move into neutral) and put back into brake, pull e brake and turn car off and remove key.
What is the top speed of a 2005 Honda crf 100?
it depends what has been done to it but a normal cr125r would go 60 to70 mph they cant go too fast because a cr450 goes 80mph to 100mph
This sounds like an issue that VW has recognized and is fixing for free. I would recommend calling your local dealer and consulting them on whether this is a problem that they have sent out a recall about.
If your 1998 VW Beetle has a radio preset button that will not push anymore, you can sometimes fix it by prying the button out of the radio with a butter knife. Then, clean behind the button and clean the button itself. Pop the button back into the radio.
How do you remove the radio on 2003 vw beetle?
I had the same problem when I installed a new after market SONY CD/radio. If yours is the New Beetle check the 25 AMP fuse in the fuse box on the drivers side where the door connects to the dash. It is fuse # 42 (or the only 25Amp fuse on the 3rd row up from the bottom. You can get a pack of 5 of this fuses at the auto parts store (ex Advanced Auto) If the 25 Amp is okay, check the 10 Amp #37 on the bottom row.
How do you replace the front and rear brakes on a 2001 VW Beetle?
You will need a metric Allen wrench (7 mm).Jack up passenger side and place jack stand. Remove wheel. Take a screwdriver and work it in between brake pad and rotor. Once done, apply steady pressure on brake pad until you push the caliper piston as far in (toward engine) as it will go. You will need to remove caliper bolts. They are on the back of the caliper at top and bottom. Place Allen wrench in each bolt and turn wrench towards front of vehicle to remove. Once removed, remove caliper with brake pads inside. Match new brake pads with old and put new pads in like you removed the old pads. Place new pads and caliper back on vehicle and replace caliper bolts. If caliper and new pads do not slide easily back in place,you may need to get a large c-clamp and push piston back in caliper a little more. After you get caliper back on and tightened, get in car and pump your brake pedal until it is hard to push. This resets the brake pads. Replace wheel and your done!!
What is the top speed of a 2008 Corvette?
Has been measured up to 190mph with the Z06 measured up to 198mph.
What did the Romans discover as they experimented with different shapes of clear glass lens?
The Greeks and Romans filled glass spheres with water use them as lenses. However, glass lenses were actually invented in the Middle Ages. It was the Greeks who made the observations, rather than the Romans.
The Greek mathematician Euclid (late 4th century B.C.-mid-3rd century B.C) noted that with greater angles objects are magnified, lesser angles there was less magnification and with equal angles there was none. He also surmised that the size of an object is related to the distance from the eye and studied the perceived shapes of cylinders and cones seen from different angles.
Hero of Alexandria (c. 10 - c. 70 AD), another Greek, showed that the path taken by a ray of light reflected from a plane mirror is shorter than reflected paths between the source and point of observation by using a geometrical method
Titus Lucretius (c. 99 BC - c. 55 BC), a Roman philosopher, thought that light and heat of the sun are composed of minute which pushed and quickly shoot through the air in the direction of the push.
Ptolemy (c. AD 90 - c. 168) studied reflection and refraction. He measured the angles of refraction between air, water, and glass, and adjusted his measurements to fit his incorrect assumption that the angle of refraction is proportional to the angle of incidence.
How do i change spark plugs in 2002 Hyundai Elantra?
basically, if you lift the hood and look directly at the engine (the big silver thing), on the top left side of it as you are looking at it from the front is where you place the oil in (oil cap). Just above that are the four spark plugs. They are underneath the plug and coils. you would have to unscrew the two bolts holding the coils down to get to two of the spark plugs, and the other two spark plugs, you just pull the wires off. (Just pull)
How do you remove door glass vw beetle?
remove door handles x2 ,crank and lever (2 screws each)
remove cards
remove the bolts 10mm seen on door connected to regulator.
remove regulate
remove glass from reg.
rev, for back (use caulk to hold glass in reg bottom)
How do you replace the headlight bulb on 2001 Malibu?
i need to replace the low-beam head light and can figure out how
first of all, raise hood. on top of headlight assembly are 2 plastic slide pins.pull up on these pins to release headlight assembly. pull assembly out as far as possible, then change headlight. when putting back on push in on assembly to put slide pins back down to hold assembly in.