0
1982-1994 Chevy Cavaliers
1,826 Questions
Where is the crankshaft positioning sensor located on a 2003 Chevy suburban 5.3L?
Same as the Tahoe behind the starter
How do you install a new timing chain on a 1994 Chevrolet Cavalier 2.2L?
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
What would cause a Chevy S-10 truck horn to go off on its own - in the middle of the night?
it could be a ghost
I Use A small dab of pematex or similar sealant just enough to hold, make sure surface is clean.
How can you tell if its the solenoid or module when your car stalled and cant get it started again?
if a starter sol. is faulty the car will fail to turn over, all the time or intermitantly. The ignition module will usually cause the vehicle to not start (no spark).
How do you set the clock in a 1995 Cadillac eldorado?
hope this may help, on my 88 eldorado. it is reset or changed by pin hole. Look for a small needle hole in the area of display. mine is on lower right corner of center console, right below time and date display message.
Where is the camshaft sensor in a 91 Chevy Cavalier?
On the firewall side of the engine block, near the transmission bellhousing, under the intake manifold that answer sir, is incorrect, the cavaliers did not use a cam sensor, only a crank sensor, but the location is right for the crank sensor
Where is the fuel pump relay located on a 1981 Mercedes 380 sel?
it's in the fuse box, a black relay on the right corner, it should say the revolutions number on it.
Where can you get a diagram for the fuse box to a 1994 Chevrolet Cavalier?
Try "google"ing for your vehicle's "Electrical Diagnosis Service Manual Supplement"... Chevy printed one for my 1990 Geo Metro - has all wiring diagrams and specs plus troubleshooting guides for all electrical components - a MUST HAVE! Good luck.
What would cause a 1994 Ford Escort speedometer needle to jump all over the place?
The speed sensor is malfunctioning If the speedometer is still run by a cable from the transmission, the cable could be getting bound up inside the case that covers it. With heat and time the lubricant inside the plastic tube and that covers the metal cable gets dry and hard and sticky. As the cable begins to twist it will spin and then catch and then release causing the needle to bounce. This is only if you have what I consider to be a mechanicaly fed speedometer. If it is electronically fed with a speed sensor and all, answer ! may be correct. I owned a 95 and thought for sure I had mechanically activated speedometer. And on a side note if it is not the cable itself, then it may be the speedometer gear in the tranny going bad. As the tranmission speedometer gear rotates it spins the cable inside the plastic tube. Possibly a tooth or two broke off. If you find your speedo is run by a cable, there are ways to lubricate them if you can get it disassembled from the rear of the speedo or from the tranny. You may want to look at purchasing a new cable and just replacing it that is if you have a cable fed speedometer.
Is there an easy fix in replacing a head gasket for a 99 Daewoo Leganza?
I had an external antifreeze leak, and I tried a product called steelseal and it worked as advertised, just took off radiator hose and added the product as per instructions still no leak, i think it messed with my thermostat though.
U have a blown head gasket,cracked cylinder head or cracked block.. The white smoke is from water getting into the Exhaust system.
How do you remove the Ignition switch assembly on a 1993 Acura Legend?
you have to replace the whole steering column
Where is the fuel relay located on a 1987 Buick LeSabre?
It is with all of the relays in the center of the firewall under the hood.
How do you replace the ignition switch in a 92 Chevy Cavalier?
We just finished doing this job so I hope this helped. First and foremost, disconnect your battery. You do not need to completely remove the steering wheel. First you do need to remove the panel that contains your horn (you will have to disconnect it as well). Then remove the 6 screws from the steering wheel. Remember the position your steering wheel was in so you do not mess up your alignment in the process. After that, you will remove the top and bottom panels behind the steering wheel. There should be 3 screws holding the bottom panel in. Remove those. You will also need to remove the handle on the left hand side of the steering wheel that adjusts the height of the steering wheel. It screws off. There will be two screws, one on either side of the steering wheel that connect the top and bottom panels together. Remove those. The panels should come apart fairly easily after this. Remove both of the panels. The ignition switch will be on the bottom left side of where the steering wheel was. It is held in by two screws and have two sets of wires coming out of it. Remove the screws first as this will allow you to remove the wires easier. Remove the two sets of wires. After this, take your new ignition switch and reverse the process: put the wires back in, put the screws back in and secure it in place (Before you put everything back together, temporarily reconnect your battery to make sure everything works. Disconnect your battery after the test and start reassembling.), replace both of the panels and screw in the two screws that hold the two panels together, put the three screws under the bottom panel back in place, put the steering wheel back on in the same position that you took it off and screw it back in place, reconnect your horn and put the panel for the horn back in place, and screw the handle to adjust your steering wheel height back into place. Reconnect your battery. After that, you should be good to go.
How do you access and change the windshield washer motor pump in a 1992 Chevrolet Cavalier?
It is located in the washer fluid reservoir.
Whether you're an expert Chevrolet electronics installer or a novice Chevrolet enthusiast with a 1994 Chevrolet Cavalier, a car stereo wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car stereo, car radio, car speakers, car amplifier, car navigation or any car electronics is identifying the correct color wires for a 1994 Chevrolet Cavalier. 1994 Chevrolet Cavalier Car Stereo Radio Wiring Diagram: You will find these wires grouped together in the plugs as they are listed below. Car Radio Constant 12v+ Wire: Orange (Keeps power to station memory & clock)
Car Radio Switched 12v+ Wire: Yellow (Sends power to radio when key is on) Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger: Pink_________________________________________
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A_______________________________________
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green___________________________
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue Hope this helps you,
John D
How to remove rear stock speakers from a 1992 Dodge Dynasty?
There are two bolts on the front edge of the bottom of the seat. One per side, take those out then slide out the bottom seat cushion. Remove the two bolts holding on the back of the seat. It should lift out. Then one or two screws should hold on the back deck.
What would cause your pointer finger to twitch for a couple of days and it will not stop?
Alzheimer's is one possibility, but not the only one.
This happened to Michael J. Fox while shooting the film "Doc Hollywood". He would go back to his motel room and his finger started shaking.
While this is probably not the real reason ... one should seek a Medical opinion and have it checked out. Any nervous tics could be the symptoms of something to come. See your Doctor.
AnswerMichael J Fox has Parkinson's disease AnswerCould be nerve damage. Have you ever had a back or neck injury? I suffered a cervical spine fracture of the C-6 vertebrae (shoulder line) roughly 20 years ago (15 at the time) and I still have little twitches in my fingers on some days. Late at night my feet will also involuntarily twitch as well. WE ALL GET TWITCHES!All people will get the odd twitch or "tick" in their eyelid, brow, lip, fingers and even toes. Some doctors believe it is low calcium, but it's possible you could have slept wrong, stressed some muscles or even done something as simple as carried something heavy in that hand. EXAMPLE: I had a very sore right shoulder for weeks and also I had one finger that twitched (more aggravating than anything else) and I couldn't figure out what it was. It suddenly dawned on me I carried a purse with strap over my right shoulder that had notes and books in it that I use for meetings. The weight was the issue. I've even had this happen to a finger due to carrying those plastic groceries bags by the handle (if the bag is full of heavy articles the plastic digs into the fingers and caused lack of blood circulation for a few minutes.)Are you a typist? My pointer finger on my left hand started twitching, sometimes it went into my thumb. I was told it could be Carpal tunnel syndrome which I always thought was just in the wrist but apparently not! I work as a medical office assistant typing all day.
What is the location of and how do you replace the O-ring on the injectors in a 1991 Jeep?
the First and most important step is there is a shcrader valve on the fuel rail (looks like a valve stem for a tire, put a rag around this and push on the core like you are letting the air out of a tire. This relieves the fuel pressure from the system so it doesnt spray all over you. After removing the fuel rail from the top of the injectors and the electrical plugs from the sides you can carefully extract each injector from it's hole.. the key is lubricate the O-rings before reinstalling them and second I heartily recommend replacing all the O-rings at once..they are cheap enough and if one is leaking the others will be sooner or later (sooner if you bump them while changing the one next to it. Under the injectors where they screw into the heads...
What are size of the stock audio speakers in a 1998 Kia Sportage 4WD?
They are 4" for the front door speaker, and 6.5" for the rear panel speakers. Careful not to buy too deep a replacement speaker, as the space is limited.
Test for fuel pump pressure at the back for the throttle body at the schrader valve. Your fuel pump may be going out. This is the #1 problem with these cars.
