answersLogoWhite

0

Ford Windstar LX

Introduced in 1995, the Windstar LX was a first generation Windstar model powered by a 155 hp 3.8 L V6 engine, which can generate up to 220 lb ft of torque.

1,653 Questions

What is the spark plug gap for a 1992 vw golf 1.8l 8v?

0.8mmUse NGK plugs. They come pre-gapped. PS Never try adjust the gap on a plug (throw them away every 10000-15000km) it's not worth it. The cathode ends up bent and wears the anode unevenly and will cause you more grief than pleasure. Also, the washer on a plug is meant for once-only se. It compressess when you tighten it in the first time. If you take it out, chuck it away.

Where is the cooling system diagram for a 1992 Ford Bronco?

You can find a 1992 Ford Bronco cooling system diagram at most Ford dealerships. The diagram will be in Ford service manuals at your local library.

What is the spark plug gap for a 1990 Yamaha FZR-1000?

The spark plug gap for a 1990 Yamaha FZR-1000 is typically set at 0.8 to 0.9 mm (0.031 to 0.035 inches). It's important to check the specifications in the owner's manual or service manual for the most accurate setting. Proper gap adjustment ensures optimal engine performance and efficiency. Always use the recommended spark plugs for best results.

Where exactly is the location of the camshaft position sensor on your 2002 Isuzu rodeo 2.2L?

look at the top of the engine, the cover for the spark plugs ends at the front of the engine. Right at that point is where the connector is, to get at the sensor you must remove the serpentine belt, wiring cover, and timing belt cover, and the sensor bolt can be accessed between the camshaft pulleys, its a small torx bolt.

What is the spark plug gap on a 2000 Pontiac Firebird 3.8 v-6?

That's my car! It's .060. I got the NGK Iridium plugs though and it's recommended at .054

What kind of plugs do you have, or are planning on getting?

What is the proper spark plug gap for a 1981 Yamaha XS400?

type spark plug: DR8ES-L

Electrode gap: 0.6-0.7mm (0.024-0.028in)

Tightening torque: 20Nm (2.0m-kg, 14.5ft-lb)

Where is the engine block drain for antifreeze on a 1988 Mercury Sable?

There is no drain on the block, just the drain on the radiator (bottom of rad drivers side, facing the transmission).

ANS 2 The above is perfectly correct, but if you still wish to drain coolant fluid from that block, the easiest way is removing the lower rad hose from engine side.

Im puting an LS1 supercharger on your 98 3800 V6 camaro and you wanted to know what you have to change in the engine so that your car can handle the power?

2001-2002 LS-1 Vortech 5.7 v-9 sq g is the engine that the Supercharger System was made for. yes it is too much for a 3800 v-6 to handle. The f body 5.7l will improve to 470 horsepower and 462 ft/lbs of torque with ram air models and 448 horsepower and 449 ft/lbs of torque can be attained on non-ram air engines

How do you get drivers side power window motor out of 1989 ford f 150?

start by removeing inside door pannel withe your window in the up possision you will be able to un bolt your backet that hold the motor theres not a lot of room so you will have to be patiant but it dose come out

How do you change the air filter on a 1999-2003 Ford Windstar?

The air filter is in the large diameter (about 8" across) tube on the right side of the engine - windshield side of the battery.

There's a lever that releases the retainer clip to access the filter inside. ON the top right of the engine there is a oblong black plastic tube (about 6 inches in diameter) with a metal clasp on the top. open it and separate the 2 sides and remove the old air filter and put in the new one. re-connect the tube and close the clasp. I found it helpful to loosen the clamps that hold the rubber gasket just prior to the filter housing. Don't forget to reconnect the hose on the back side of the filter.

On the top of the engine there should be a BIG black tubular looking hose going from the engine to the driver's side of the engine compartment The air filter is inside this. There is a latch thing. lift up on this latch and it will snap open. pull then end that is toward the engine away from the piece that is attached to the side. the air filter sits inside the piece that is on the side of the compartment. pull it out. It does take a little wiggling it around to get it out. MAKE SURE that when you install the filter the "hole" side of the filter should be facing the engine. Hope this helps. If you mean the engine air filter then you just undo the two screws that hold on the air cover box top and lift it up. Pull the filter out and then replace it. Make sure the accordion look side goes upwards away from the engine. If you mean the cabin air filter then it behind a plastic cover that is on the passenger side engine compartment up under the wiper area of the cowl. Remove the two screws and remove the cover and pull out the filter and then put in a new one. SIMPLE. Good luck. I will base this answer on changing the air filter for a large majority of vehicles. It is a very simple process involving locating the air filter in the engine compartment, unlatching it - or in some cases, removing a few screws, removing the old filter and replacing it with the new one.

What is the spark plug gap on a 1989 Honda civic 1.5 ltr?

The spark plug gap for a 1989 Honda Civic with a 1.5 liter engine should be set at .044 inches. Most Honda engines have a spark plug gap of .044 inches.

How do you replace the transmission mount on a 96 Oldsmobile achieva 4-cylinder do you have to remove the whole engine?

no you do not have to remove driver side wheel and there is 3 bolt that hold it to the transmission and one bolt threw the center. the 3 bolt should be 15mm head and the one that in center the nut is 15mm and the bolt 17mm

What is the fuse diagram on a 2000 Ford Windstar van?

The simplest answer is: there are fusebox diagrams in your Owners Manual.

You can even download a free copy of any 1996 or newer Ford product Owners Manual.

See "Related Questions" below for the links

If you don't want to use the Owners Manual, Autozone.com offers a free Repair Guide - and that also has illustrated fuse panel information.

How do I find Noise when turning the steering on ford windstar?

Depends of what kind of "Noise" you're hearing. Maybe try jacking your van up and shaking your tires back and forth to see if your ball joints, or any connecting rods are loose.

Your 91 5 speed mercury capri shift lever moves very stiff what is wrong and how do you fix it?

You have several possible reasons. And you are Lucky Here is a [http://www.techcapri.com/index.html RESOURCE] where you can get service pdf's without purchasing a Manual. Insufficient oil in transaxle. (Fix: Add oil.)
Incorrect oil quality. (Fix: Drain and fill with specified oil.)
Selector rod bent. (Fix: Replace.)
Transaxle shifting mechanism insufficiently lubricated. (Fix: Lubricate.)
Excessive clutch pedal free play. (Fix: Adjust.)
Shift fork and shift rod worn. (Fix: Replace.)
Synchronizer ring worn. (Fix: Replace.)
Worn cone surface of gear. (Fix: Replace.)
lmproper contact between synchronizer ring and cone surface. (Fix: Replace.)
Excessive play in the axial direction cf each gear. (Fix: Replace worn component.)
Bearings worn. (Fix: Adjust or replace.)
Synchronizer key is weakened. (Fix: Replace.)
Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.

How much do you gap spark plugs for a 1994 ford crownvictoria?

New plugs are pre-gapped, but if you are reusing old plugs then Gap=0.054 Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.